MANUAL DE USUARIO
6
Safety Instructions
Do not attempt to install the equipment
yourself if you do not have the knowledge of
electricity and hydraulic installation.
The electrical installation must be carried
out in such a way that the equipment can
only be started while the ltration pump is
running. To do this, connect the power supply
of the QUICKSALT equipment to the same
contactor device that controls the pump.
The QUICKSALT control unit does not contain
elements that can be replaced or repaired by
the user. Therefore, do not open or tamper
with this element, as there is a risk of electric
shock.
To avoid the risk of damage, do not allow
children to handle this equipment.
Do not use the equipment if you notice that
any of the cables (power supply or cell) are
damaged. Disconnect it immediately and
contact your service representative if this
happens.
Make sure that the power cord of the
equipment is well protected and there is
no risk of being trapped by tools such as a
lawnmower or similar.
Do not use roll-up cable extenders to connect
QUICKSALT equipment to the mains. Contact
your oicial service if you need to extend the
power cord.
The cell must always be installed on a
horizontal pipe. Never install the unit on a
vertical pipe.
The equipment must be installed at a
minimum distance of 10 feet from the pool
vessel, so that under no circumstances can it
be accessed by a person inside the pool.
If you are going to use acid to lower the pH of
the water, follow the product manufacturer’s
instructions very carefully.
