Philips HP 4494 Bedienungsanleitung
HP 4490/94/96
2
English Page 6
• Keep pages 4, 5, 50 and 51 open when reading these operating instructions.
Français Page 10
• Pour le mode d'emploi: dépliez les pages 4, 5, 50 et 51.
Deutsch Seite 13
• Schlagen Sie beim Lesen der Gebrauchsanweisung
Seiten 4, 5, 50 und 51 auf.
Nederlands Pagina 16
• Sla bij het lezen van de gebruiksaanwijzing de pagina's 4, 5, 50 en 51 op.
Italiano Pagina 19
• Prima di usare l'apparecchio, aprite le pagine 4, 5, 50 e 51
e leggeteattentamente le istruzioni per l'uso.
Español Página 22
• Desplegar las páginas 4, 5, 50 y 51 al leer las instrucciones de manejo.
Português Página 25
• Durante a leitura do modo de emprêgo, desdobre e
verifique as pág. 4, 5, 50 e 51.
Dansk Side 28
• Hold side 4, 5, 50 og 51 opslået mens De læser brugsanvisningen.
Norsk Side 31
• Slå opp på side 4, 5, 50 og 51 før De leser videre.
Svenska Sid 34
• Ha sidan 4, 5, 50 och 51 utvikt när ni läser bruksanvisningen.
Suomi Sivu 37
• Pidä sivut 4, 5, 50 ja 51 auki samalla kun luet käyttöohjetta.
Türkçe Sayfa 40
•Kullanım kılavuzunu okuduπunuzda 3., 4., 50. ve 51. sayfaları açınız.
3
Fitting a plug
Connections - Applicable to U.K. only
Important
The wires in this mains lead are coloured in accordance with the
following code: BLUE - NEUTRAL
BROWN - LIVE
As the colours of the wires in the mains lead of this appliance may not
correspond with the markings identifying the terminals in your plug,
proceed as follows:
The wire which is coloured BLUE must be connected to the terminal
which is marked with a letter "N" or coloured BLACK.
The wire which is coloured BROWN must be connected to the
terminal which is marked with the letter "L" or coloured RED.
DO NOT CONNECT either of these wires to the earth terminal in the
plug which is marked with the letter “E” or by the earth symbol E or
coloured GREEN, or GREEN AND YELLOW.
Note: If the terminals of the plug are unmarked or if you are in
any doubt consult a qualified electrician.
If a 13 Amp. 3-pin plug is fitted, it must be an "approved" plug,
conforming to BS 1363-1986.
4
M
H
N
K
1
4
5
G
F
B
A
E
O
I
L
D
C
J
5
General description (fig. 1)
AHandle
B"On"-light
CClamping ring
DConnect point
EContact pins
FHeel rest (turn backwards before use)
GClip
HStyling attachment "Spirals" (for corkscrew curls) (HP 4494/96)
IStyling attachment "Zig Zags" (for Z-shaped curls) (HP 4494/96)
JStyling attachment "Crimper/Straightener" (HP 4496)
KInset plates for "Crimper/Straightener" (HP 4496):
"Crimping plate" (ribbed side: for waves)
"Straightener" (flat side: for straight hair)
LStyling attachment "Curls" (for evenly rounded curls) (HP 4494/96)
MStyling attachment "Brush" (for brushing/untangling and creating
large rolls) (HP 4494/96)
NCool tips
OReady dot
6
English
Important
• The styling attachments and the inset plates of the "Crimper/
Straightener " will become hot during use. Prevent contact
with the skin. Do not allow the mains cord to touch any hot
parts.
• Never immerse the appliance in water. You may clean it with a
damp cloth, but first remove the plug from the wall socket.
• Washing your hair or using the "Flat plate" of the Crimper/
Straightener attachment will remove the waves and curls.
Making the "Geometricks" MultiStyler ready for use
How to change the styling attachments (fig. 2-6)
• When changing styling attachments during use only touch the plastic
parts. The metal parts are hot!
- To release the styling attachment, turn the clamping ring (C) in the
direction of the arrow (fig. 2).
- Pull the styling attachment from the handle (fig. 3).
- When mounting the required styling attachment, ensure that the
heel rest (F) is at the underside (fig. 4).
- Insert the styling attachment firmly into the main unit (fig. 5).
- Secure by turning the clamping ring (fig. 6).
How to change the Crimper/Straightener inset plates (fig. 7-10)
• Ribbed side: for waves
• Flat side: for straight hair
- Open the Crimper/Straightener by pressing the handle downwards
(fig. 7).
- Take the plate by the cool tips (N) at the front side.
- Pull the plate out of the Crimper/Straightener (fig. 8).
- Turn the plate (fig. 9).
- Insert the plate into the Crimper/Straightener. Ensure that the
protrusions at the sides enter the runners correctly (fig. 10).
Heating up (fig. 11-12)
- Insert the mains plug into the wall socket. The "On"-light (B) will come on
and the styling attachment will heat up (fig. 11).
- When the "Ready"-dot (O) on the styling attachment becomes dark the
appliance is ready for use (fig. 12).
How to use
• Before styling, comb or brush the hair so that it is completely untangled
and smooth.
• Always ensure good contact between hair and styling attachment or
Crimper. For that reason, do not attempt to style thick tresses of hair and
do not double-wind the hair when using the styling attachments.
• You need only 5 - 10 seconds to make a curl or wave.
A setting lotion may be applied after washing the hair.
7
Styling attachments (fig. 13 - 18)
• Always style small tresses of hair (2 - 3 cm or 1 inch thick).
• For good results, wind a tress around the styling attachment in a spiral
form. The full length of the tress will then be in contact with the hot rod.
• Fix the end of the tress with the clip and wind the hair around the rod
towards the head.
After 5 - 10 seconds open the clip and remove the barrel from the hair.
- With "Spirals" wind the tress following the spiral profile on the styling
attachment.
- With "Curls" wind the hair in straight.
- With the "Brush" a clip is not required as the teeth grip the hair.
• Important: Always ensure that the hair ends are wrapped smoothly
around the barrel of the attachment: this will avoid bent ends.
• You can divide the curls with your fingers to add volume. Especially with
Spirals this will give you a stunning hairstyle.
"Crimper/Straightener" (fig. 19 - 21)
• Take tresses of hair of max. 5 - 6 cm or 2 inches thick.
• The clip enables you to open and close the Crimper/Straightener, so that
you can style a tress of hair section by section.
• Always start crimping or straightening close to the head. Then
successively treat the lower sections.
• You may press the two parts of the Crimper/Straightener together by
using your fingers. (Do not touch the plates!)
• Keep the hair in the Crimper/Straightener for 5-10 seconds. Then open
the Crimper/Straightener to treat the next section of the same tress.
Ensure that there is an overlap!
After use
- After use remove the mains plug from the wall socket.
- Place the appliance with the stand downwards on a safe place and allow
it to cool down.
Replacing the mains cord
If the mains cord of this appliance is damaged, it must only be replaced by
Philips or their service representative, as special tools and/or parts are
required.
8
For U.K. only:
This appliance is supplied with a non-rewirable 13 Amp. plug. The plug
must never be used without the fuse cover being in place.
If a replacement fuse cover is required, it must be of the same type or
colour as the coloured insert around the fuse cover.
Replacement fuse covers are available from Electrical Retailers or direct
from Philips, tel. 081 - 689 - 2166, ext. 8014.
Replacement 3 Amp. fuses must be BSI or ASTA BS 1362 approved.
Important safety information
If the non-rewirable plug is not suitable for the socket outlets in your home,
it can be removed and replaced by a plug of the correct type.
The non-rewirable plug must be cut from the mains cord, the fuse
removed, and the plug safely discarded to prevent further use.
The removed plug can be hazardous if inserted into a live mains socket.
Fitting a plug: please refer to page 3
9
Description générale (fig. 1)
AAppareil
BTémoin lumineux
CBague de fixation de l'accessoire
DPoint de fixation de l'accessoire
EFiches de contact
FSupport de sécurité
GPince à cheveux
HAccessoire amovible "Spirales" (pour anglaises) (HP 4494/96)
IAccessoire amovible "Zig-Zags" (pour des cheveux crantés)
(HP 4494/96)
J"Crimper" (pour gaufrer et défriser les cheveux) (HP 4496)
KPlaques réversibles du "Crimper": (HP 4496)
Plaque à gaufrer (côté ondulé pour de fines ondulations)
Plaque à lisser (côté lisse, pour défriser les cheveux)
LAccessoire amovible "boucles" (pour des boucles rondes)
(HP 4494/96)
MAccessoire "brosse" (pour brosser, démêler ou donner du gonflant à
la coiffure) (HP 4494/96)
NPince (isolée thermiquement)
OIndicateur de température
10
Français
Important
• Les différents accessoires de l'appareil et les plaques
réversibles du "Crimper" deviennent très chauds pendant
l'utilisation: évitez tout contact avec la peau. Assurez-vous
que le fil ne soit jamais en contact avec les parties chaudes de
l'appareil.
• Ne plongez jamais l'appareil dans l'eau. Vous pouvez le
nettoyer avec un chiffon humide après l'avoir débranché et
seulement lorsqu'il est complètement refroidi.
• Vous pouvez éliminer toutes ondulations ou bouclés des
cheveux à l'aide d'un schampooing ou en utilisant le côté lisse
du Crimper.
Dieses Handbuch passt für folgende Modelle
8
Inhaltsverzeichnis
Sprachen:
Andere Philips Styling-Eisen Handbücher
Philips
Philips HP4684 Bedienungsanleitung
Philips
Philips BHS384 Bedienungsanleitung
Philips
Philips HP8343 Bedienungsanleitung
Philips
Philips SalonStraight Control HP4686 Bedienungsanleitung
Philips
Philips HP8331 Bedienungsanleitung
Philips
Philips HP4646 Bedienungsanleitung
Philips
Philips SalonStraight Jade HP4665/00 Bedienungsanleitung
Philips
Philips HP4666/15 Bedienungsanleitung
Philips
Philips HP8302 Bedienungsanleitung
Philips
Philips SALONSTRAIGHT ION HP4648 Bedienungsanleitung
Philips
Philips Ledino 44992/11/16 Bedienungsanleitung
Philips
Philips HP8602 Bedienungsanleitung
Philips
Philips HP8360/00 Bedienungsanleitung
Philips
Philips HP8339/00 Bedienungsanleitung
Philips
Philips HP4667/08 Bedienungsanleitung
Philips
Philips HP8339 Bedienungsanleitung
Philips
Philips HPS930 Bedienungsanleitung
Philips
Philips SalonStraight ProProtect 230 Bedienungsanleitung
Philips
Philips HP8309/03 Bedienungsanleitung
Philips
Philips BHS384 Bedienungsanleitung
