Philips BDL4640E Bedienungsanleitung
SERVICE MANUAL
BDL4640E
Philips BDL4640E 1
TABLE OF CONTENTS
CHAPTER A REVISION LIST……………………………………………………………………….2
CHAPTER B WARNNING…………………………………………………………………………...3
CHAPTER C SEFETY RRECAUTIONS………….……………………......................................4
CHAPTER 1 GENERAL SPECIFICATION………………….....................................................5
CHAPTER 2 OPEARTING INSTRUCTION……………………………....................................13
CHAPTER 3 THEORY OF OPERATION…………………………….......................................19
CHAPTER 4 BLOCK DIAGRAM…………………………………….…....................................23
CHAPTER 5 SCHEMATIC DIAGRAM…………………..........................................................25
CHAPTER 6 LAYOUT SIDE VIEW……………………...........................................................46
CHAPTER 7 EXPLODED VIEW…………………………………………...................................50
CHAPTER 8 TROUBLE SHOOTING…………………….………….........................................54
Philips BDL4640E 2
CHAPTER A
REVISION LIST
Model Name Version Issues Date Remark
BDL4640E 3A 2011-12-06 First Release
Philips BDL4640E 3
CHAPTER B
WARNNING
This service information is designed for experienced repair technicians only and is not
designed for use by the general public.
It does not contain warnings or cautions to advise non-technical individuals of
potential dangers in attempting to service a product.
Products powered by electricity should be serviced or repaired only by experienced
professional technicians.
Any attempt to service or repair the product or products dealt within this service
information by anyone else could result in serious injury or death.
Philips BDL4640E 4
CHAPTER C
SAFETY PRECAUTIONS
1. Caution
No modification of any circuit should be attempted. Service work should only be performed after you
are through familiar with all of the following safety checks and servicing guide lines.
2. Safety check
Care should be taken while servicing this LCD display. Because of the high voltage used in the
inverter circuit. These voltage are exposed in such areas as the associated transformer circuits.
3. Power supply requirements
The internal power converter with the attached AC power cord is necessary for the LCD monitor. Any
attempt to replace another power converter could result in serious of problems on the display.
4. Leakage current hot check
4-1 Plug the AC cord directly into the AC outlet. Do not use an isolation transformer during this check.
4-2 Connect a 1500 ohm, 10 watt resistor, paralleled by a 0.15uF capacitor between each metallic
part and a good earth ground.
4-3 Use an AC voltmeter with 1000 ohm / volt or more sensitivity and measure the AC voltage across
the combination 1500 ohm resistor and 0.15uF capacitor.
4-4 Move the resistor connection to each exposed metallic part and measure the voltage.
4-5 Reverse the polarity of the AC plug in the AC outlet and repeat the above measurement.
4-6 Voltage measured must not exceed 1.5 volt RMS, from any exposed metallic part to the ground.
A leakage current tester may be used in the above hot check, in which case any circuit measured
must not exceed 1 milliamp. In the case of a measurement exceeding the 1 milliamp value, a rework is
required to eliminate the chance of a shock hazard.
To Metal Parts
V
AC VOLTMETER
1500 10W
0.15u
.
Earth Ground
Philips BDL4640E 5
CHAPTER 1
GENERAL SPECIFICATION
Index of this chapter:
1. Specification
2. Outline
3. I/O connectors
4. Factory preset timing
1. Specification
Item Specification
LCD Module
Size: 46” diagonal
Pixel Pitch: 0.53025(H) mm x 0.53025(V) mm
Resolution: 1920(H) x 1080(V)
Color: 8 bit, 16.7 M colors
Brightness: 450 cd/m2 (typical)
Contrast Ratio: 4000:1 (typical)
Viewing Angle (CR>10): Horizontal 178° / Vertical 178°
Response Time: 8 ms (GTG)
Frequency Horizontal :31 ~ 91 KHz
Vertical :50 ~ 75 Hz
Pixel Clock 13.5 ~ 165.0 MHz
Speaker External speaker jack: 7W+7W
Internal speaker: without
Power Supply 100 / 240 VAC, 50 / 60 Hz
Power Consumption Display mode: max 285 W
Sleeping mode: Less than 1 W
Operational Environment Temperature: 0 ~ 40 °C, Humidity: 20 ~ 80%
Storage Environment Temperature: -20 ~ 60 °C, Humidity: 10 ~ 90%
Tilt / Swivel / Rotation No
Wall Mount Method VESA in back-cover
Dimension (w/o stand) Net: 1122(W) x 663(H) x 136.3(D) mm
Cross: 1285(W) x 885(H) x 275(D) mm
Weight (w/o stand) Net: 31.1 kg
Gross: 36.7 kg
Philips BDL4640E 6
2. Outline
¾Front view
¾Rear view
Philips BDL4640E 7
¾Side view
¾Top view
Philips BDL4640E 8
3. I/O connectors
3.1 Overview
AUDIO IN 1, 2, 3
To input the audio input signal from external equipment such as a computer, VCR or DVD player.
AUDIO OUT
To output the audio signal from the AUDIO IN 1,2 and 3 jack.
EXTERNAL CONTROL (mini D-Sub 9 pin)
This for the serial connection when multiple BDL4635E monitors are connected. To achieve remote
control through RS232 commands (refer to the RS232 remote control user manual), connect the IN
connector with the RS-232C OUT connector of a computer or a multi-connected BDL4635E monitor
and connect the OUT connector with the RS-232C IN connector of a next BDL4635E monitor.
VIDEO IN/OUT
VIDEO IN connector (BNC and RCA): To input a composite video signal. Note that BNC and RCA
are not available at the same time.
VIDEO OUT connector (BNC): To output the composite video signal from VIDEO IN connector.
S-VIDEO IN connector (MINI DIN 4 pin): To input the S-video (Y/C separate signal).
EXTERNAL SPEAKER TERMINAL
To output the audio signal to external speakers from AUDIO IN 1, 2, 3 jack or HDMI.
AC IN connector
To connect with the supplied power cord.
HDMI 1 IN
To input digital RGB signals from a digital device or computer.
* This connector does not support analog input. AUDIO is supported via the HDMI connector.
Philips BDL4640E 9
HDMI 2 IN
To input digital RGB signals from a digital device or computer.
* This connector does not support analog input. AUDIO is supported via the HDMI connector.
PC-A IN (mini D-Sub 15 pin)
To input analog RGB signals from a computer (VGA) or set-top box.
RGB OUT (mini D-Sub 15 pin)
To output the signal from PC-A IN.
CVI IN [ Y, Pb, Pr ] (BNC)
To Connect an device such as a DVD player, HDTV device, or Laser disc player.
Inhaltsverzeichnis
Andere Philips Monitor Handbücher
Philips
Philips LTC 2821/90 Bedienungsanleitung
Philips
Philips 278B1/27 Bedienungsanleitung
Philips
Philips 22BDL7219L Bedienungsanleitung
Philips
Philips B Line 162B9T/70 Bedienungsanleitung
Philips
Philips Rotary Mower Bedienungsanleitung
Philips
Philips 107C63 Bedienungsanleitung
Philips
Philips 272E1GSJ Bedienungsanleitung
Philips
Philips 273E3QHSB/00 Bedienungsanleitung
Philips
Philips 275C5 Bedienungsanleitung
Philips
Philips BDL5231VS Bedienungsanleitung
Philips
Philips 170B6CG Bedienungsanleitung
Philips
Philips BDL6551V Bedienungsanleitung
Philips
Philips 190WV7 Bedienungsanleitung
Philips
Philips 220TW9FB Bedienungsanleitung
Philips
Philips 55BDL8005X Bedienungsanleitung
Philips
Philips 271S4 Bedienungsanleitung
Philips
Philips 170S7 Montage- und Bedienungsanleitung
Philips
Philips 162B9T Bedienungsanleitung
Philips
Philips 150B6 Montage- und Bedienungsanleitung
Philips
Philips 4CM6282 Bedienungsanleitung
