Planex GW-DSMM Bedienungsanleitung
IEEE802.11g Wireless MIMO
XRTM PCIBus Adapter
GW-DSMM
Foreword
Explanation of the signals
In order to let you set up and use this product correctly, please pay attention when reading or
browsing the manual as you see these signals listed below.
Warning/ Danger
Users should read the explanation carefully and understand it completely, otherwise
users might be in danger or even be injured.
Caution/ Be Careful
Remind users to be careful when setting up the product and to avoid damaging the
product or its system programs.
Seeking for service or searching for an agent or a distributor
Thank you for purchasing products from Planex Communications Inc. If you have any
operational problems while conÀguring or setting up the product, you may contact with our
Customer Service Department or ask the agent or the distributor from which you bought
the product for help. Moreover, during warranty, if you Ànd any defect or breakdown of the
product, you may bring the product, assembly, and its warranty card to our company or to
where you bought the product to ask for repair.
ŘEvery product has different warranty period and contract; please refer to our
company for further information or consult the agent or the distributor.
Planex Communications Inc.
Support PhoneĈ+65-6238-6859 (Singapore)
+886-2-8218-7114 or +886-2-2219-7454 (Taiwan)
Contact Us
TelĈ+886-2-2219-1816
FaxĈ+886-2-2219-0655
Agents & DistributorsĈhttp://www.planex.net/where/index.htm
Trademarks:
All trade names and trademarks are the properties of their respective companies.
Copyright © 2006, All Rights Reserved.
GW-DSMM
Contents
Foreword
Chapter1 Introduction to GW-DSMM
1.1 Package Contents....................2
1.2 Features ............................2
1.3 Product Functions ....................3
Chapter2 Basic Installation & Configuration
2.1 How to install the Driver & Utility ........ 5
2.2 Site Survey..........................11
2.3 Profile .............................16
2.4 Authentication and Security ...........20
2.5 802.1x Setting .......................26
2.6 Link Status ..........................30
2.7 Statistics ...........................32
Chapter3 Advanced Configuration
3.1 Advanced .........................35
3.2QoS...............................39
3.3 About .............................41
Chapter4 Soft AP Mode
4.1 How to use AP mode .................43
4.2 Config .............................45
4.3 Auth. vs. Security ....................49
4.4 Access Control ......................52
4.5 MAC Table .........................54
4.6 Event Log ..........................55
4.7 Statistics ...........................56
4.8 About .............................58
GW-DSMM Contents
1
1
Chapter1 Introduction to GW-DSMM
1Introduction to GW-DSMM
Thank you for purchasing the IEEE 802.11g Wireless MIMO XRTM
PCIBus Adapter – GW-DSMM.XR
TM technology can improve wireless
transmission over a long distance, and GW-DSMM fully supports the
MIMO XRTM technology which enables you to connect with wireless
networks at further distances. GW-DSMM has two internal and one
external antenna which are designed to maintain high data transmission
rate even at further distance; therefore, not only the connection distance
is enhanced, but also the ņdead spotsŇon the network are reduced.
In addition, GW-DSMM is backward compatible with 802.11b. When
GW-DSMM is connecting to the standard 802.11b or 802.11g APs or
routers, it can perform much better than other standard stations.
GW-DSMM supports higher data throughput than the IEEE802.11g
standard (up to 54Mbps). It can compress the data and decrease the waiting
time of sending the data to the next routers or APs, so it increases the data
transmission rate. This function is called Turbo Mode. When GW-DSMM
WLAN adapter connect to the APs or routers by using this particular
function, your wireless network will be more effective.
For the security of WLAN, GW-DSMM supports 64/128-bit
WEP data encryption which protects your wireless network from
eavesdropping. It also supports WPA which combines IEEE802.1x
and TKIP technologies. Client users are required to authorize
before accessing to APs or routers, and the data transmitted on the
network is encrypted and decrypted by a dynamically changed
secret key. Besides, GW-DSMM supports WPA2 function which provides a
stronger encryption through AES which is the most advanced WLAN solution for
IEEE802.11i.
GW-DSMM is cost effective and with many versatile features. It
must be the best solution for you to build your wireless network.
1
2
GW-DSMM
1.1. Package Contents
After purchasing GW-DSMM, IEEE 802.11g Wireless MIMO XRTM
PCIBus Adapter, from a reseller or an agency, please open the package and
check all the components listed below are included. If there is any item
missing, please contact with the reseller or the agency at once.
œGW-DSMM x 1
œ2dBi Dipole Antenna x 2
œ0.5dBi Desktop Antenna x1
œCD-ROM(Driver & Utility) x 1
œUser's Manual x 1
œWarranty Card x 1
1.2. Features
œCompatible with IEEE 802.11b and IEEE 802.11g 2.4GHz
œData transmission rate is up to 54Mbps
œLarger wireless coverage, less dead spots and higher throughput
with MIMO XRTM technology
œSupports Turbo Mode which can enhance the data transmission
rate within the specific wireless network
œSupports WMM (Wi-Fi Multimedia) function (IEEE 802.11e QoS
standard) and can meet the requirement of the multi-media data
bandwidth
œSupports 64/128-bit WEP, WPA (TKIP with IEEE802.1x) and
WPA2 (AES with IEEE 802.1x) functions for high level security
œSupports CCX 2.0(Cisco Compatible Extensions) for the radio
monitoring and fast roaming
1
3
Chapter1 Introduction to GW-DSMM
œAutomatic fallback which increases the data security and
reliability
œSupports the most popular O.S.ĈWindows 98SE/ME/2000/
XP/2003
œSupports PCI-BUS interface
1.3. Product Functions
Antennas
If you hope to receive better radio signals, you can
adjust the position and the direction of the antenna to
get better signals.
LINK LED
Put GW-DSMM into the PCI-BUS of your computer,
and power on the computer. If the connection if fine,
the LINK LED will be green all the time.
ACT LED
Put GW-DSMM into the PCI-BUS of your computer,
and power on the computer. If the data start to
transmit or any action happens, the ACT LED will be
flashing green lights.
2
5
Chapter2 Basic Installation & Configuation
2Basic Installation & Configuration
Before starting to install the utility, please pay attention to the
following statements:
1.If you had installed the wireless PC card driver and utility
before, please uninstall the old version first.
2.The following illustrations of installation procedures are from
Windows XP. And these procedures are all similar to the operating
procedures on Windows 98SE/ME and Windows 2000.
2.1. How to install the driver and utility
Please follow the instructions below to install the driver and utility of
GW-DSMM.
1.Open the shell of your computer, and then insert GW-DSMM into the
PCI-BUS and put the external antenna at the spot which does not have
many obstacles around and can have better radio signals. Put back
the shell and power on the computer. After that, the computer will
automatically detect and open the Found New Hardware Wizard, please
click ņCancelŇand then use the driver and utility of GW-DSMM.
2
6
GW-DSMM
2.Put the installation CD-ROM into the CD-ROM player and then start the
ņGW-DSMM_v1.2.2.0.exeŇprogram. After that, the setup wizard will
automatically start the ņInstallShield WizardŇto continue setting up.
Inhaltsverzeichnis
Andere Planex Computerhardware Handbücher
Beliebte Computerhardware Handbücher anderer Marken
EMC2
EMC2 VNX Series Betriebsanleitung
Panasonic
Panasonic DV0PM20105 Bedienungsanleitung
Mitsubishi Electric
Mitsubishi Electric Q81BD-J61BT11 Bedienungsanleitung
Gigabyte
Gigabyte B660M DS3H AX DDR4 Bedienungsanleitung
Raidon
Raidon iT2300 Bedienungsanleitung
National Instruments
National Instruments PXI-8186 Bedienungsanleitung
