ProFlight Wraith PFBD104 Bedienungsanleitung
Wraith
User Manual
Model: PFBD104
Thank you for choosing ProFlight.
Please read this user manual before using this drone and
keep it safe for future reference.
2of 18
CONTENTS
Safety
3
Battery Installation
5
Battery Charging
5
Installing Controller Batteries
6
Transmitter Diagram
6
Installing the Mobile Holder / Antenna
7
Propeller Installation
7
Installing the Legs
8
Installing the Camera (Optional)
8
Installing the Action Camera Mount
8
Preparing for First Flight
9
Binding of Radio Transmitter and Receiver
9
Gyro Calibration
9
Compass Calibration
10
Flight Instructions
11
Flight Adjustment
12
Aircraft Functions & Features
13
Camera
13
App
14
Troubleshooting Guide
16
Support
17
3of 18
SAFETY
Read the entire instruction manual and familiarise yourself with the product
and all its features before operating. Failure to operate the product correctly
can result in damage to the product, surroundings or even serious injury. This
product is not a toy and must be operated with caution and common sense. It
requires some basic mechanical knowledge. This product is not intended for
use by children without direct adult supervision. This manual contains
instructions for safety, operation and maintenance. It is essential to read and
follow all the instructions and warnings in this manual prior to assembly, setup
or use in order to operate correctly and avoid damage or serious injury.
Not intended for use by children under 14 years of age. This is not a toy.
Always operate your drone in open spaces away from vehicles, buildings,
traffic and people.
Never operate your drone with low transmitter batteries
Avoid exposure to water as moisture can cause damage to the
electronics.
Do not touch the propellers while
they are rotating, as injury is likely to
occur.
Always keep out of reach of children.
Do not operate the drone in adverse weather conditions, such as during
storms, rain, strong wind ( Over 10 m/s), fog or snow
Ensure the drone is kept away from people, trees, electrical wires and
tall buildings during flight. Radio transmission towers, power lines,
electrical substations and similar may interfere with the compass, which
could prevent adequate control of the drone.
4of 18
The battery charger included with the drone has been designed to safely
charge the Li-Po battery.
Mishandling of Li-Po batteries can result in a fire, personal injury, and
/or property damage.
By handling, charging or using the included Li-Po battery you assume all
risks associated with lithium batteries.
If at any time the battery begins to balloon or swell, discontinue use
immediately. If charging or discharging, discontinue and disconnect.
Continuing to use, charge or discharge a battery that is ballooning or
swelling can result in fire.
Always store the battery at room temperature in a dry area for best
results.
Do not store battery or drone in a car or direct sunlight. If stored in a
hot environment, the battery can be damaged or even catch fire.
Never use any other type of battery charger other than the one supplied
with the drone. Failure to charge the battery with a compatible charger
may cause fire resulting in personal injury and/or property damage.
Never exceed the recommended charge rate.
When a Li-Po battery is discharged below 3.7V, the battery may be
damaged and may no longer accept a charge. The drone will
automatically land and become inactive when the battery reaches this
level, this is to protect the battery.
5of 18
Battery Installation
Ensure the drone is turned off using
the power switch on its underside.
Open the battery cover on the rear
of the drone
Slide the battery into the battery
housing
Connect the power lead from the
battery to the power connector
within the battery housing.
Battery Charging
Remove the battery from the drone, following the reverse of steps 2 –4 above.
Plug the charging cable from the
battery into the socket on the
charger
Plug the supplied power supply into
the charger, and plug into a wall
socket to charge.
The battery will take around 3 hours to fully charge, and will give around 18 –
20 minutes of charge. While charging the led on the charger will be red, and
when fully charged the light will turn green.
6of 18
Installing the Controller Batteries
Unscrew the battery cover and insert 6 x AA Batteries, making sure the correct
polarity is followed, before reattaching the battery cover
Transmitter Diagram
1
Power Switch
2
Indicator
3
Sling Hook
4
Right Stick
5
Left Stick
6
Mobile Device Support
7
Handle
8
Speed Selector
9
Take Off / Landing
10
Pitch Tuning
11
Pan/tilt angle tuning
12
Flying side Trim
13
Take Photo
14
Headless Mode
15
Record Video
16
Forward and Back Trim
7of 18
Installing the Mobile Holder / Antenna
The black antenna on the top of the Transmitter can be swapped with the
mobile phone holder, if you are wanting to view footage live on your phone.
To swap them over, the part fitted can be removed by carefully pulling it
directly upwards, while rocking slightly to unclip it internally. The alternative
piece can then be pushed into position.
Propeller Installation
It is important the correct blades are
placed on the correct motor or the
aircraft will not fly correctly. Each blade is
marked with an A1 or B2 on its underside
to indicate which motor it corresponds to.
They should be placed onto the motor
shaft with the mark on their underside.
B2 propellers should be locked into place
with the silver nuts and the A1 propellers
with the black nuts. Use the small supplied rod threaded through the
nut to ensure the nuts are tight, to prevent the propellers becoming
loose during flight.
B2
B2
A1
A1
Front
8of 18
Installing the legs
The legs should be positioned on the mounting points on the underside of the
drone as per the first image below. They should then be fastened to the drone
using 2 screws per leg (Supplied).
Installing the camera (Optional)
If the camera has been purchased slide it
onto the camera mount on the base of the
drone, sliding from the front until it clicks
into place. Then plug the black lead from
the camera into the port labelled plug on
the underside of the drone.
Removal is the opposite process, but the
safety button must be pressed to release
the camera from the drone before sliding
Installing the Action Camera Mount
Slide the action camera mount onto the
camera mounting point on the underside
of the drone, sliding from the front, until it
clicks into place. The back fixing should be
unscrewed, the camera attached, and then
the fixing used to lock the camera into
position.
9of 18
Preparing for First Flight
1. Make sure both the transmitter and aircraft batteries are sufficiently
charged.
2. Find a suitable place to fly the aircraft, away from people, buildings and
vehicles.
3. Ensure the Gyro and Compass are calibrated before use.
4. Make sure the throttle stick is centred before turning on the transmitter.
Binding of Radio Transmitter & Receiver
1. Place the aircraft on a flat surface and
insert the battery into the aircraft, the
aircraft will start to bleep. Turn it on using
the button on the underside, before
placing back on the level surface, the
lights on the drone will flash
2. Turn on the controller.
3. Pair it to the drone by pulling the
throttle stick down and releasing
4. After a few seconds the drone will
pair and the lights on the drone will
become constant
Gyro Calibration
When first used the gyroscope must be
calibrated. To do this, place the drone on
a level surface, push the left stick to the
top left, and the right stick to the bottom
right. The lights on the drone will flash
while calibration is in process, and will be
constant when calibration is successful
10 of 18
Compass Calibration
Before starting calibration of the Compass, ensure the drone is on a level
surface
Hold the left stick to the bottom left
and the right stick to the top right
until the lights on the drone start to
flash.
With the drone still on the level
surface, turn it slowly clockwise,
turning it in a full 360 degree circle 3
times.
Point the front of the drone to the
ground, and then twist the drone
clockwise, turning it in a full 360
degree circle 3 times.
With the drone horizontal, and the
front facing away from you, flip the
drone in a 360 degree circle 3 times.
Inhaltsverzeichnis
Andere ProFlight Drohne Handbücher
ProFlight
ProFlight TRACER PFBD97 Bedienungsanleitung
ProFlight
ProFlight PFBD301 Bedienungsanleitung
ProFlight
ProFlight PFBD303 Bedienungsanleitung
ProFlight
ProFlight MAVERICK AIR PFBD200 Bedienungsanleitung
ProFlight
ProFlight Challenger Bedienungsanleitung
ProFlight
ProFlight ORBIT PFBD201 Bedienungsanleitung
ProFlight
ProFlight ECHO PFBD77 Bedienungsanleitung
ProFlight
ProFlight PFBD303 Bedienungsanleitung
ProFlight
ProFlight PFBD101 Bedienungsanleitung
ProFlight
ProFlight PFBD302 Bedienungsanleitung
