4
RaceAmerica 5840 T-Link 3.0 Wireless
PRODUCT OVERVIEW
T-Link 3.0 Wireless replaces track cables normally
used to connect track sensors to the timing system.
Model 5840 T-Link 3.0 connects to an external
track sensor using a short interconnect track cable.
NOTE: THIS PRODUCT OPERATES ON
HIGH FREQUENCY RADIO WAVES. DO
NOT POWER ON THE T-LINK2 WITHOUT
ATTACHNG THE ANTENNA AND DO NOT
OPERATE UNITS CLOSER TOGETHER
THAN FOUR FEET. ADDITIONALLY, DO
NOT PLUG ANY DEVICE IN THE CHAR-
GER PLUG BUT THE CHARGER. PLUG
ONLY DESIGNATED RACEAMERICA
CABLES IN THE T-PORT CONNECTOR.
PRODUCT SPECIFICATIONS
Model 5840AW T-Link 3.0
Frequency 900MHz band
Internal Battery USB Battery Pack
Lithium-Ion
T-Port Connections 05-5825 to Sensor
Connection Type RJ-45 Modular
Identier Codes A-G to sensors
Max Operating Range -20ºF to 120ºF
Model 5840AZ T-Link 3.0
Frequency 2.4GHz band
Internal Battery USB Battery Pack
Lithium-Ion
T-Port Connections 05-5825 to Sen-
sor
Connection Type RJ-45 Modular
Identier Codes A-G to sensors
Max Operating Range -20ºF to 120ºF
.
AVAILABLE OPTIONS
05-5825 Cable for Ext Sensor 25ft
6070T3 Blow Molded Carry Case
4591A High gain antenna
T-LINK2 SETUP
Each T-Link 3.0 unit is congured with a
unique ID code and a wireless optimizer code.
These codes are listed on the identity label located
on the bottom of the T-Link 3.0 unit. Valid T-Link
3.0ID codes are A, B, C, D, E, F, or G. The
wireless optimizer code is also listed on the identy
label for wireless communications optimization
and compatibility with other T-Link 3.0 units.
Install the antennas on all T-Link 3.0 units.
If the antenna has been bent down for transport,
loosen the antenna slightly and rotate the upper
portion of the antenna into position. Hold the
upper portion of the antenna while tightening the
knurled area on the bottom portion of the antenna.
Locate a 4520BU or 4520 UIDZ USB Wireless
Unit and connect the USB cable, then connect the
USB cable toany USB port on the PC. . When
the 4520 is the only wireless unit powered on, the
LED will quick ash red each time it transmits.
When other T-Link 3.0s are powered on, the LED
will ash green when a wireless signal is received.
During normal operation, the LED on each T-Link
3.0 will ash red during transmit and ash green
each time signal is received from another T-Link
3.0.
Position the T-Link 3.0 unit with ID A at the
start line and ID B at the nish line. Connect the
external Track Sensor to the T-Port of the T-Link
3.0unit using interconnect cable 05-5825. Power
on all available T-Link 3.0 IDs A through G. The
LED will step through the startup sequence. If
the external track sensor is aligned with the beam
emitter, the LED will blink green when receiving
data and red when responding. If the LED is on
solid red, the track sensor is out of alignment.
Re-position the track sensor until the LED goes
out and begins to display the red/green transmit/
