Phrozen Transform Bedienungsanleitung
Phrozen Transform Operating
Instruction
Congratulations on joining the Phrozen 3D printer. When you receive the Phrozen
Transform, please check the contents of the package inside of the box.
General content includes：
• Phrozen Transform Printer * 1 pc
• Print stage and resin tank * 1 set
• Print Accessibility Tool Set
o Soft scraper * 1 pc
o Hard scraper * 1 pc
o Funnel * 1 pc
o Gloves * 1 set
• Black power cord * 1 pc
If you have any missing component or problems, please contact the Phrozen team
directly
The first time start the machine
Power on
Connect the black power cord to the machine and turn on the power switch above
the socket.When the power is turned on, the machine will start to open the system,
and the first start will take about 2 minutes The opening screen is as follows:
After opening, entering the main screen of the system, the boot is finished.
Z-AXIS Calibration
•Z-axis calibration: This is the only place where the Phrozen Transform
needs to be corrected. It is suggested use the touch panel on the machine.
The detailed steps are as follows：
•1.Open the front cover of the machine
Open the front cover of the machine: It is suggested when facing the machine,
open the right front cover first
2. Click on the Z-axis calibration icon on the homepage
3. Click on the right icon to enter the calibration function.
4. Confirm that there is no foreign matter on the printing stage and remove the
resin tank. Place an A4 blank sheet over the LCD screen.。
5.Use the hex wrench to loosen the four fixing screws on the side of the printing
stage and click Next.
.
6.The machine will transport the printing stage to the bottom. At this time, the
printing stage will be flattened with blank paper. One hand will gently fix the
stage, and the other hand will lock the table screw. After the four screws are
locked, the Z-AXIS calibration is done
7. Press DONE to complete the calibration procedure.
8. The machine will raise the stage to the highest level to finish the Z-axis
calibration.
9.The timing of Z-AXIS calibration
●The first time use the machine
●After replacing the screen
●Because the Z-AXIS calibration is not correct cause the printing fails.
●When long-distance movement or strong relocation causes the machine to shake.
Start printing
Pour resin
Andere Phrozen 3D-Drucker Handbücher
Phrozen
Phrozen SONIC 4K Gebrauchs- und Pflegehandbuch
Phrozen
Phrozen SONIC MINI 8K Gebrauchs- und Pflegehandbuch
Phrozen
Phrozen MegaCure Bedienungsanleitung
Phrozen
Phrozen Shuffle 2019 Bedienungsanleitung
Phrozen
Phrozen SONIC MIGHTY 4K Bedienungsanleitung
Phrozen
Phrozen SONIC MINI 8K S Installations- und Benutzerhandbuch
Phrozen
Phrozen Sonic Mega 8K Bedienungsanleitung
Phrozen
Phrozen Sonic Mini Series Bedienungsanleitung
Phrozen
Phrozen SONIC MINI 4K Bedienungsanleitung
Phrozen
Phrozen SONIC MIGHTY 8K Bedienungsanleitung
