PSR ACT Leitfaden
C
Ca
ab
bl
le
e R
Re
ee
el
l/
/C
Ca
ab
bl
le
e/
/A
An
ng
gl
le
e/
/L
Le
en
ng
gt
th
h
R
Re
ep
pl
la
ac
ce
em
me
en
nt
t I
In
ns
st
tr
ru
uc
ct
ti
io
on
ns
s
Rev 4 6-15-05
Contents (ACT)
Cable Reel Removal Page 3-7
Cable Reel Replacement Page 8
Cable Reel Layout Page 9-10
Cable Reel Angle Adjustments Page 11-12
Cable Reel Radius Adjustments Page 13
Cable Broken repair Page 14-16
Cable Replacement Page 17-23
Cable reel angle pot replacement Page 24-25
Cable reel length pot replacement Page 26-29
Cable Reel replacement Instructions(ACT)
Fully retract the boom and lower it to zero degrees, now turn the power off the system.
Cable Reel replacement Instructions(ACT)
Disconnect the cable that comes from the swivel area of the machine at the
cable disconnect located by the slip ring collector for the cable reel.
Cable Reel replacement Instructions(ACT)
5
Disconnect the wires at the junction box for the A-2-B switch
Note:
For cable reels with two conductor cable connect the red and gray
wires for the A-2-B circuit in the boom tip junction box.
For cable reels with three conductor cable connect the red and
green wires for the A-2-B circuit in the boom tip junction box.
Cable Reel replacement Instructions(ACT)
6
CAUTION: THE CABLE REEL IS UNDER TENSION!!
DO NOT RELEASE THE CABLE AND ALLOW IT TO RETRACT ON ITS OWN.
DAMAGE CAN OCCUR TO THE GEAR ASSEMBLY.
Remove the cable clamp and rubber grommet, save it for later. Hold on to the cable and slowly release
the cable back towards the cable reel by hand to release the tension.
Cable Reel replacement Instructions (ACT)
Remove the four mounting bolts on the cable reel that attach it to the boom
and replace the cable reel with the replacement cable reel. Tighten the four bolts.
Andere PSR Industrieanlagen Handbücher
