QuickCable 303125 Bedienungsanleitung
4
1
CANADA
Quick Cable Canada Ltd.
6395 Kestrel Road
Mississauga, Ontario L5T 1Z5
Phone: 800-728-1742
Fax: 905-362-1614
Email: [email protected]
www.quickcable.com
USA
Quick Cable Corp.
3700 Quick Dr.
Franksville, WI 53126
Phone: 800-558-8667
Fax: 800-733-8611
Email: [email protected]
www.quickcable.com
2650-1265-00
Rev. A
303125 Infrared Printer
Instruction Manual
This infrared printer allows test results to be printed at a distance up to
20 feet.
2
3
OPERATION
The 303125 Infrared Printer
can be operated from up to 20 ft. away.
1. Plug the AC adapter
in and the Red LED
will light up.
2. Point the I/R receiver
that is on the front
panel, in the direction
of the vehicle or tester
being used.
3. Perform the test using
your hand-held tester.
4. When the test is complete,
point the tester in the general
direction of the 303125 Infrared
Printer. Press the print key on
the tester panel. The test
number and results indicated
on the tester LCD will print
out on the 303125 printer.
5. To feed the paper manually, Press
the LF button to start feeding the
paper. Press the LF button again
to stop feeding. Printer will
automatically stop the feed in
10 seconds. You are now
ready to print.
on the back cover of this manual.
NOTE:
If the infrared receiver on
the printer is exposed to
direct sunlight, the printer
may not function properly.
Turn the printer so that the
infrared receiver is not
exposed to direct sunlight,
and reduce the printing
distance from hand held testers.
1.
1.
2.
2.
4.
4.
PAPER INSTALLATION
Note: The AC Adapter needs to be plugged in to load and advance paper.
1. Remove the paper compartment cover by sliding it towards the
back of the printer
2. Make sure the paper has a clean cut. Press the LF button. Feed the paper
into the slot as illustrated (see g. 3). Make sure the paper loops under the
roller & not over. Once the paper is fed squarely, press the LF button again
to stop the paper from feeding any further.
3. Feed the paper up through paper cutting slot on
the paper compartment cover. Replace the
paper compartment cover by aligning
the tabs and sliding the cover forward.
You are now ready to print.
PAPER HOLDER ASSEMBLY
Standard Thermal Paper Roll - (58 mm)
Available from any ofce supply
AC Adapter
(120 VAC Output 9 VDC)
Printer Dimensions
6 1/4” W 4 1/8” D 1 3/4” H
1. Right and left arm snap into center base.
2. Clip hooks onto the notch located on the
backside of printer with cover off. Then swing
bracket down and snap the brackets
in place. (g. 2)
3. Replace cover.
4. Insert Rod.
(g. 2)
CONGRATULATIONS!
You have chosen the 303125 printer designed for use with the all 303100,30310,
AND 30315 handheld testers. If you should have any questions about this
product please refer to the contact information
(g. 3)
Inhaltsverzeichnis
Andere QuickCable Drucker Handbücher
