Radial Engineering JR-1 LATCHING Bedienungsanleitung

www.radialeng.com

True to the Music

USER GUIDE

Radial®JR•1™User Guide - Part # R870 1219 10 / 07-2023

reserved. Specications and appearance are subject to change without notice.

Radial Engineering Ltd.

1845 Kingsway Ave., Port Coquitlam, BC V3C 0H3, Canada

Tel: 604-942-1001 • Fax: 604-942-1010

[email protected]

REMOTE FOOTSWITCH

FEATURES

1. COMBO: Used to connect

to remote device, provides

locking connection for

¼" TRS or XLR-male

terminated cable.

2. ACTIVE/PASSIVE:

Selects active mode for

use with Radial devices or

passive mode for standard

footswitch operation.

3. LED REV: Reverses the

operation of the LED

indicators to ensure they

light up with the matching

inputs or outputs of your

Radial device.

4. XLR-M: Used to connect

to remote device, provides

alternate connection for

XLR-female cable.

5. A/B LED: Provides local

visual status of the

remotely controlled device.

6. LATCHING: The JR•1L is

equipped with a latching

footswitch that will change

states each time it is

pressed.

7. MOMENTARY: The

JR•1M is equipped with

a momentary footswitch

that will change states only

when held down.

8. YELLOW & BLACK: Yellow

top is highly visible on dark

stages while black casing is

‘invisible’ from the audience

perspective.

124

57 8

65 8

Radial Engineering Ltd. JR•1™

124

INTRODUCTION

Thank you for purchasing the Radial JR•1 footswitch. Please take a few moments

to read this short manual and familiarize yourself with the various functions. This

will help you get the most out of the JR•1 as you explore its uses. Should you

have a question that is not covered in this manual, we invite you to send us an

email at [email protected] and we will do our very best to reply in short order.

OVERVIEW

The Radial JR•1 is a remote footswitch equipped with either a latching footswitch

(JR•1L) or momentary footswitch (JR•1M) depending which model you have

purchased. The JR•1 controls various Radial devices, such as the Relay Xo

stereo switcher, and derives its power from the device under control, thus

eliminating the need for a local power supply or batteries.

LATCHING: The JR•1L is equipped with a latching footswitch that

will change states each time it is pressed. Press the switch once

to toggle from A to B and press again to change back to A. The

latching footswitch is a good option when switching effects that

stay on for the duration of a song.

JR•1L

EFFECTS

RELAY

MIXERVOCAL MIC

MOMENTARY: The JR•1M is equipped with a momentary

footswitch that will change states only when held down. Press

and hold the switch to toggle from A to B and release the switch

to change back to A. The momentary footswitch is well suited for

‘push-to-talk’ uses like toggling to an intercom system to speak

with stage technicians.

JR•1M

RELAY

INTERCOM

PA SYSTEMVOCAL MIC

Radial Engineering Ltd. JR•1™

MAKING CONNECTIONS

Connecting the JR•1 is done using ¼" guitar cables or XLR mic lines

depending on the device you are connecting to. The rear panel features a

combo connector that accepts ¼" or XLR connectors and an alternate XLR

connector is provided for exibility.

Only one remote output connector should be used at a time as using

two concurrently could cause a control system conict.

CONNECTING WITH ¼" GUITAR CABLES

Standard coaxial guitar and instrument cable may be used to connect the

JR•1 to the remote device.

JR•1

¼" GUITAR CABLE

RELAY Xo

CONNECTING WITH XLR MIC LINES

Any standard XLR mic cable may be used. The locking XLR connectors are

benecial on busy stages as it reduces the opportunity for a connection to

come lose during a performance. Press the metal tab above the connector

to release the cable.

JR•1

LOCKING XLR MIC LINE

RELAY Xo

Another advantage is that XLR cables can be daisy-chained together to

make a longer cable. This means you won’t have to depend on a specic

custom built cable to connect your remote device.

DAISY CHAIN OF XLR CABLES

Radial Engineering Ltd. JR•1™

ACTIVE MODE

On the rear panel you will nd a switch labeled ACTIVE/PASSIVE. This is

recessed to prevent accidentally changing settings during use. Use a small

screwdriver to access the ACTIVE/PASSIVE switcher during setup. Once

you are done, you will likely leave it alone.

Set the switch to ‘active’ (inward position) when the JR•1 is controlling a

Radial device such as the Relay Xo stereo switcher. When set to active, the

JR•1 sources its power from the remote device and the LED indicators work.

PASSIVE MODE

A passive mode may be engaged that allows the JR•1 to function as a

standard footswitch for any device with a compatible ¼" footswitch jack. Use

passive mode with non-Radial devices such as guitar ampliers to change

amp channels or electronic keyboard to turn on the sustain. Note that some

Radial devices can be operated using the JR•1 but they are not able to

provide power to the LEDs, in this case passive mode should also be used.

To use like a standard footswitch, set the ACTIVE/PASSIVE switch to

‘passive’ (outward position). The A/B status LEDs will not illuminate when the

JR•1 is operating in passive mode. Connection is done the same way with

¼" guitar cable. Connect one end to the JR•1 and the other to a compatible

footswitch jack.

¼" GUITAR CABLE

GUITAR AMPJR•1

REVERSING THE LEDS

In order to have the LED indicators line up with the channels of your connected

Radial device, the JR•1 includes a switch on the rear panel labeled LED REV.

This switch will reverse the A and B LED indicators so that they are illuminated

with the corresponding inputs or outputs on your Radial device. If you connect

your JR•1 and the LED indicators already match the ones on your Radial device,

simply leave this switch in the ‘out’ position. Note that the LED REV switch only

affects the JR•1 when it is used in Active Mode as described above.

True to the Music

RADIAL ENGINEERING 3 YEAR

TRANSFERABLE LIMITED WARRANTY

RADIAL ENGINEERING LTD. (“Radial”) warrants this product to be free from defects in material

and workmanship and will remedy any such defects free of charge according to the terms of this

warranty. Radial will repair or replace (at its option) any defective component(s) of this product

(excluding nish and wear and tear on components under normal use) for a period of three (3)

years from the original date of purchase. In the event that a particular product is no longer available,

Radial reserves the right to replace the product with a similar product of equal or greater value. In

the unlikely event that a defect is uncovered, please call 604-942-1001 or email service@radialeng.

com to obtain an RA number (Return Authorization number) before the 3 year warranty period

expires. The product must be returned prepaid in the original shipping container (or equivalent) to

Radial or to an authorized Radial repair center and you must assume the risk of loss or damage.

A copy of the original invoice showing date of purchase and the dealer name must accompany

any request for work to be performed under this limited and transferable warranty. This warranty

shall not apply if the product has been damaged due to abuse, misuse, misapplication, accident

or as a result of service or modication by any other than an authorized Radial repair center.

THERE ARE NO EXPRESSED WARRANTIES OTHER THAN THOSE ON THE FACE HEREOF

AND DESCRIBED ABOVE. NO WARRANTIES WHETHER EXPRESSED OR IMPLIED,

INCLUDING BUT NOT LIMITED TO, ANY IMPLIED WARRANTIES OF MERCHANTABILITY

OR FITNESS FOR A PARTICULAR PURPOSE SHALL EXTEND BEYOND THE RESPECTIVE

WARRANTY PERIOD DESCRIBED ABOVE OF THREE YEARS. RADIAL SHALL NOT BE

RESPONSIBLE OR LIABLE FORANY SPECIAL, INCIDENTAL OR CONSEQUENTIALDAMAGES

OR LOSS ARISING FROM THE USE OF THIS PRODUCT. THIS WARRANTY GIVES YOU

SPECIFIC LEGAL RIGHTS, AND YOU MAY ALSO HAVE OTHER RIGHTS, WHICH MAY VARY

DEPENDING ON WHERE YOU LIVE AND WHERE THE PRODUCT WAS PURCHASED.

WIRING DIAGRAMS

1 2

F-XLR

1 2

SHIELD

¼” TRS ¼” TRS

M-XLR

TIP

SLEEVE

TIP

SLEEVE SHIELD SHIELD

¼” TS (COAX)¼” TS (COAX)

TIP

SLEEVE

¼” TS (COAX)

SHIELD

Standard Coaxial ¼" Guitar Cable

Custom Male-XLR to ¼" Cable

Standard XLR Mic Line

To meet the requirements of California Proposition 65, it is our responsibility to inform you of the following:

WARNING: This product contains chemicals known to the State of California to cause cancer,

birth defects or other reproductive harm.

Please take proper care when handling and consult local government regulations before discarding.

Radial Engineering Ltd. JR•1™

www.radialeng.com

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere Radial Engineering Schalten Handbücher

Radial Engineering

Radial Engineering JX 42 Bedienungsanleitung

Radial Engineering

Radial Engineering Pro48 Bedienungsanleitung

Radial Engineering

Radial Engineering BigShot ABY Bedienungsanleitung

Radial Engineering

Radial Engineering Gold Digger Bedienungsanleitung

Radial Engineering

Radial Engineering SW8-USB Bedienungsanleitung

Radial Engineering

Radial Engineering BigShot i/o Bedienungsanleitung

Radial Engineering

Radial Engineering Backtrack Bedienungsanleitung

Radial Engineering

Radial Engineering Tonebone JX-2 Switchbone Bedienungsanleitung

Radial Engineering

Radial Engineering J48 stereo Bedienungsanleitung

Radial Engineering

Radial Engineering BigShot ABY Bedienungsanleitung

Radial Engineering

Radial Engineering SW8 MK2 Bedienungsanleitung

Radial Engineering

Radial Engineering Tonebone SWITCHBONE V2 Bedienungsanleitung

Radial Engineering

Radial Engineering Relay Xo Bedienungsanleitung

Radial Engineering

Radial Engineering BigShot i/o Bedienungsanleitung

Radial Engineering

Radial Engineering JX42 V2 Bedienungsanleitung

Radial Engineering

Radial Engineering SW4 Bedienungsanleitung

Radial Engineering

Radial Engineering Cherry Picker Bedienungsanleitung

Radial Engineering

Radial Engineering SW8 Bedienungsanleitung

Beliebte Schalten Handbücher anderer Marken

URC

URC Total Control MFS-8 Bedienungsanleitung

Azbil

Azbil HPQ-D11 Bedienungsanleitung

Sony

Sony DFS-900M Bedienungsanleitung

SICK

SICK i17S Bedienungsanleitung

F&F

F&F SZR-277 Bedienungsanleitung

Shure

Shure UAMS/BK Bedienungsanleitung

Dräger

Dräger X-zone Switch Off Bedienungsanleitung

Asco

Asco Joucomatic 349 Series Bedienungsanleitung

BT Mini Hub Bedienungsanleitung

D-Link

D-Link DES-1226G Bedienungsanleitung

Johnson Controls

Johnson Controls FS80-C Bedienungsanleitung

MicroNet

MicroNet SP1200A Bedienungsanleitung

Ruijie

Ruijie RG-PF2920 Series Installations- und Betriebsanleitung

Altinex

Altinex DA1914SX Bedienungsanleitung

RJM

RJM MASTERMIND PBC/6X Bedienungsanleitung

Atlas

Atlas MMK-KVM8 Bedienungsanleitung

Cabletron Systems

Cabletron Systems GIGAswitch GSR-16 Bedienungsanleitung

Cisco

Cisco Catalyst X4448 Handbuch