- -
4
(3). USE RIGHT TOOL. Don’t force tool or
attachment to do a job for which it was not
designed.
(4). SECURE WORK. Use clamps or a vise
to hold work when practical. It’s safer than
using your hand frees both hands to operate
tool.
(5). MAINTAIN TOOLS IN TOP
CONDITION. Keep tools sharp and clean for
best and safest performance. Follow
instructions for lubricating and changing
accessories.
(6). USE RECOMMENDED
ACCESSORIES. Consult the owner’s
manual for recommended accessories. The
use of improper accessories may cause
hazards.
(7). AVOID ACCIDENTAL STARTING.
Make sure switch is in “OFF” position before
plugging in power cord.
(8). DIRECTIONOF FEED. Feed work into
a blade or cutter against the direction of
rotation of the blade or cutter only.
(9). ADJUST AND POSITION the blade
guide arm before starting the cut.
(10). KEEP BLADE GUIDE ARM TIGHT,
A loose blade guide arm aill affect sawing
accuracy .
(11). MAKE SURE blade speed is set
correctly for material being cut.
(12). CHECK for proper blade size and type.
(13). STOP the machine before putting
material in the vise.
(14). ALWAYS have stock firmly clamped in
vise before starting cut.
(15). GROUNDALL TOOLS. If tool is
equipped with three-prong plug, it should be
plugged into a three-hole electrical receptacle.
If an adapter is used to accommodate
atwoprong receptacle, the adapter lug must be
attached to a known ground. Never removed
the third prong.
C. ADJUSTMENT :
MAKE all adjustments with the power off.
In order to obtain the machine. Precision and
correct ways of adjustment while assembling,
the user should read the detailed instruction in
this manual.
D. WORKING ENVIRONMENT:
(1). KEEP WORK AREA CLEAN.
Cluttered areas and benches invite accidents.
(2). DON’T USE IN DANGEROUS
ENVIRONMENT. Don’t use power tools in
damp or wet locations, or expose them to rain.
Keep work area well-lighted.
(3). KEEP CHILEREN AND VISITIORS
AWAY. All children and visitors should be
kept a safe distance from work area.
(4). DON’T install & use this machine in
explosive, dangerous environment.
E. MAINTENANCE:
(1). DISCONNECT machine from power
source when making repairs.
(2). CHECK DAMAGED PARTS. Before
further use of the tool, a guard or other part
that is damaged should be carefully checked
to ensure that it will operate properly and
perform its intended function check for
alignment of moving parts, binding of moving
parts, breakage of parts, mounting, and any
other conditions that may affect its operation.
A guard or other part that is damaged should
