Quality Heating QH16-18A Bedienungsanleitung
INFRARED HEATER
READ AND SAVE THESE INSTRUCTIONS
Read all instructions carefully before setting up and operating this unit.
This manual is designed to provide you with important information needed to setup,
operate, maintain for your radiant heaters.
Failure to follow these instructions may damage and/or impair its operation and void
the warranty.
Health and fresh!
1
1. SAFETY PRECAUTIONS
This appliance is not intended for use by persons (including
children) with reduced physical sensory or mental capabilities,
or lack of experience and knowledge, unless they have been
given supervision or instruction concerning use of the
appliance by a person responsible for their safety.
Children should be supervised to ensure that they do not play
with the appliance.
WARNING: In order to avoid overheating, do not cover the
heater.
1. If the supply cord is damaged, it must be replaced by the
manufacturer, its service agent or similarly qualified persons in order
to avoid a hazard.
2. The heater must not be located immediately below a socket outlet.
3. Do not use the same socket together with other appliances, in
case of current overload. Make sure the plug and socket good
contact.
4. Please pull plugs out when power off. Do not pull wires by hands.
5. Please stop power immediately once heaters failure or wires are
broken. Users can not repair heaters by themselves. Please contact
authorized servicer for maintenance if heaters failure.
6. Radiant heater cannot be placed directly below the power outlet.
7. Radiant heater surface temperature is high, must be installed
higher than 2.2 meters above ground.
8. Radiant heater surface cannot be covered and cannot hang
objects on equipment.
9. The distance between back of radiant heater and roof should be
larger than 150mm，cannot place objects within 1000mm distance in
front of radiant heater, the side should be kept at least 200mm away
from the surrounding space.
10. Must cut off power and wait till equipment surface cool before
cleaning, flushed by water is prohibited.
Health and fresh!
2
11. Users cannot repair the radiant heater，if equipment failure and
need maintenance, please contact authorized servicer.
12. Do not install and use radiant heaters on areas occur with
flammable，explosive，easy to shock.
13. Please do not insert any metal or foreign objects to inside of
radiant heater, to avoid accident or personal injury.
14. Radiant heater panel surface with high temperature, the surface
temperature can reach to >250℃~380℃，touch is forbidden，beware
of scalding accident.
15. Do not splash water into radiant heater to avoid accidents.
2. FOREWORD
Thank you for your trust and support in choosing the Infrared Heater, please read the
instructions carefully before operating product.
3. INFRARED HEATER THEORY
Far-infrared radiant heaters are produced by unique design and manufacturing
technique.
Using a specially coated aluminum panel, the heat generated by the heating element
is transferred radiantly to people and objects with maximum efficiency.
The heat radiated from the panel surface, is absorbed by people, walls, floors, and
furniture etc., like sunshine.
Infrared heating will not lead to air movement, making the air cleaner, as dust and
particles are not disturbed and circulated. Traditional convection heating relies on air
movement to distribute the heat.
The air remains less humid, and gives you a sense of fresh, comfortable,
warmth-similar to the warmth felt from the sun.
4. PERFORMANCE FEATURES
Comfortable:
No wind, light or odor will be caused during the running of this product, so the indoor
air is clean without floating dust.
Energy-saving:
High heat generation and excellent heat distribution, use less energy than traditional
heating methods.
Reliable:
The indoor temperature can be adjusted freely, free of the limitation of heating
season.
Health and fresh!
3
Physical therapy:
The heat radiant can change body microcirculation, cell organization under skin
producing resonance, clearing the barrier of microcirculation, adjusting and balancing
nervous system, promoting metabolism, increasing body physical power. It is very
good for people's health.
Far-infrared radiant heaters are produced by unique design and manufacturing
technique.
Using a specially coated aluminum panel, the heat generated by the heating element
is transferred radiantly to people and objects with maximum efficiency.
The heat radiated from the panel surface, is absorbed by people, walls, floors, and
furniture et cetera, like sunshine.
Infrared heating will not lead to air movement, making the air cleaner, as dust and
particles are not disturbed and circulated. Traditional convection heating relies on air
movement to distribute the heat.
The air remains less humid, and gives you a sense of fresh, comfortable,
warmth-similar to the warmth felt from the sun.
5. WORKING CONDITION
Ambient temperature: -30℃ ~ +40℃
Rated Voltage: 220-240V~
Rated frequency: 50Hz/60Hz
Relative humidity: less than 95%
6. INSTALLATION REQUIREMENTS
1. Qualified installer:
The installation must be carried out by trained personnel.
2. Installation conditions:
(1) Supply voltage fluctuation range should be within ± 10%,If not, please revise
before installation.
(2) If there is a serious security risk in users' electricity environment, the installation
should be refused, until eliminate the security risks.
(3) Electricity lines should be equipped with earth leakage protection devices and
master switch.
(4) Ground wire should be connected to the grounding device on the building, if not,
please consult to professional installer, please do not put ground wire to gas pipe,
water pipe, lightning rod or telephone grounding wire.
Model No.
Power(W)
Current(A)
Voltage(V)
Lighting
power(W)
JH-NR16-18A
1650
7.5
220-240
N/A
JH-NR20-19A
2000
9.1
220-240
12W
Health and fresh!
4
7. SPARE PARTS
Expansion
screw fixing
plate
2pc
Stainless steel
expansion bolt
2pc
8. INSTALLATION INSTRUCTION(JH-NR16-18A)
Specifications
Installation decomposition
Health and fresh!
5
Step 1:Select the position of the heater on the ceiling, and remove the two aluminum
gussets in the installation position and the two aluminum gussets in the side.
Step 2: Right above the installation position of the heater, make a 10mm diameter bolt
hole with a percussion drill, insert the stainless steel expansion bolt, and fix the
"expansion screw fixing plate". The hole spacing between the two "expansion screw
fixing plates" is 355mm.
Step 3: Install the wire rope in the wire groove of regulator holder.
Step 4: Ensure the surface of the heater is flush with the aluminum gusset by
adjusting the length of the wire rope.
Health and fresh!
6
Step 5: Connect the lead wires of the heater to the corresponding power cable.
(Note: Make sure the product is completely grounded!)
Step 6: Reinstall the removed aluminum gussets.
Health and fresh!
7
8. INSTALLATION INSTRUCTION
Specifications
Installation decomposition
Health and fresh!
8
Step 1: Select the position for installing the heater on the ceiling, and remove the 3
aluminum gussets in the installation position and the 3 aluminum gussets in the side.
Step 2: Right above the installation position of the heater, Make a 10mm diameter
bolt hole with a percussion drill , insert the stainless steel expansion bolt,
and fix the "expansion screw fixing plate",The hole spacing between
the two "expansion screw fixing plates" is 600mm.
Step 3: Install the wire rope in the wire groove of regulator holder.
Health and fresh!
9
Step 4: Ensure the surface of the heater is flush with the aluminum gusset by
adjusting the length of the wire rope.
Step 5: Connect the lead wires of the heater to the corresponding power cable. (Note:
Make sure the product is completely grounded!)
Step 6: Reinstall the removed aluminum gussets.
Inhaltsverzeichnis
Andere Quality Heating Heizung Handbücher
Beliebte Heizung Handbücher anderer Marken
Empire Heating Systems
Empire Heating Systems WCC65 Bedienungsanleitung
Wetekom
Wetekom 92 86 43 Bedienungsanleitung
Desa
Desa SPC170-F Bedienungsanleitung
Watlow
Watlow Watrod Electric Tubular Heaters Bedienungsanleitung
Haverland
Haverland ECO-DRY GPS Series Stücklistenhandbuch
Stelpro
Stelpro ASILVC2060 Series Bedienungsanleitung