www.PyleUSA.com
3
• Clean the unit with a damp cloth only. Do not use solvents or abrasive
cleaners. Never pour liquid on or into the unit.
• Do not install near any heat sources such as radiators, heat registers, stoves,
or other apparatuses ( including ampliers) that produce heat.
• Do not defeat the safety purpose of the polarized or grounding–type plug.
A polarized plug has two blades with one wider than the other. A grounding
plug has two blades and round grounding prong. The wide blade or third
prong is provided for your safety. If the provided plug does not t your outlet,
consult an electrician for the placement of the obsolete outlet.
• Route the power cord and other cables so that they are not likely to be
walked on, tripped over, or stressed. Pay particular attention to the condition
of the cords and cables at the plugs, and the point where the Power Supply
Conditioners. To prevent risk of re or injury, damaged cords and cables
should be replaced immediately.
• Unplug the unit during lightning storms or when unused for long periods of
time
• When wiring this unit and all other equipment used in connection to this unit
make sure that all of your equipment is turned OFF.
• Once installation and wiring is complete power on all your equipment with
the volume and level controls DOWN. Once all the equipment is ON slowly
raise the volume or level controls to their proper positions.
• Before placing, installing, rigging, or suspending any product, inspect all
hardware, suspension, cabinets, brackets, and associated equipment of
damage. Any missing corroded, deformed, or non- load rated component
could signicantly reduce the strength of the installation, placement or array.
