Philips BT3000 Bedienungsanleitung
www.philips.com/support
User manual
Always there to help you
Register your product and get support at
Question?
Contact
Philips
BT3000
1EN
Contents
1 Important 2
2 Your Bluetooth speaker 3
Introduction 3
What's in the box 3
Overview of the speaker 4
3 Get started 6
Power supply 6
Turn on 6
4 Use Bluetooth devices 8
Play from Bluetooth devices 8
Control your phone call 8
5 Other features 9
Listen to an external device 9
Adjust volume 9
6 Product information 10
Specications 10
7 Troubleshooting 11
General 11
About Bluetooth device 11
8 Notice 12
Compliance 12
Care of the environment 12
Trademark notice 12
2EN
1 Important
Warning
•Never remove the casing of this speaker.
•Never lubricate any part of this speaker.
•Never place this speaker on other electrical equipment.
•Keep this speaker away from direct sunlight, naked
amesorheat.
• Make sure that there is enough free space
around the speaker for ventilation.
• Battery usage CAUTION –To prevent
battery leakage which may result in bodily
injury, property damage, or damage to the
speaker:
• Install the batteries correctly, + and - as
marked on the speaker.
• Do not mix batteries (old and new or
carbon and alkaline, etc.).
• Remove the batteries when the
speaker is not used for a long time.
• The batteries shall not be exposed to
excessiveheatsuchassunshine,reor
the like.
• Use only power supplies listed in the user
manual.
• The speaker shall not be exposed to
dripping or splashing.
• Do not place any sources of danger on
thespeaker(e.g.liquidlledobjects,lighted
candles).
• Where the plug of the Direct Plug-in
Adapter is used as the disconnect device,
the disconnect device shall remain readily
operable.
Note
•The type plate is located on the bottom of the product.
3EN
2 Your Bluetooth
speaker
Congratulations on your purchase, and
welcometoPhilips!Tofullybenetfromthe
support that Philips offers, register your product
at www.philips.com/welcome.
Introduction
With this speaker, you can enjoy audio from
your Bluetooth-enabled devices, or other
external audio devices.
What's in the box
Check and identify the contents of your
package:
• Speaker
• Power adapter
• Audio-in cable
• 4 x AA batteries
• Short user manual
• Safetyandnoticeleaet
Short User Manual
www.philips.com/welcome
Always there to help you
Register your product and get support at
Question?
Contact
Philips
4EN
Overview of the speaker
a
• Turn the speaker on or off.
b +/-
• Adjust volume.
abc
d
ef
c /PAIRING
• Enter Bluetooth pairing mode.
• Disconnect Bluetooth connection.
• Answer or reject an incoming call.
• End the current phone call.
5EN
d Battery compartment
e AUDIO IN
• Connect an external audio device.
f DC IN
• Connect power.
6EN
3 Get started
Always follow the instructions in this chapter in
sequence.
Power supply
The Bluetooth speaker can be powered by
either AC mains or batteries.
Option 1: Battery power
Caution
•Risk of explosion! Keep batteries away from heat,
sunshine,orre.Neverdiscardbatteriesinre.
•Batteries contain chemical substances, so they should
be disposed of properly.
Note
•WhenLEDindicatorashesred,replacethebatteries.
1 Open the battery compartment.
2 Insert 4 AA batteries with correct polarity
(+/-) as indicated.
3 Close the battery compartment.
4 x AA
Option 2:AC power
Caution
•Risk of product damage! Make sure that the power
voltage corresponds to the voltage printed on the back
or underside of the speaker.
Connect the power adaptor to:
• the DC IN socket on the speaker.
• the wall outlet.
Turn on
Press and hold for 2 seconds.
» The speaker switches to Bluetooth
mode automatically.
» TheLEDindicatorashesblue.
Note
•Ifbatteryislow,theLEDindicatorashesred.
2”
7EN
Turn off
The speaker is turned off in the following
situations:
• Press and hold for 2 seconds again;
or
• The Bluetooth connection is
disconnected and there is no audio-in
cable inserted for 15 minutes.
» The LED indicator is turned off.
8EN
4 Use Bluetooth
devices
With this speaker, you can listen to audio from
Bluetooth-enabled devices and control the
incoming call through Bluetooth.
Play from Bluetooth devices
Note
•Make sure that your Bluetooth device is compatible
with this speaker.
•Before pairing a device with this speaker, read its user
manual for Bluetooth compatibility.
•The speaker can memorize a maximum of 4 paired
devices.
•Make sure that Bluetooth function is enabled on your
device, and your device is set as visible to all other
Bluetooth devices.
•Any obstacle between this speaker and a Bluetooth
device can reduce the operational range.
•Keep away from any other electronic device that may
cause interference.
•The operational range between this speaker and a
Bluetooth device is approximately 10 meters (30 feet).
•If there is an incoming call on the connected mobile
phone, music playback pauses.
1 Press and hold for 2 seconds.
» TheLEDindicatorashesblue.
2 On your Bluetooth device, enable
Bluetooth and search for Bluetooth devices
that can be paired (refer to the user
manual of the device).
3 When [PHILIPS BT3000] is displayed on
your device, select it to start pairing and
connection. If necessary, input “0000” as
the pairing password.
» After successful pairing and connection,
the speaker beeps twice, and the LED
indicator turns solid blue.
4 Play audio on the Bluetooth device.
» Audio streams from your Bluetooth
device to the speaker.
To disconnect the Bluetooth-enabled device:
• Press and hold PAIRING for two seconds;
• Disable Bluetooth on your device; or
• Move the device beyond the
communication range.
To reconnect the Bluetooth device:
• Next time you turn on the speaker, the
speaker will reconnect the last connected
device automatically; or
• On your Bluetooth device, select "PHILIPS
BT3000" on your Bluetooth menu.
To connect another Bluetooth-enabled device:
1 Press and hold PAIRING for two seconds
to disconnect the currently connected
device;
» The speaker enters Bluetooth pairing
mode.
2 Connect another Bluetooth device.
LED indicator Description
Flashing blue Connecting;
Waiting for pairing
Solid blue Connected
Control your phone call
After Bluetooth connection, you can control an
incoming call with this speaker.
Button Function
Press to answer an incoming call.
Press and hold for 2 seconds to reject
an incoming call.
During a call, press to end the current
call.
Andere Handbücher für BT3000
1
Inhaltsverzeichnis
Andere Philips Sprecher Handbücher
Philips
Philips TAS3505 Bedienungsanleitung
Philips
Philips STS9500/00 Bedienungsanleitung
Philips
Philips SPA2200 - PC Multimedia Speakers Bedienungsanleitung
Philips
Philips HTL5130B Bedienungsanleitung
Philips
Philips HTL2100 Bedienungsanleitung
Philips
Philips CSP251 Bedienungsanleitung
Philips
Philips CSS5123/93 Bedienungsanleitung
Philips
Philips FB 830 Bedienungsanleitung
Philips
Philips SoundRing SB3700/10 Bedienungsanleitung
Philips
Philips SPA2100 Bedienungsanleitung
Philips
Philips HTL4115B/F7 Bedienungsanleitung
Philips
Philips Fidelio E6 Bedienungsanleitung
Philips
Philips HTB7150 Bedienungsanleitung
Philips
Philips TAX5206/37 Bedienungsanleitung
Philips
Philips PS402 Bedienungsanleitung
Philips
Philips A2.310/25 Bedienungsanleitung
Philips
Philips 3000 series Bedienungsanleitung
Philips
Philips SPA1260/12 Bedienungsanleitung
Philips
Philips SW700M/37 Bedienungsanleitung
Philips
Philips HTL3110B/F7 Bedienungsanleitung
Beliebte Sprecher Handbücher anderer Marken
Bowers & Wilkins
Bowers & Wilkins 4 Bedienungsanleitung
Sonance
Sonance SONOS OUTDOOR Series Bedienungsanleitung
Electro-Voice
Electro-Voice EVID FM4.2 Bedienungsanleitung
Pioneer
Pioneer XW-HTD630 Bedienungsanleitung
Onn
Onn BWA16AA002 Bedienungsanleitung
HP
HP GL313AA - USB Speakers PC Multimedia Bedienungsanleitung