Qtx SW-2 Bedienungsanleitung

SW-2

SNOW MACHINE

Item ref: 160.565UK

User Manual

160.565UK User Manual

Caution: Please read this manual carefully before operating

Damage caused by misuse is not covered by the warranty

Introduction

Thank you for choosing the SW-2 DMX snow machine for stage and events special effects. This product is

designed to produce high volume snow output on demand for festive and themed events. Please read these

instructions in full to gain the best results from this item and avoid damage to the unit through misuse.

Unpacking

Your SW-2 should reach you in good condition and should be supplied with IEC mains lead(s) and a wired

remote control.

If there are any signs of damage or items missing from the packaging, contact your dealer immediately.

Warning

To prevent risk of fire or electric shock, do not expose electrical parts to rain or moisture.

If liquids are spilled on areas other than the fluid tank or nozzle, disconnect the mains, allow the SW-2 to dry

out and have it checked by qualified personnel before further use.

Avoid any impact, dropping or extreme pressure to the housing.

No user serviceable parts inside - do not open the case.

Allow the SW-2 to acclimatize to room temperature before operating.

Refer all servicing to qualified service personnel.

Placement

The SW-2 has a built-in snow fluid container and should be operated in an upright position.

If free-standing, ensure that the SW-2 is positioned on a stable, non-slip surface.

If mounted at height, use the integral mounting bracket and attach a safety cable for added security.

Safety

Check for correct mains voltage and condition of IEC lead before connecting to power outlet

Check the condition of the remote lead and ensure that it is not trapped

This unit must be earthed

This unit produces a snow effect using foam, which may cause a slip hazard on some floor surfaces

Cleaning

Use a soft dry or slightly damp to clean the casing

Do not use strong solvents for cleaning the unit

Clean the foam mechanism periodically by operating with distilled water instead of snow fluid

160.565UK User Manual

Rear Panel

Setting up

The SW-2 requires snow fluid, which forms small foam drops to create the snow effect.

It is recommended to use qtx snow fluid for best results (160.578, 160.579)

A chart for recommended fluids is included further along in this document.

Unscrew the top cap of the fluid tank (removable) and fill with the selected snow fluid

The SW-2 can accommodate a complete 5 litre snow fluid refill if preferred

Replace the cap and close securely, ensuring the pipe is fed down to the bottom of the bottle so that a

consistent flow of fluid is supplied to the machine

Connect the remote control to the 5-pin DIN connector on the rear panel (6)

Connect the IEC mains lead supplied to the rear mains inlet (5)

Remote control operation

DIP switches for DMX address setting

DMX input (3-pin XLRM)

DMX output (3-pin XLRF)

Power on/off rocker switch

Mains inlet (IEC male) and fuse holder

Remote control connection (5-pin DIN)

Fluid level indicator

Snow output control –adjusts the amount of fluid delivered by the pump

Snow effect indicator –illuminates when effect is activated

10.

Power indicator –illuminates when mains power is switched on

11.

Snow effect on/off rocker switch –switches the fan on or off

160.565UK User Manual

Make sure that the remote control rocker switch (11) is set to the “off” position at startup

Switch the mains power on (4) at the rear of the unit And the power indicator (10) will light

Set the output control (8) to the lowest setting and switch the rocker switch on

The snow effect indicator (9) will light to show that the fan is active

Adjust the output control to the required density of snow pumped into the nozzle when active

Switch the rocker switch off to stop the fan and thus stop the effect

DMX operation

For DMX operation, a single channel controls both the fan and snow output pump.

Connect DMX input from a controller or prior device to the XLRM connector (2) on the rear panel

Connect further DMX devices from the XLRM connector (3) on the rear panel

Set the DMX address (single channel) using the DIP switches (1) in binary format as shown below



DMX control values operate the snow machine as follows.

Value

Fan

Fluid pump

0 - 5

Fan off

and no snow output

6 - 255

Fan on

and snow output

When in use for long periods, periodically check the fluid level indicator and refill if necessary.

Check that the foam produced does not cause a slip hazard on the floor surface and clean if necessary.

Switch of mains power when not in use. Disconnect from mains before moving or storage.

Specifications

Power supply

220-240Vac, 50/60Hz (IEC)

Tank capacity

5 litre

Power

1200W

Volume per minute

50m³

Remote control

Wired remote (on/off & output volume)

DMX channels

1 channel (fan on/off & output 1 - 100%)

Dimensions

320 x 300 x 525mm

Weight

7.6kg

DMX

Address

DIP Switches

128

256

…

410

160.565UK User Manual

Troubleshooting

No light on mains switch

Check mains voltage is correct and socket is switched on

Check IEC lead is OK and connected properly

Check mains fuse in IEC connector and fuse in plug top

If fuse blowing repeatedly, refer to qualified service personnel

No power light on remote

Check remote control is connected properly

No snow output when

using remote control

Check snow fluid level

Check that rocker switch is on and output control is turned up

Check that nozzle cloth is not blocked and clean with water if necessary

No snow output when

using DMX control

Check that DMX lead is connected properly and correct start address is set

Ensure that a value between 6 and 255 is being transmitted on the channel

Disposal: The “Crossed Wheelie Bin” symbol on the product means that the product is classed as Electrical or

Electronic equipment and should not be disposed with other household or commercial waste at the end of its useful

life. The goods must be disposed of according to your local council guidelines

Errors and omissions excepted.

160.565UK User Manual

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere Qtx DJ-Equipment Handbücher

Qtx

Qtx TinyMover 150.461UK Bedienungsanleitung

Qtx

Qtx Mesmerizer Bedienungsanleitung

Qtx

Qtx MHS-60 Bedienungsanleitung

Qtx

Qtx QTFX-B3 Bedienungsanleitung

Qtx

Qtx PAR100W Bedienungsanleitung

Qtx

Qtx 151.545UK Bedienungsanleitung

Qtx

Qtx CORTINA Bedienungsanleitung

Qtx

Qtx SURGE Bedienungsanleitung

Qtx

Qtx MHS-100G Bedienungsanleitung

Qtx

Qtx QTFX-B4 Bedienungsanleitung

Qtx

Qtx Gobo Fireflash Bedienungsanleitung

Qtx

Qtx 160.494UK Bedienungsanleitung

Qtx

Qtx Stage Bar Bedienungsanleitung

Qtx

Qtx AQUA RIPPLE Bedienungsanleitung

Qtx

Qtx Azure Bedienungsanleitung

Qtx

Qtx QMX4.1 Bedienungsanleitung

Qtx

Qtx Tri-PAR Bedienungsanleitung

Qtx

Qtx SW-3LED Bedienungsanleitung

Qtx

Qtx Derby9 Bedienungsanleitung

Qtx

Qtx MHS-40K Bedienungsanleitung

Qtx

Qtx PAR-T Bar Bedienungsanleitung

Qtx

Qtx WINDMILL 150.550UK Bedienungsanleitung

Qtx

Qtx B12P Bedienungsanleitung

Qtx

Qtx Pentaflash Bedienungsanleitung

Beliebte DJ-Equipment Handbücher anderer Marken

ALPHA LITE

ALPHA LITE ALPHA 1500 Betriebsanleitung

Chauvet

Chauvet OVATION E-930VW Bedienungsanleitung

Zumtobel

Zumtobel APHRODITE Home Bedienungsanleitung

Snow Masters

Snow Masters Zig Oscillator Bedienungsanleitung

EuroLite

EuroLite 50530554 Bedienungsanleitung

Beamz

Beamz BUV243 Bedienungsanleitung

thomann

thomann Stairville DJ Lase 40-G MK-III Bedienungsanleitung

Eagletone

Eagletone 6 Eyes Flower Bedienungsanleitung

EuroLite

EuroLite FLD-1508 Bedienungsanleitung

Technical Pro

Technical Pro LG8xSEA Bedienungsanleitung

JB Systems

JB Systems Lounge Laser DMX Bedienungsanleitung

Lightmaxx

Lightmaxx Vega Halo 90 Bedienungsanleitung

Elation

Elation FUZE WASH Z350 Bedienungsanleitung

Maverick

Maverick MK3 WASH Bedienungsanleitung

Infinity

Infinity TF-260C7 Fresnel Bedienungsanleitung

Chauvet

Chauvet EVE E-50Z Bedienungsanleitung

Eliminator Lighting

Eliminator Lighting E 138 Bedienungsanleitung

EuroLite

EuroLite Mini Multicolor LED Flashing Light SC Bedienungsanleitung