- 2 -
When using an electrical device, basic safety precautions should always be followed,
including the following:
Read all instructions before using the Tiertime filament dryer (hereinafter
referred as the "dryer").
Always use a heat resistant surface.
DO NOT touch hot surfaces.
To protect against electrical hazards, DO NOT immerse cord, plug or the dryer
in water or any other liquid. DO NOT switch the dryer ON if surfaces are wet.
Do not allow children to use the dryer, close supervision is necessary when the
dryer is used near children.
Unplug from outlet when not in use and before cleaning. Allow to cool before
putting on or taking off parts.
DO NOT operate the dryer with a damaged cord or plug or after the dryer
malfunctions, or has been damaged in any manner. Return the dryer to the
manufacturer for examination, repair or adjustment. See Warranty section.
The use of accessories/attachments not recommended may cause hazards.
DO NOT use outdoors.
DO NOT let cord hang over edge of table or counter, or touch hot surfaces.
DO NOT place on or near a hot gas or electric burner, or in a heated oven.
DO NOT block the air intakes or exhaust in any manner.
DO NOT use for other purposes other than the intended use.
To disconnect, turn the power switch to ‘OFF’, then unplug from wall outlet.
DO NOT pour liquids into the dryer.
DO NOT leave the dryer unattended while in use.
DO NOT operate near combustible or pressurized spray cans.
DO NOT use the dryer more than 48 continuous working hours. After a
maximum of 48 hours in use, turn OFF the dryer, unplug and allow it to cool.
Leave a minimum 30 mm (1.25") open space all around the exterior of dryer.
The use of unauthorized accessories may cause injuries.
Store in a dry & clean place. Do not drop, knock or shake the dryer. Rough
