Pyle PLCD43BTM Bedienungsanleitung

Contents

www.PyleUSA.com

PRECAUTIONS

Precautions & Warnings

• To reduce the risk of re, electric shock, and interference, do not attempt to repair

this unit by yourself. Refer all service to a qualied technician.

• Some MP3/WMA les may not be playable.

• Keep the volume at a reasonable level to avoid distracted driving.

High volume levels may make it dicult to concentrate on trac and road conditions

while driving.

• If the car has been in direct sunlight for an extended period, you may need to

reduce the temperature inside the car before turning on and using the unit.

• If the battery is disconnected, discharged, or changed, the preset memory of the

unit will be lost and require reprogramming.

• The unit is designed to be installed in a level, horizontal position.

For optimal performance, avoid installing the unit at an angle.

• Never use excessive force when removing or attaching the faceplate.

Do not tightly grip the display and buttons to avoid damage.

Lithium Battery Cell Warnings

• Cell leakage may cause damage to the remote control

• Do not throw cells into as this may cause an explosion.

• Keep battery cells out of reach of children.

Drives and Connections

Never place any foreign objects into the openings of the car radio (disc compartment,

USB jack, AUX IN, connection). Otherwise you might damage the slots and connections.

How to Handle Discs

• Handle a disc by its edges. Do not touch the playing side.

• Before inserting a disc, wipe the disc outward from the disc center

with a clean, soft, dry and lint-free cloth. Do not use solvents or

thinners such a petrol/benzene or cleaners.

• After removing a disc from the disc slot, place the disc in a sleeve

or case to keep it clean and prevent scratches.

• Do not stick paper or tape on the disc surface. If there is glue

(or adhesive) on the disc surface, remove it before using the disc.

Others Warnings

Do not switch on the car radio for long periods of time when the motor is switched

o. This could cause the car battery to discharge and the vehicle can no longer be

started.

INSTALLATION

Installation Procedures

First complete the electrical connections and then check for correctness.

Installation Opening

This unit can be installed in any dashboard Having

an opening as shown the right gure.

Important:

Remove the transport CD deck screws before use.

To Install the Car Radio

Be sure you test all connections rst, and then follow these steps to install this unit.

1. Make sure the ignition is turned o, and then disconnect the cable from the

vehicle battery’s negative (-) terminal.

2. Disconnect the wire harness and the antenna.

3. Lift the left or right top corner of the plastic outer trim ring then pull it out to

remove it.

4. Insert the two bracket keys into the left and right side of the chassis, as shown the

below gure to separate the chassis from the housing.

www.PyleUSA.com

182 mm

53 mm

Bracket key

Plastic outer trim ring

Bracket key

www.PyleUSA.com

5. Insert mounting sleeve into the dashboard and bend the mounting tabs out with

a screwdriver. Make sure that the lock lever is ush with the mounting sleeve and

is not projecting beyond.

6. Insert car radio into the mounting sleeve.

7. Use a metal strap to secure the rear part of the chassis using the hardware indicated.

8. Make wiring connections, as illustrated in the “Wiring Diagram.”

9. Install the plastic outer trim ring.

- Only use speakers with 4 ohms impedance.

- Do not attach the control panel to the chassis before wiring is complete.

- The maximum current of the auto antenna is 200mA.

Wiring Connections

INSTALLATION

DIAGRAM

SPRING WASHER

PLAIN WASHER

TAPPING SCREW

HEX NUT

DASH BOARD

CONSOLE

MOUNTING SLEEVE

HEX BOLT

ACC + (Red)

GND - (Black)

ANT + (Blue)

Power B+ (Yellow)

Green

Purple Rear Right

Speaker

Front Right

Speaker

Rear Left

Speaker

Front Left

Speaker

Purple/Black

Green/Black

White

White/Black

Gray

Gray/Black

WIRING DIAGRAM

Radio Antenna Socket

White: Front Left CH RCA Audio Output

Red: Front Right CH RCA Audio Output

White: Rear Left CH RCA Audio Output

Red: Rear Right CH RCA Audio Output

FUSE 15A

www.PyleUSA.com

Removal of the Main Unit

1. Remove the metal strap from the main unit.

2. Remove the plastic trim out from the main unit.

3. Insert a bracket key into the left and right side of the main unit and draw the unit

out of the mounting sleeve.

CONTROL PANEL BUTTON LOCATIONS

1. (power)/MODE (source) button

2. SEL (select/menu) button and VOL (volume) knob

3. BAND (band) button, button

4. AMS (automatic store / preset station scan, automatic music search) button

5. (pause/play), Preset station1 button

6. INT (intro), Preset station 2 button

7. RPT (repeat), Preset station 3 button

8. RDM (random), Preset station 4 button

9. -10 (previous 10 tracks), Preset station 5 button

10. +10 (next 10 tracks), Preset station 6 button

11. CLK (clock setting) button, button

12. (tune down, seek down, track down, fast reverse) button

13. (tune up, seek up, track up, fast forward) button

356 7

8 9

16 15

CLK

1 14

RESET

www.PyleUSA.com

14. MUTE button

15. (eject) button

16. Disc slot

17. IR remote control sensor

18. LCD Display

19. EQ (Equalizer Preset) Button

20. USB port

21. MIC hole (built-in Microphone)

22. AUX IN (auxiliary input) jack

23. (Release) button

24. RESET button

GENERAL OPERATION

Turn Unit ON/OFF

• Press the power /MODE button on the front panel to turn ON the unit, press and

hold it again to turn OFF the unit.

• Press the power button on the remote control to turn the unit ON or OFF.

Adjust Volume (VOL)

Rotate the VOL knob on the front panel or press the VOL+ /VOL- button on the

remote control to increase or decrease the volume level.

Adjust Menu Options (SEL)

• Press the SEL button on the front panel or on the remote control repeatedly to

cycle through the following adjustable audio functions: BASS, TREBLE, BALANCE,

FADER, EQ OFF/ROCK/POP/CLASS/FLAT, LOUD ON/OFF, DX/LOC, STEREO/MONO

and VOLUME.

• Rotate the VOL knob on the front panel or press the VOL+ /VOL- button on

the remote control to adjust the selected item.

- BASS/TREBLE: -7, -6, ~, -1, 0, +1, ~, +6, +7

- BALANCE: L10, L09, ~, L1, R=L, R1, ~, R09, R10

- FADER: R10, R09, ~, R1, R=F, F1, ~, F09, F10

- EQ (Equalizer) Setting: OFF, ROCK, POP, CLASSIC, FLAT

- Loudness: LOUD ON/OFF

- DX/LOCAL: Enables or disables the local broadcast mode (LOCAL).

- Stereo/Mono: Switches between MONO and STEREO reception mode for radio

frequencies.

- Volume level: 0, 1, ~, 40

www.PyleUSA.com

• Press and hold the SEL button on the front panel or press the SEL/ENTER button

on the remote control to access these additional functions: VOL (LAS/ADJ), AREA

EU/US, CLOCK 12/24, BEEP ON/OFF.

- VOL (LAS/ADJ): This option allows you to preset a volume level as the power-on

memory volume level.

- VOL LAST: In this mode, the unit switches on at the actual volume it had when it

was last switched o.

- VOL ADJ: In this mode, the unit power on at the actual volume that you preseted

a constant switch-on volume level.

Press the SEL button to enter the constant switch-on volume adjusting mode

and the “A-VOL XX”will be shown on the LCD display.

Then you can adjust a constant switch-on volume level by rotating the VOL knob.

- AREA EU/US: This car radio is equipped the Europe / USA frequency.

Rotate the volume knob to switch between USA and Europe frequency.

The system will change the frequency setting in about 3 seconds.

- CLOCK 12/ 24: This unit is equipped with two types of clock display formats,

12 and 24 hours.

Rotate the volume knob to choose 12 hours format or 24 hours format.

- BEEP ON/OFF: Enables or disables the “BEEP” signal to conrm use.

• Rotate the VOL knob on the front panel or press the VOL+ /VOL- button on

the remote control to adjust the selected item.

Set the Clock (CLK)

1. To display clock time, press the CLK button.

2. To set clock time, press and hold the CLK button and the hour will ash.

3. Press the or button on the front panel or on the remote control to adjust

the hour.

4. Press the CLK button and the minutes will ash.

5. Press the or button on the front panel or on the remote control to adjust

the minute.

6. Finally press the CLK button to conrm the time adjustments.

Change the Source (MODE)

Press the MODE button to switch between RADIO, BT (Bluetooth), DISC (with a

CD/MP3 disc inside the disc slot), USB (with USB device inserted) and AUX -IN

(auxiliary input) modes.

www.PyleUSA.com

Mute ON/OFF

In power on mode, briey press the MUTE button to toggle mute on or o.

The muted state will be also released when the volume knob is used.

Loudness ON/OFF

Press the LOUD button on the remote control to turn on the loudness to reinforce

the output of bass frequencies, press again to turn it o.

Preset Equalizer (EQ)

Press the EQ button on the front panel or on the remote control to toggle between

EQ OFF, ROCK, POP, CLASS, FLAT.

Release the detachable front panel

Press the (Release) button to detach the detachable front panel, then the front

panel can be removed from the chassis.

USB port

The USB port of this car radio is designed for media playback from ash memory

devices and charging for iPhone/andriod mobile phone. The charging current

consumption is 1 ampere.

Built-in Microphone

To receive your voice when you calling by using this Bluetooth hands-free system.

Aux input connector

The 3.5mm auxiliary input stereo connection is designed for devices with 3.5mm

line-out or headphone output.

Reset System (RESET)

The RESET button is used to reset all parameters to factory default settings.

This function may be used when the LCD does not display normally or sound is

distorted, or when any of the controls are disabled. Press the button to release

the front panel and remove it, then use a thin object with a pointed end to depress

the RESET button.

www.PyleUSA.com

RADIO OPERATION

Switch Between USA area and Europe area Frequency

In radio mode, press and hold the VOL/SEL button to enter switch state of the EU

(USA) and EU (Europe) frequency, then rotate it to switch between US (USA) and EU

(Europe) frequency. The system will change the frequency setting in about 3 seconds.

Change Bands (BAND)

Press the BAND button to switch between the FM1, FM2, FM3, AM1 and AM2 bands.

Each band stores up to six preset stations.

Manual Tuning ( / )

Press and hold the or button on the front panel or on the remote control to

enter manual tuning mode. In manual tuning mode, press the or button to

move the radio frequency number up or down one step.

Auto Seek Tuning ( / )

In standby mode or while not in manual tuning mode, quickly press the or

button to move to the next/previous available station automatically.

To Store/Recall Preset Stations

The radio can be stored 6 preset stations for each band (FM1, FM2, FM3, AM1 and

AM2) for a total of 30 preset stations.

To memorize a station:

• Turn the radio on and select the desired band and station.

• Select a station by or button.

• Press and hold the desired preset button (numbered 1-6 on the face of the radio)

for more than 2 seconds to save the station to that preset number.

To recall a preset station:

• Select the desired band.

• Briey press a preset button (numbered 1-6) to recall the corresponding preset

station.

Andere Handbücher für PLCD43BTM

Inhaltsverzeichnis

Andere Pyle Stereo-Receiver Handbücher

Pyle

Pyle PT380AU Bedienungsanleitung

Pyle

Pyle PT380AU Bedienungsanleitung

Pyle

Pyle PT590AU Bedienungsanleitung

Pyle

Pyle PT560AU Bedienungsanleitung

Pyle

Pyle PVTA90 Bedienungsanleitung

Pyle

Pyle PLMR15BW Bedienungsanleitung

Pyle

Pyle PT390BTU Bedienungsanleitung

Pyle

Pyle PL7ANDIN Bedienungsanleitung

Pyle

Pyle PT270AIU Bedienungsanleitung

Pyle

Pyle PLMP3C1 Bedienungsanleitung

Pyle

Pyle PLML50FB Bedienungsanleitung

Pyle

Pyle pldnv66b Bedienungsanleitung

Pyle

Pyle PT390BTU Bedienungsanleitung

Pyle

Pyle PT390AU Bedienungsanleitung

Pyle

Pyle PVTA20 Bedienungsanleitung

Pyle

Pyle PVTA80 Bedienungsanleitung

Beliebte Stereo-Receiver Handbücher anderer Marken

Marantz

Marantz CINEMA 70S Bedienungsanleitung

Kenwood

Kenwood KMDX92 Bedienungsanleitung

Yamaha

Yamaha RX-830 Bedienungsanleitung

Pioneer

Pioneer AVH-Z7250BT Bedienungsanleitung

Yamaha

Yamaha RX-750 Bedienungsanleitung

Denon

Denon AVR-1311 Bedienungsanleitung

Denon

Denon AVR-S760H Bedienungsanleitung

Denon

Denon AVR-X7200W Bedienungsanleitung

Pioneer

Pioneer SC-LX904 Handbuch

Sony

Sony XAV-1500 Bedienungsanleitung

Radio Shack

Radio Shack DX-399 Bedienungsanleitung

Sony

Sony STR-DE535 - Fm Stereo/fm-am Receiver Bedienungsanleitung

Pioneer

Pioneer SX-1000TA Bedienungsanleitung

Yamaha

Yamaha MusicCast TSR-5B3D Bedienungsanleitung

Sony

Sony STR-DE335 - Fm Stereo/fm-am Receiver Bedienungsanleitung

Sony

Sony STR-DG500 - Multi Channel Av Receiver Bedienungsanleitung

Panasonic

Panasonic AJSD955B - DVCPRO50 STUDIO DECK Bedienungsanleitung

Pioneer

Pioneer SX-838 Bedienungsanleitung