13. Use only with the cart, stand, tripod, bracket
or table specified by the manufacturer or
sold with the apparatus. When a cart is used,
use caution when moving the cart/apparatus
combination to avoid injury from tip-over.
14. Unplug this apparatus during lightning
storms or when unused for long periods of
time - to prevent damage to this product.
15. Refer all servicing to qualified service personnel. Servicing is
required when the product has been damaged in any way: such
as the power supply cord or plug has been damaged; liquid has
been spilled or objects have fallen into the product; the product
has been exposed to rain or moisture, does not operate
normally, or has been dropped - Do not attempt to service this
product yourself. Opening or removing covers may expose you
to dangerous voltages or other hazards. Please call
PianoDisc® to be referred to an authorized service center near
you.
16. To prevent risk of fire or electric shock, avoid overloading wall
outlets, extension cords, or integral convenience receptacles.
17. Do not let objects or liquids enter the product - as they may
touch dangerous voltage points or short-out parts that could
result in a fire or electric shock.
18. Do not install near any apparatus that is sensitive to magnetic
fields - The product contains permanent magnets that could
disrupt the operation of apparatus such as computer disk drives
or CRT devices including TV sets and computer monitors.
19. Avoid power lines - Use extreme care when installing an outside
antenna system to keep from touching power lines or circuits, as
contact with them may be fatal. Do not install external antennas
near overhead power lines or other electric light or power
circuits, nor where an antenna can fall into such circuits or
power lines.
20. Ground all outdoor antennas - If an external antenna or cable
system is connected to this product, be sure the antenna or
cable system is grounded. This will provide some protection
against voltage surges and built-up static charges. Section 810
of the National Electrical Code ANSI/ NFPA No. 70 provides
information with respect to proper grounding of the mast and
supporting structure, grounding of the lead-in wire to the
antenna discharge unit, size of grounding conductors, location
of antenna-discharge unit, connection to grounding electrodes,
