6v2021-02-1.09EN
oIn places subject to bad weather that could allow foreign bodies (dust,
sand, water, etc.) to enter through the vents and openings of the device
oDirectly on soft ground (sand, snow) which could block the ventilation of
the device.
•The device is designed to withstand water projections directed downwards,
up to an angle of 45 degrees from vertical. Do not expose the device to an
immediate environment exceeding these conditions of use.
•Do not immerse the device in water or any other liquid.
•Keep a minimum distance of 4 inches around the device for sufficient ventila-
tion.
•Before use, check that the device and its accessories (in particular cables and
connecting elements) are not damaged. In the case of damage, do not use
the device and contact your dealer for any inspection or repair.
•Never intentionally open a reactant bag. The internal powder reacts in the
presence of water and the direct contact of the powder with water produces
significant heat. In the case of a torn and unused reactant bag, set it aside in
a dry, heat-resistant place. Never use a torn reactant bag with the device.
Avoid powder ingestion and direct unprotected contact.
•Donot disassemble the device yourself. All disassembly, repair and verifica-
tion must be carried out exclusively by a trained / qualified person. Always
check before use whether the tank is filled to appropriate level with water.
•If the device is used with an inadequate water level, it may damage the device
and render it unusable.
•The reaction to produce hydrogen also produces heat. The heating of the
reactor is normal. The peak of heat is produced during the first 60 minutes of
the reaction. Do not open the reactor within 60 minutes of starting the produc-
tion hydrogen reaction. Wait for the reactor to cool before opening it.
•During use, some parts of the device may be hot. Do not touch the top of the
hydrogen reactor.
•The water in the reactor may be hot after use. Take the necessary precau-
tions when draining the reactor to avoid physical contact with hot water.
•The surfaces of the hydrogen reactor may be subjected to residual heat after
use, until the device has completely cooled.
•Do not clean the device with cleaners, metal sponges or other abrasive ma-
terials.
•Donot clean the device with products containing solvents.
•This device is designed to be used exclusively with the white reactant bags
intended for its use. The reactant bags are for single use.
•Keep these instructions.
