Operating Instructions
Power On/Off Device
1. Press the POWER key for 1 second to switch on and hold for 3 seconds to switch off the device manually.
2. While device is connected to the car, the device will turn on automatically when engine is started. When
car engine shuts off or car charger been disconnected, the device automatically switches off after 10
seconds (unless feature is turned off).
System Settings
In video or image mode press the MENU key and then the UP/DOWN key once followed by OK to enter the
“System Setup”. Navigate through options using UP/DOWN key and press OK to select. Press
POWER/MODE button (top of unit) to change selection.
•G-Sensor: On/Off.
•File Type: Emergency video, circular video and image.
•Sounds: Video with/without sound, buzzer on/off and sound adjustment.
•Power Save: Off / 1min / 3min / 5min.
•Flash: On/Off.
•Date & Time: Date and time adjustment.
•Language: Choose the desired language from various languages.
•Light Freq: On/Off.
•TV Out: NTSC/PAL (Should be set to PAL)
•Format: Format the SD card.
•System: Restore factory settings, system info and SD card info.
•Delay shutdown: On/Off. A 10 second delay before shutdown.
Video settings
After powering on the device the default mode is video mode. When in video mode the video mode icon
will be displayed in the upper-left corner of screen. Press the OK key to start video recording. Please
note a SD card must be inserted prior to use (not included).
During recording, the red icon flashes on the top left of the screen.
The GPS icon will show white when no GPS signal is present & green when a GPS signal is present.
If no GPS signal is present, check to ensure GPS antenna is connected.
Press the OK key to stop recording.
