Polycom realpresence group convene Bedienungsanleitung
1
ENGLISH
www.polycom.com
© 2015, Polycom, Inc. All rights reserved. POLYCOM® and the names and marks as-
sociated with Polycom’s products are trademarks and/or service marks of Polycom,
Inc. and are registered and/or common law marks in the United States and various
other countries. No portion hereof may be reproduced or transmitted in any form or
by any means, for any purpose other than the recipient’s personal use, without the
express written permission of Polycom.
P/no. MFL69143011 (1503-REV00)
Set Up the Polycom® RealPresence® Group Convene™
Display AC/DC adapter 4 AC Power
adapters
Stand body
Stand base Screws (4 pcs)
(M4 X L10)
Cable cover Rear cover
HDMI cable DC-to-DC jumper
cable
2 Screws and
2 T-Nuts
Easy Setup Guide
*MFL69143011*
ENGLISH
2
ASSEMBLE THE STAND
1
2
3
Use the packing material from the
lower portion of the display as a
platform for assembly.
Do not stand the unit up until the
installation and cabling are complete.
INSTALL THE CAMERA
Unpack the RealPresence Group Series co-
dec and camera. Reserve the codec power
supply for future use.
Power supply
Only use the power supply
provided with the display
accessory.
Open the hinge on the camera and insert the hinge into the camera
bracket on the rear top of the display.
Gather the excess cable and secure with the cable ties.
3
ENGLISH
ASSEMBLE THE STAND
Use the packing material from the
lower portion of the display as a
platform for assembly.
Do not stand the unit up until the
installation and cabling are complete.
INSTALL THE CAMERA
Open the hinge on the camera and insert the hinge into the camera
bracket on the rear top of the display.
Gather the excess cable and secure with the cable ties.
Do not carry display by holding the base.
Do not carry the display upside down by just holding the
base. This may cause the display to fall off the stand and
could result in personal injury.
ENGLISH
4
CONNECT CABLES
Plug the DC-to-DC jumper between the
display and the codec.
Connect and route all cables through the
cable management channel.
Note: Generic cables
If you use generic cables
not certied by LG and
Polycom, the screen may
not display or there may
be image noise.
INSTALL THE CODEC
Install the RealPresence Group Series codec by inserting the T-nuts into
the keyholes on the back of the display.
Connect the DC power, LAN, HDMI, and camera cables to the codec. Refer
to the RealPresence Group Series 500 Setup Sheet for details.
Route the LAN and DC power supply cables between the codec and dis-
play and then through the cable channel at the rear of the stand.
PREPARE THE CODEC
HDMI IN
DC-OUT
(12V 2.7 A)
DC-IN
(12V )
5
ENGLISH
CONNECT CABLES
INSTALL THE CODEC
Install the RealPresence Group Series codec by inserting the T-nuts into
the keyholes on the back of the display.
Connect the DC power, LAN, HDMI, and camera cables to the codec. Refer
to the RealPresence Group Series 500 Setup Sheet for details.
Route the LAN and DC power supply cables between the codec and dis-
play and then through the cable channel at the rear of the stand.
PREPARE THE CODEC
HDMI IN
DC-OUT
(12V 2.7 A)
DC-IN
(12V )
HDMI IN
DC-OUT
(12V 2.7 A)
DC-IN
(12V )
HDMI IN
DC-OUT
(12V 2.7 A)
DC-IN
(12V )
ENGLISH
6
Stand Hinge
Cable cover
MANAGE THE CABLES
Arrange the cables so that they run below the stand hinge and then cover
them with the cable cover from the bottom up.
You can disassemble the cable cover by following the assembly instruc-
tions in reverse order.
INSTALL THE REAR COVER
Install the rear cover on the stand by tting the hooks on the cover into
the slots on the back of the display and sliding into place.
7
ENGLISH
MANAGE THE CABLES
Arrange the cables so that they run below the stand hinge and then cover
them with the cable cover from the bottom up.
You can disassemble the cable cover by following the assembly instruc-
tions in reverse order.
INSTALL THE REAR COVER
Install the rear cover on the stand by tting the hooks on the cover into
the slots on the back of the display and sliding into place.
ENGLISH
8
CONNECT THE HEADPHONES (OPTIONAL)
CONNECT POWER
DC Switch
(shipped
with codec)
Caution: Power on DC switch rst.
Power on the DC switch on the bottom of the product
before turning on the display.
Four AC power adapter cables are supplied with the display. Select the ap-
propriate AC power adapter cable for your geographic region. Connect the
cable to the power supply input. Connect the AC power cable, provided
with the RealPresence Group Series codec, to the AC power adapter cable.
9
ENGLISH
CONNECT THE HEADPHONES (OPTIONAL)
Bottom Center of
the Display
CONNECT POWER
Four AC power adapter cables are supplied with the display. Select the ap-
propriate AC power adapter cable for your geographic region. Connect the
cable to the power supply input. Connect the AC power cable, provided
with the RealPresence Group Series codec, to the AC power adapter cable.
ENGLISH
10
Power/Menu buttons
POWER ON THE SYSTEM
Power on the display. When the Automatic Standby message appears,
select Yes to disable Automatic Standby. Otherwise, the display will go
into Automatic Power Down after four hours and it will not wake up for
a video call without manually turning on the display. When the codec
nishes booting up, refer to the Polycom RealPresence Group Series
Administrator Guide for details on codec settings conguration and IP
connectivity.
ADJUST THE ANGLE
Automatic Standby
Automatic Standby is currently set at 4 hours.
Would you like to disable Automatic Standby?
Yes No
Press "OK" button to select.
OK EXIT
Andere Handbücher für realpresence group convene
1
Inhaltsverzeichnis
Andere Polycom Konferenzsystem Handbücher
Polycom
Polycom VSX 3000 Bedienungsanleitung
Polycom
Polycom OTX 300 Merkblatt
Polycom
Polycom HDX Room Systems Bedienungsanleitung
Polycom
Polycom RealPresence Group Series Handbuch
Polycom
Polycom CX8000 Montageanleitung
Polycom
Polycom V500 Bedienungsanleitung
Polycom
Polycom MGC-100 Bedienungsanleitung
Polycom
Polycom RealPresence Group Series Service-Handbuch
Polycom
Polycom MGC-100 Bedienungsanleitung
Polycom
Polycom VSX 3000 Bedienungsanleitung
Polycom
Polycom realpresence group 550 Service-Handbuch
Polycom
Polycom VSX 7000 Installations- und Betriebshandbuch
Polycom
Polycom SIP 2.2.0 Bedienungsanleitung
Polycom
Polycom Digital Signage 2000 Bedienungsanleitung
Polycom
Polycom VSX 7000 Gebrauchsanweisung
Polycom
Polycom V500 Bedienungsanleitung
Polycom
Polycom realpresence trio 8800 Technisches Datenblatt
Polycom
Polycom IPOWER 9000 Bedienungsanleitung
Polycom
Polycom HDX Series Bedienungsanleitung
Polycom
Polycom RealPresence Group Series Montageanleitung
Beliebte Konferenzsystem Handbücher anderer Marken
Kramer
Kramer VIA GO Bedienungsanleitung
AVT
AVT MAGIC AC1 Go Bedienungsanleitung
ProSoft Technology
ProSoft Technology AN-X4-AB-DHRIO Bedienungsanleitung
Sony
Sony PCS-I150 Bedienungsanleitung
Middle Atlantic Products
Middle Atlantic Products VTC Series Bedienungsanleitung
Prentke Romich Company
Prentke Romich Company Vanguard Plus Leitfaden
