Qian QEI-1000-01 Bedienungsanleitung
BATTERY BACKUP & SURGE PROTECTOR
BATERÍA DE RESPALDO Y PROTECTOR CONTRA SOBRETENSIONES
MOD. QEI-1000-01
Please read carefully before using your equipment
and save it for future reference.
Por favor lea cuidadosamente antes de usar su equipo
y guárdelo para uso de futuras consultas.
USER MANUAL / MANUAL DE USUARIO
2
These terms shall be governed and construed under laws of
the jurisdiction in which the product was purchased, if any
term here is held to be invalid or unenforceable, the such
term (in so far as it is invalid or unenforceable) shall be given
no effect and deemed to be excluded without invalidating an
of the remaining terms. Qian reserves the right to amend any
term at any time without notice.
WARRANTY AND PRODUCT INFORMATION
P
R
O
D
U
C
T
I
N
F
O
R
M
A
T
I
O
N
I
N
F
O
R
M
A
C
I
Ó
N
D
E
L
P
R
O
D
U
C
T
O
3
ATTENTION
CAUTION! To prevent the risk of re or electric shock, install
in a temperature and humidity controlled indoor area free
of conductive contaminants. (See the specications for the
acceptable temperature and humidity range.)
CAUTION! To reduce the risk of overheating the UPS, do
not cover the UPS’ cooling vents and avoid exposing the
unit to direct sunlight or installing the unit near heat emitting
appliances such as space heaters or furnaces.
CAUTION! Do not attach non-computer-related items, such as
medical equipment, life-support equipment, microwave ovens,
or vacuum cleaners to UPS.
CAUTION! Do not plug the UPS input into its own output.
CAUTION! Do not allow liquids or any foreign object to enter
the UPS. Do not place beverages or any other liquid-containing
vessels on or near the unit.
CAUTION! In the event of an emergency, press the OFF button
and disconnect the power cord from the AC power supply to
properly disable the UPS.
CAUTION! Do not attach a power strip or surge suppressor to
the UPS.
CAUTION! If the UPS is with metal chassis, for safety purpose,
grounding is a must during UPS installation in order to reduce
leakage current below 3.5mA.
Attention! Hazardous through electric shock.Also with disconnection
of this unit from the mains, hazardous voltage still may be
accessible through supply from battery. The battery supply
should be therefore disconnected in the plus and minus pole
at the quick connectors of the battery when maintenance or
service work inside the UPS is necessary.
4
CAUTION! Servicing of batteries should be performed or
supervised by personnel knowledgeable of batteries and the
required precautions. Keep unauthorized personnel away from
batteries.
CAUTION! When replacing the batteries, use the same number
and type of batteries. CAUTION! Internal battery voltage is
12Vdc. Sealed, lead-acid, 6-cell battery.
CAUTION! Do not dispose of batteries in a re. The battery
may explode. Do not open or mutilate the battery or batteries.
Released electrolyte is harmful to the skin and eyes.
CAUTION! Unplug the UPS prior to cleaning and do not use
liquid or spray detergent. CAUTION! A battery can present a
risk of electric shock and high short circuit current. The following
precaution should be observed before replacing batteries:
• Remove watches, rings, or other metal objects.
• Use tools with insulated handles.
• Wear rubber gloves and boots.
• Do not lay tools or metal parts on top of batteries.
• Disconnect charging source prior to connecting or disconnecting
batteries terminal.
5
PRODUCT SPECIFICATIONS
Model QEI-1000-01
UPS Capacity 1000VA 600W
Input Voltage America 110 / 120 VAC
Europe 220 / 230 VAC
Input Voltage
Range
America 81-134VAC / 89-145VAC
Europe 140-290 VAC / 140-300 VAC
Frequency
Range
50Hz/60Hz (Auto sensing), 50Hz/60Hz ± 1Hz (Bat
mode)
Output Voltage America 110/115/120 VAC
Europe 220/230 VAC
AC Voltage
Regulation
± 10% (Bat mode)
Transfer time Typical 2-6 ms
Waveform Simulated Sine Wave (Bat mode)
Battery Type Lead-acid battery, 12V/7Ah*2
Dimensions D: 14.56 x W: 5.31 x H: 6.49 inches
Recharge Time 4-6 hours recover to 90% capacity,
Full protection Overload, discharge, overcharge, short circuit over-
voltage, under-voltage and over-heating protection
LED Display AC Mode: Green Light
Battery mode: Yellow Light
Fault: Red Light
Battery Alarm
Modes
Battery mode: Sounds every 10s
Low battery: Sounds every 1s
Overload: Sounds every 0.5s
Battery Replacement Alarm: Sounds every 2s
Fault: Continuosly sound
Weight 18.51 lb
Humidity 0 - 90% Relative Humidity 32-104°F (Non-
condensing)
Noise Level Less than 40db
Operating
System
Supports Win 2000, 2003, XP, Vista, Vista 2008, 7,
8. Linux, Unix and M. OS
6
CONTENT
• 1 UPS
• 1 User manual
• 1 Warranty policy
7
PRODUCT OVERVIEW
1.- UPS status LED
AC mode: green lighting
Battery mode: yellow ashing
Alarm mode: red lighting
2.- Switch
AmericaEurope
1.- Output receptacles
2.- AC input
3.- AC input breaker
8
INSTALLATION & INITIAL STARTUP
NOTE: Before installation, please inspect the unit. Be sure
that nothing inside the package is damaged.
Placement & Storage Conditions
Install the UPS in a protected area that is free of excessive
dust and has adequate air ow. Please place the UPS away
from other units at least 20 cm to avoid interference. Do
NOT operate the UPS where the temperature and humidity
is outside the specic limits. (Please check the specs for the
limitations.)
Connect to Utility and Charging
Plug in the AC input cord to the wall outlet. For the best
results, suggest to charge the battery at least 6 hours before
initial use. The unit charges its battery while connecting to
the utility.
Connect the Loads
Plug in the loads to output receptacles on the rear panel of
the UPS. Simply turn on the switch of UPS unit, then devices
connected to the UPS will be protected by UPS unit.
9
CAUTION: NEVER connect a laser printer or scanner to
the UPS unit. This may cause the damage of the unit.
Connect USB cable (Optional)
Connect the USB cable to UPS and Computer, insert CD
to computer and follow the wizard to install the monitoring
software properly.
Connect Modem/Phone for Surge Protection (Optional)
Connect a single modem/phone line into surge-protected
“IN” outlet on the back panel of the UPS unit. Connect from
“OUT” outlet to the computer/Modem with phone line cable.
Turn On/Off the Unit
Turn on the UPS unit by pressing the switch. Turn off the
UPS unit by pressing again the switch.
10
P
R
O
D
U
C
T
I
N
F
O
R
M
A
T
I
O
N
I
N
F
O
R
M
A
C
I
Ó
N
D
E
L
P
R
O
D
U
C
T
O
Estos términos se regirán e interpretarán de acuerdo con
las leyes de la jurisdicción en la que se compró el producto,
si alguno de los términos en este documento se considera
inválido o inaplicable, dicho término (en la medida en que
sea inválido o inaplicable) no tendrá efecto y se considerará
excluido sin invalidar ninguno de los términos restantes.
Qian se reserva el derecho de modicar cualquier término en
cualquier momento sin previo aviso.
GARANTÍA E INFORMACIÓN DEL PRODUCTO
Inhaltsverzeichnis
Sprachen:
Beliebte Überspannungsschutz Handbücher anderer Marken
OBO Bettermann
OBO Bettermann ÜSM-20-230I1PE65 Bedienungsanleitung
Minuteman
Minuteman MMS7120RCT Bedienungsanleitung
Leviton
Leviton 52412-DS3 Bedienungsanleitung
Savio
Savio LZ-07 Bedienungsanleitung
Siemens
Siemens HNM3M120 Bedienungsanleitung
Mitsubishi Electric
Mitsubishi Electric LITOL LTM-125RF Bedienungsanleitung