10
by mode. The network will also timeout after 15 min-
utes and automatically close. But if it didn’t connect
to any network after 15 minutes, the Smoke Alarm
Remote Control will go into Stand Alone mode and
the Green LED will flash twice every 30 seconds.
NOTE: It is recommended to first create the wireless
smoke alarm network. Then use the Push To Test
(PTT) to confirm it is working properly (See wireless
smoke alarm User Guide). And then join this Remote
as an additional device in the wireless network.
NOTE: The 6000THL Remote Control cannot be set as
a Coordinator.
4.3 Smoke Alarm Remote Control Network Setting
Reset network: To clear the wireless network settings
in the Remote Control, open the network by pressing
its button 4 times. Then press and hold the button for
8 seconds. Release the button immediately when the
Red LED flashes rapidly. After the Remote is reset, the
unit will go to Stand Alone mode.
Stand Alone mode to Network Search mode: Press
the 6000THL button twice to change from Stand-Alone
mode to Network Joining mode.
Open a network: When the Remote is in Standby
mode, press the button 4 times to open the wireless
network.
View the number of network devices: Press and re-
lease the Remote Control button when the network is
in open mode to view the number of network devices.
The number of Red LED flashes denote the number of
wireless devices.
Close a network: Press the corresponding button
twice on any interconnected wireless device to close
the network.
