Flush Channel Installation Guide
3v001 | Flush Channel Installation Guide
Read and save these instructions before beginning to install the Node Flush Channel.
Warning! To reduce the risk of re, electric shock, or injury to persons, observe the following:
• When cutting or drilling into wall or ceiling do not damage electrical wiring and other hidden utilities
• Use this unit only in the manner intended by the manufacturer. If you have any questions, contact the
manufacturer info@parc-celings.com.
Before You Start
Inspect all product parts for aws and shipping damage.
If anything is discovered to be damaged, contact the shipping company and manufacturer immediately.
W
arning!
Damaged
or
missing
parts
must
be
reported
to
P
ARC
at
[email protected]info@parc-ceilings.com immediately, PARC will not be responsible for any damage or loss that occurs during unpacking or installation.
Site Conditions, Storage and Handling
Read this guide before handling the product.
• Read the Installation Guide before handling.
• Always wear appropriate hand protection when handling.
• Only store in clean dry conditions.
• Do not over stack.
• Do not stack in a way likely to cause falls.
Poor or rough handling, rolling or dropping of the product on corners or edges may cause damage to the product or
cause the product to deteriorate.
Lengths of Node should not span between points as any load applied mid-span may cause product damage.
Site storage of items should be at, preferably on a suitable pallet (supporting the entire length of the Node Flush
Channel) without additional top loading.
Consideration should be given to the advice of the Site Occupational Health and Safety Representative regarding
manual handling. An assessment should be made of any risk and if necessary mechanical lifting equipment should be
used.
The storage space must be cleared of debris and, in general, should be enclosed. The Node Flush Channel should be kept
clean, dry and protected from the elements.
Site conditions should be prepared for installation of the Node Flush Channel. The site should be clean, dry and clear of
other trades working in the ceiling void.
Flush Channel with Diffuser
Installation Guide
3
Flush Channel with Diffuser Installation Guide
Read and Save these Instructions before beginning to install Node Flush Channel with Diffuser:
Warning! To reduce the risk of fire, electric shock, or injury to persons, observe the following:
•When cutting or drilling into wall or ceiling do not damage electrical wiring and other hidden utilities.
•Use this unit only in the manner intended by the manufacturer. If you have any questions, contact the
manufacturer info@PARC-celings.com.
Before You Start:
Inspect all product parts for flaws and shipping damage.
If anything is discovered to be damaged, contact the shipping company and manufacturer immediately.
Node Flush Channel with Diffuser Installation Tools Required:
Site Conditions, Storage & Handling:
Read This Guide before handling the product.
•Read the Installation guide before handling.
•Always wear appropriate hand protection when handling.
•Only store in clean dry conditions
•Do not over stack.
•Do not stack in a way likely to cause falls.
Poor or rough handling, rolling or dropping of the product on corners or edges may cause damage to the product or
cause the product to deteriorate.
Lengths of node should not span between points as any load applied mid-span may cause product damage.
Site storage of items should be flat, preferably on a suitable pallet (supporting the entire length of the Node Flush
Channel with Diffuser) without additional top loading.
Consideration should be given to the advice of the Site Occupational Health & Safety Representative regarding manual
handling. An assessment should be made of any risk and if necessary mechanical lifting equipment should be used
Tools Required
LEVEL
4 MM HEX KEY
DRIVER T25 TORX DRIVER
5/16” / 8MM
SOCKET OR
WRENCH
LASER LEVEL MEASURING TAPE NODE REMOVAL
TOOL
