ProScan PLDED3996A Bedienungsanleitung
PLDED3996A
USER’S MANUAL
39” LED TV
Contents
Introduction
Warning
Caution
Important Information
Attaching or Removing the Stand
Installing Batteries to the Remote Control
Identifying Front and Rear Panel
Connection Suggestion
Main Unit Description
Remote Control
OSD Basic Adjustment
How Do I Clean The TV
Troubleshooting
Specifications
FCC Compliance Statement
1
Introduction
Thank you very much for purchasing your LED TV. It serves as a normal colour TV
and a PC monitor. To enjoy your set fully from the very beginning, read this manual
carefully and keep it handy for future reference.
INSTALLATION
①Locate the receiver in the room where direct light does not strike the screen. Total
darkness or a reflection on the picture screen can cause eyestrain. Soft and indirect
lighting is recommended for comfortable viewing.
②Allow enough space between the receiver and the wall to permit ventilation.
③Avoid excessively warm locations to prevent possible damage to the cabinet or
premature component failure.
④This TV can be connected to AC 100-240V~ 50/60HZ.
⑤Do not install the TV in a location near heat sources such as radiators, air ducts,
direct sunlight, or in closed compartments and closed areas. Do not cover the
ventilation openings when using the TV.
The indicator light will last for about 30 seconds after the power has been turned
off. Wait until the indicator light goes out before repowering the TV.
6
2
Warning
This symbol is intended to alert the user to avoid the risk
of electric shock. This equipment may only be disassembled
by qualified service personnel.
This symbol is intended to alert the user to the presence
of important operation and maintenance instructions in
the literature accompanying the equipment.
CAUTION: TOAVOID THE RISK OF ELECTRIC SHOCK.
DO NOT REMOVE COVER (OR BACK).
NO USER- SERVICEABLE PARTS INSIDE.
REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
Class I structures of equipment should be connected to the grid
power output with a protective earth connection on the socket.
Power plug as a broken appliance，broken installations should
be easy to operate.
3
Caution
Caution
High voltagesare used inthe operation ofthis product.
-Do not open the product's casing. Refer servicing
to qualified service personnel .
Caution
To prevent fire or electrical shock hazard, do not expose
the main unit to rain or moisture，do not place objects
filled with liquids, such as vases, on the apparatus.
Caution
Do not drop or push objectsinto the television cabinet
slots or openings. Never spill anykind ofliquid on the
television receiver.
Caution
Avoid exposingthe main unit to direct sunlight and other
sources of heat. Do not stand the television receiver
directly on other products which give off heat: e. g. video
cassette players and audio amplifiers. Do not block the
ventilation holes in the back cover. Ventilation is essential
to prevent failure of electrical components. Do not squash
the power supply cord under the main unit orother heavy
objects.
4
Caution
Caution
Never stand on, lean on or suddenly push the product
or its stand. You should pay special attention to
children.
Caution
Do not place the main unit on an unstable cart stand,
shelf or table. Serious injury to an individual and
damage to the television may result if it should fall.
Caution
When the product is not used for an extended period
of time, it is advisable to disconnect the AC power
fromtheACoutlet.
Caution
The LED panel used in this product is made of glass and
is therefore breakable. This product must not be dropped
or banged. If the LED Panel breaks be careful of being
injuredbybrokenglass.
5
Television Antenna Connection Protection
Important Information
External Television Antenna Grounding
If an outside antenna or cable system is to be connected to the TV, make sure that the antenna or
cable system is electrically grounded to provide some protection against voltage surges and
static charges. Article 810 of the National Electrical Code, ANSI/NFPSA 70, provides
information with regard to proper grounding of the mast and supporting structure, grounding of
the lead-in wire to an antenna discharge unit, size of the grounding conductors, location of
antenna discharge unit, connection to grounding electrodes, and requirements of the grounding
electrode.
Lightning Protection
For added protection of the TV during a lightning storm or when it is left unattended or unused
for long periods of time, unplug the TV from the wall outlet and disconnect the antenna or cable
system.
Power Lines
Do not locate the antenna near overhead light or power circuits, or where it could fall into such
power lines or circuits.
6
Attacthing or Removing the Stand
1. To attach the base place the display unit flat on a table. Afterwards attach the stand onto
the bottom of the stand. Screw in the 5 screws to secure the stand.
7
2. To remove the stand, remove the 4 screws in the area and the stand will come off.
Installing Batteries to the Remote Control
Please insert two AAA batteries into the remote control. Make sure that you match the (+)
and (-) symbols on the batteries with the (+) and (-) symbols inside the battery compartment.
Afterwards, re-attach the battery cover.
Please note:
�Only use AAA batteries.
�Do not mix newand old batteries. Thismay result in cracking or leakage that may pose a
fire risk or lead to personal injury.
�Inserting the batteries incorrectly may also result in cracking or leakage that may pose a
fire risk or lead to personal injury.
�Dispose the batteries in accordance with local laws and regulations.
�Keep the batteries away from children and pets.
�If the remote control is not used for a long time, remove the batteries.
�Keep the remote control away from moisture, sunlight, and high temperatures.
8
Front View
Rear View Mounting Pattern
Identifying Front and Rear Panel
INDICATOR LIGHT – The light is red when power is plugged in but the TV is not turned on.
The light turns blue when the TV is turned on. Because of the LED in the panel, the TV
might take 10 – 12 seconds to power on.
REMOTE SENSOR – The remote sensor receives all the commands from the remote control.
Mounting Specification : 200mm x 200mm using screw size M6. Length of screw should not
exceed 8mm. Please Note : The 8mm length of screw refers to how deep the screw can go
inside the mounting holes. When you’re buying screws, you should add the original 8mm to
the thickness of your mounting plate in order to get the total screw length.
9
Dieses Handbuch passt für folgende Modelle
2
Inhaltsverzeichnis
Andere ProScan LED-Fernseher Handbücher
ProScan
ProScan PLDED4616-UK Bedienungsanleitung
ProScan
ProScan PLEDV2488A Bedienungsanleitung
ProScan
ProScan PLDED4897A Bedienungsanleitung
ProScan
ProScan PLED2435A Bedienungsanleitung
ProScan
ProScan PLDV321300-E Bedienungsanleitung
ProScan
ProScan PLEDV1947-UK Bedienungsanleitung
ProScan
ProScan PLED2435A-E Bedienungsanleitung
ProScan
ProScan PLDEDV3293-UK Bedienungsanleitung
ProScan
ProScan PLED4242UHD-RK Bedienungsanleitung
ProScan
ProScan PLED2845A-D Bedienungsanleitung
ProScan
ProScan PLED3216A Bedienungsanleitung
ProScan
ProScan PLED1960A-L Bedienungsanleitung
ProScan
ProScan PLDED5068A-S Bedienungsanleitung
ProScan
ProScan PLEDV2488A Bedienungsanleitung
ProScan
ProScan 55LED55SA Bedienungsanleitung
ProScan
ProScan PLEDV3282A Bedienungsanleitung
ProScan
ProScan PLED2243A-F Bedienungsanleitung
ProScan
ProScan PLDV321300-D Bedienungsanleitung
ProScan
ProScan PLDED3273A-B Bedienungsanleitung
ProScan
ProScan PLED1960A Bedienungsanleitung
