Philips WP3820 Bedienungsanleitung

WP3820

ENGLISH 6

PORTUGUÊS DO BRASIL 22

Introduction

Congratulations on your purchase and welcome to Philips!To fully

benet from the support that Philips offers, register your product at

www.philips.com/welcome.

General description (Fig. 1)

AFilter cartridge

B Water purier housing

CFilter capacity selection button

DBattery low indication

E Selected lter capacity indication

F Remaining lter capacity indication

GReset button

HWater selection lever

IBattery compartment cover

JStainless steel screen

KRubber washer

LAdapter

1A-type

2B-type

3C-type

4D-type

MAttachment nut

NFiltered water outlet

O Unltered water inlet

PGranular activated carbon

Q Hollow bre

R Unltered water outlet

Important

Read this user manual carefully before you use the appliance and save it

for future reference.

ENGLISH

Warning

This appliance is not intended for use by persons (including children)

with reduced physical, sensory or mental capabilities, or lack of

experience and knowledge, unless they have been given supervision

or instruction concerning use of the appliance by a person

responsible for their safety.

Children should be supervised to ensure that they do not play with

the appliance.

Before use

To prevent quick clogging of the lter cartridge, let the water run at

the unltered setting for around 5 seconds before every use.

If the water is highly coloured or turbid due to work on your water

network, do not let the water run at the ltered setting until the

water is clear.

Let the water run at the ltered setting for 10 seconds before the

rst use of the day.

Let the water run at the ltered setting for 60 seconds before use if

you have not used the water purier for more than two days.

If you have not used the water purier for more than two weeks, let

the water run at the ltered setting for 2-3 minutes before use. If the

lter cartridge emits an unpleasant smell, replace it with a new one.

Water temperature

Do not let water hotter than 50°C run through the water purier,

because this may damage the appliance.

Do not let the water purier freeze.

Battery

To prevent that the battery leaks, overheats or explodes:

Do not disassemble the battery.

Do not charge the battery.

Do not use a damaged battery.

Do not expose the battery to water or high humidity levels.

Do not expose the battery to direct sunlight, high temperatures or

re.

ENGLISH 7

Any liquid leaking from the battery is harmful to eyes and skin. Avoid

eye and skin contact.

Applications

Only use the appliance to lter water that meets drinking water

standards at the point of use.

Do not block the ltered water outlet or connect other devices to it.

If the water pressure is very high, reduce the water ow of the tap to

prevent damage to the cartridge.

Keep the water purier away from heat to avoid distortion or

breakage.

Do not tamper with the water purier.

Do not remove the lter cartridge while you use water purier.

Do not use the water purier without a lter cartridge.

Do not place the appliance near a window where it is exposed to

direct sunlight.

This appliance does not soften water.

Do not use ltered water in aquariums. Tap water, ltered or

unltered, can be harmful to sh.

Do not store puried water to avoid contamination. Air contact

contaminates puried water quickly. If you want to store puried

water, use a clean container and keep it in the refrigerator. Do not

keep it in the refrigerator longer than 1 day to avoid contamination.

Features

Philips’ multi-ltration system consists of a primary lter, a secondary

lter, a high-tech hollow-bre membrane lter and a granular

activated carbon lter.

The hollow bre membrane contains more than 520 billion

micropores that are small enough to remove particles down to

0.1µm. It eliminates 99.99%* of bacteria, rust and other particles

larger than the micropore size from your tap water without removing

calcium, magnesium and other minerals that are vital to your body.

(* tested according to Japanese Water Purier Association (JWPA)

standard).

ENGLISH8

The granular activated carbon removes the unpleasant chlorine smell

and taste from your tap water.

The LCD display on the water purier shows the current remaining

lter capacity. A remaining lter capacity of 0 tells you that you

have to replace the lter. Philips’ unique cartridge replacement

indicator also helps you to determine when to replace the lter.

The high-speed initial ow rate of 2 litres per minute gives you plenty

of clean water instantly.

The water selection lever offers you a choice of three water ow

types: unltered spray, unltered stream or ltered spray.

The nine tap-mounting adapters supplied with the water purier

allow easy installation on almost any type of tap.

The bayonet-type mount ensures quick, easy and secure lter

cartridge replacement.

Preparing for use

Inserting the battery

Before you insert the battery, make sure your hands and the water

purier are dry.

Keep away from the kitchen sink to prevent the battery from falling

down the drain.

Insert the battery before you install the water purier on the tap.

1 Use a coin to turn the battery compartment cover on the back of

the water purier in the ‘OPEN’ direction. Remove the battery

compartment cover (Fig. 2).

2 Place the battery (included) in the cover, with the + pole facing the

battery compartment cover (Fig. 3).

3 Place the battery compartment cover back onto the water purier

in such a way that the ‘%’ mark on the cover is aligned with the ‘I’

mark on the water purier. (Fig. 4)

4 Use a coin to turn the battery cover in the ‘CLOSE’ direction until

the ‘I’ mark on the cover is aligned with the ‘I’ mark on the water

purier (Fig. 5).

ENGLISH 9

Note: Make sure you align the ‘I’ marks properly, otherwise water may leak

into the battery compartment.

When the battery is properly inserted, the LCD display performs a

self-check for approx. 9 seconds. Then the display goes off again.

Before installation

The screw thread of the tap is sharp.

Before you install the water purier, make sure all tap-mounting

adapters you require are present.

The tap must have a diameter of 13mm-25mm.

Determine what type of tap you have and select the appropriate

adapter.

The adapters supplied make the water purier suitable for almost

any kitchen tap. However, the water purier may not t some

uncommon types of taps.

The tap water pressure has to be between 0.7kgf/cm² (7 metres of

water column) and 3.5kgf/cm² (35 metres of water column). If you

use the water purier at a water pressure outside this range, either

the ltered water ow will be extremely low or the water purier

will get damaged.

Installation A-type adapter

For taps with a round spout with a diameter of 16mm, 17.5mm or

19mm (Fig. 6).

1 Remove the attachment nut and the adapter from the water

purier housing (Fig. 7).

2 Pass the attachment nut over the tap spout (Fig. 8).

3 Place the matching adapter (A-type) over the tip of the spout. The

16mm adapter is packed with the water purier. If necessary,

replace it with the 17.5mm adapter or 19mm adapter to t the

diameter of your tap (Fig. 9).

4 Screw the attachment nut rmly onto the water purier

housing (Fig. 10).

ENGLISH10

Inhaltsverzeichnis

Sprachen:

Andere Philips Wasserfiltersystem Handbücher

Philips

Philips AC4012 Bedienungsanleitung

Philips

Philips Pure Taste WP3861 Bedienungsanleitung

Philips

Philips AC4142 Bedienungsanleitung

Philips

Philips Saeco AquaClean CA6903/47 Bedienungsanleitung

Philips

Philips AC4143 Bedienungsanleitung

Philips

Philips AWP1811 Bedienungsanleitung

Philips

Philips AUT7006 Bedienungsanleitung

Philips

Philips IronCare GC024 Bedienungsanleitung

Philips

Philips AWP2950/03 Bedienungsanleitung

Philips

Philips AWP2980 Bedienungsanleitung

Philips

Philips Saeco BRITA INTENZA+ Bedienungsanleitung

Philips

Philips AC4144 Bedienungsanleitung

Philips

Philips GoZero Bedienungsanleitung

Philips

Philips AUT3234 Bedienungsanleitung

Philips

Philips AUT3015 Bedienungsanleitung

Philips

Philips Micro Pure WP3811 Bedienungsanleitung

Philips

Philips AC4105 Bedienungsanleitung

Philips

Philips AUT2016 Bedienungsanleitung

Philips

Philips WP3870 Bedienungsanleitung

Philips

Philips AWP2900 Bedienungsanleitung

Philips

Philips Saeco AquaClean CA6903 Bedienungsanleitung

Philips

Philips Micro Pure WP3811 Bedienungsanleitung

Philips

Philips Micro Pure WP3811 Bedienungsanleitung

Philips

Philips Saeco AquaClean CA6903 Bedienungsanleitung

Beliebte Wasserfiltersystem Handbücher anderer Marken

Wisy

Wisy LineAir 100 Bedienungsanleitung

Schaffner

Schaffner Ecosine FN3446 Series Betriebsanleitung

Pentair

Pentair FLECK 4600 SXT Benutzerhandbuch

H2O International

H2O International H20-500 Bedienungsanleitung

Renkforce

Renkforce 2306241 Bedienungsanleitung

Neo-Pure

Neo-Pure TL3-A502 Bedienungsanleitung

FLTR

FLTR OBF Bedienungsanleitung

STA-RITE

STA-RITE VERTICAL GRID DE FILTERS S7D75 Bedienungsanleitung

Applied Membranes

Applied Membranes W-G844EM Bedienungsanleitung

BEGA

BEGA 116 Bedienungsanleitung

WATA

WATA Standard Bedienungsanleitung

Price

Price FFU series Handbuch

Gaggenau

Gaggenau BRITA INTENZA 467873 Bedienungsanleitung

Brita

Brita SAFF-100 Bedienungsanleitung

HEISSNER

HEISSNER FPU24000-00 Bedienungsanleitung

BGS technic

BGS technic 1518 Bedienungsanleitung

Reverse Osmosis

Reverse Osmosis RF Series Bedienungsanleitung

ubbink

ubbink Filtramax Series Bedienungsanleitung