Radio Shack FRS Bedienungsanleitung

TEKCOM Industries Limited

Page 1 of 6

OWNER’S MANUAL

FRS RADIO

21-1860

INTRODUCTION

Your RadioShack FRS radio is a portable, easy-to-use, two-way radio that you can carry almost

anywhere. Use it at shopping malls, amusement parks, sports events, or at the beach to contact

family and friends, or for vital communications in a neighborhood watch.

Your radio has 14 channels and 38 different quiet codes. If someone else is using the channel

you selected and you do not want to hear that person, select another channel or use the quiet

feature. You can talk with a person who has a FRS radio if both radios are tuned to the same

channel and quiet code.

Your radio also has one touch access key for 3 pre-programmed or user preferable FRS channel.

The radio can auto dual watch between the operation channel and user preset channel.

Your radio has auto-squelch, which means you will not hear anything on a channel unless

someone is transmitting nearby on the same channel. You can turn off auto-squelch to hear

weaker, distant transmissions.

Also, if the radio is idle for 2 hours, it automatically shuts off. It turns on again when you press

any key.

You can connect an optional speaker/microphone and earphone, charger (not supplied) to the

radio. And, the belt clip lets you take your radio almost anywhere.

USING THE RADIO

A. DISPLAY

Your radio comes with a multifunction backlighted display. By pressing any button except the

CALL and PTT, the backlight will illuminate for 7 seconds.

1. Shows the selected channel number.

TEKCOM Industries Limited

Page 2 of 6

2. Shows the selected privacy code number.

3. Shows the selected memory channel number.

4. “QUIET”: Displays when the QUIET mode is enabled.

5. “BUSY” : Displays when a call is being received.

6. “ ”:Displays when your radio is transmitting or the CALL button is pressed.

7. “FUNC” : Displays when the secondary function is enabled.

8. “SCAN” : Displays when the scan mode is activated.

9. “DUAL” : Displays when the dual-watch function is activated.

10.

“ ”:Displays when the working channel is set to be skipped.

11.

“ ”: Indicates the batteries are low. Replace the batteries when it appears.

12.

“ ”:Displays when the key tone function is activated.

13.

“ ”: Displays when the keypad lock is activated.

14.

“C-TONE”: Display when the over-tone function is activated.

B. FUNCTION AND LOCATION OF THE CONTROLS

1. “ON/OFF” Volume Control.

TEKCOM Industries Limited

Page 3 of 6

In “OFF” position, your transceiver is off. Rotate this control clockwise to turn on your radio

and adjusts the volume, until you get a comfortable listening level.

2. CH /Key Tone Button

Press CH to move one channel higher. Press and hold CH for more than 1.5sec to enter

into the scan upwardly mode. Press CH will change the scanning direction.

Press FUNC key and hold for less than 1.5 sec, then press CH key to activate or deactivate

the Key Tone function. Icon “ ” will be shown if activated.

3. CH / Skip / Automatic Shut Off Button

Press CH to move one channel down. Press and hold CH for more than 1.5sec to enter

into the scan downwardly mode. Press CH will change the scanning direction.

Skip

User can choose a desired channel from being scanned. Press CH or to go to the desired

channel. Press FUNC key and hold for less than 1.5 sec, then press CH key to skip this

channel from scanning. Icon “ " ” is on to indicate this working channel is set to be skipped.

Automatic Shut Off Button

Press and hold the CH while turning on the radio will enable or disable the automatic shut off

timer. The display will show “AP ON” when the timer is activated, or “AP OF” when deactivated.

The timer automatically turns off the unit when it is idle for 2 hours.

4. QUIET /QUIET Scan Button

Press QUIET button to enable or disable the QUIET privacy mode operation.

a) Hold down QUIET button for 2 seconds until QUIET is displayed and the quiet code

flashes.

b) Repeatedly press (or hold down) CH or CH until you see the code number you want

to use.

c) Press QUIET button to store the code.

To turn on the quiet feature, press QUIET. QUIET appears. To turn off the feature, press

QUIET until QUIET disappears.

Note: We recommend that you select a quiet code from the range 7-30. If you select a code

below or above that range, you must wait 1 to 2 seconds after holding down PUSH-TO-TALK

before you start talking.

QUIET Scanning

TEKCOM Industries Limited

Page 4 of 6

Press FUNC key for less than 1.5 sec, and follow by QUIET key to enter into the QUIET Scan

mode, and icons of “SCAN” and “QUIET” will be lightened on LCD. When received the same

QUIET code, the scanning stops and will keep scanning after the signal disappears. Press any

key will exit and return to the normal working channel.

5. M1 (M2 or M3)/ Dual Watch

Press M1 (M2 or M3) to switch the unit to the channel stored at this location.

Dual Watch

It can be activated or deactivated by pressing the FUNC key for less than 1.5sec and follow by

M1 (M2 or M3). ‘DUAL’ icon will be shown on the LCD if activate. During Dual-Watching,

upon receiving a signal from the normal working channel or M1 (M2 or M3) channel, the unit

will stop at that channel. If the signal is gone, the unit will resume Dual-Watch.

6. Push-To-Talk button / Keylock /C-Tone

To talk, hold down the Push-To-Talk. Speak into the microphone in a normal tone of voice

when the icons is displayed. When you finish speaking, release the Push-To-Talk button.

Your can also lock your radio setting to avoid accidental pressing of keys by activating the

keypad lock. Press and hold the FUNC button, then press the PTT button to activate or

deactivate the keypad lock.

Press and hold the Push-To-Talk while turning on the radio will enable or disable the courtesy

tone (C-Tone) function.

7. MON/FUNC Button

To hear everything happening on a channel, including weak transmission, hold down

MON/FUNC button for more than 1.5 sec. Re lease the MON/FUNC button to turn the auto-

squelch back on.

8. CALL/MCU Reset Button

You can cause a ringer sound on all radios tuned to the same FRS channel and/or the privacy

code as your radio. To send a page, press and hold down the CALL button.

Holding the CALL button while turning on the radio will resume your radio’s MCU and the quiet

code will be reset to number 12, CTCSS privacy mode operation is deactivated, the automatic

shut off timer disabled, keypad lock disabled, backlight switched off and channel setting will go

to number 1.

When the unit is reset, memory channel M1, M2, M3 will go to CH1, CH2, CH3 without QUIET

code.

9. External Mic/Spk Jack

TEKCOM Industries Limited

Page 5 of 6

Connect an optional speaker/microphone or earphone in this jack.

Charger Jack (shared with the Mic jack)

You can recharge Ni-Cd batteries using an optional battery charger (not supplied). Plug the

charger’s barrel plug into the CHRG jack on the side of the unit, then connect the charger to a

standard AC outlet.

10. Belt Clip

To attach the belt clip, place it over the locking pin and align the screw hole. Tighten the screw.

11. Battery Compartment

Press and push back the battery door to release.

Ni-Cd/Alkaline Switch (inside the battery compartment)

When you use Ni-Cd batteries and begin to recharge your batteries, the switch on the battery

compartment should be set to the position of Ni-Cd. Open the battery door, and you will find this

switch as shown as following:

Warning: Do not put the switch to the position of Ni-Cd when Alkaline batteries are used. It

may cause the radio to burst and cause personal injury when you recharge the

batteries.

C. OPERATION

1. Your radio uses four AA batteries for power. We recommend alkaline batteries. However,

you can use rechargeable batteries in the radio.

2. To start using your radio, insert four AA batteries into the battery compartment, noting the

polarities.

3. Rotate ON/OFF volume control to turn on the radio and adjust the volume.

4. Select the desired channel and/or quiet code.

5. Press the Push-To-Talk button to transmit and the CALL button to cause a ringer.

6. To receive, simply release the Push-To-Talk button.

Note: You can only communicate with another radio that is using the same channel and/or the

same quiet code as your radio.

TECHNICAL SPECIFICATIONS

TEKCOM Industries Limited

Page 6 of 6

RX Frequency................................................................................................462-467 MHz

Channels............................................................................................................................14

Modulation type..............................................................................................................FM

Antenna impedance..................................................................................................50 Ohm

Microphone...................................................................................................condenser type

Power supply..............................................................................................4× AA Alkaline

Sensitivity at 12dB Sinad............................................................................................0.5µ

µµ

µV

Adjacent Channel Rejection........................................................................................45dB

Audio Squelch .............................................................................................................Auto

Audio output power...............................................................................250mW @ 8 Ohm

Audio Distortion ............................................................................................................5%

RF Output Power...........................................................................500 mW ERP @6V DC

Harmonic Emissions.................................................................................more than 50dB

Dimensions(HWD)..................................................................….......121.5×55.0×38.0mm

Weight(without batteries).............................................................................................145g

CHANNEL FREQUENCIES Frequency: MHz

1=462.5625 5=462.6625 9=467.5875 13=467.6875

2=462.5875 6=462.6875 10=467.6125 14=467.7125

3=462.6125 7=462.7125 11=467.6375

4=462.6375 8=467.5625 12=467.6625

CTCSS PRIVACY CODES Frequency: Hz

1: 67.0 11: 97.4 21: 136.5 31: 192.8

2: 71.9 12: 100.0 22: 141.3 32: 203.5

3: 74.4 13: 103.5 23: 146.2 33: 210.7

4: 77.0 14: 107.2 24: 151.4 34: 218.1

5: 79.7 15: 110.9 25: 156.7 35: 225.7

6: 82.5 16: 114.8 26: 162.2 36: 233.6

7: 85.4 17: 118.8 27: 167.9 37: 241.8

8: 88.5 18: 123.0 28: 173.8 38: 250.3

9: 91.5 19: 127.3 29: 179.9

10: 94.8 20: 131.8 30: 186.2

Andere Handbücher für FRS

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere Radio Shack Radio Handbücher

Radio Shack

Radio Shack DX-398 Bedienungsanleitung

Radio Shack

Radio Shack 20-125 Bedienungsanleitung

Radio Shack

Radio Shack PRO-2041 Wartungshandbuch

Radio Shack

Radio Shack DX 275 Bedienungsanleitung

Radio Shack

Radio Shack TRC521 CB Bedienungsanleitung

Radio Shack

Radio Shack PRO-651 Bedienungsanleitung

Radio Shack

Radio Shack TRC-501 Bedienungsanleitung

Radio Shack

Radio Shack 12-826 Bedienungsanleitung

Radio Shack

Radio Shack 12-796 Bedienungsanleitung

Radio Shack

Radio Shack iScan 20-107 Bedienungsanleitung

Radio Shack

Radio Shack 1201850 Bedienungsanleitung

Radio Shack

Radio Shack 1201475 Bedienungsanleitung

Radio Shack

Radio Shack Pro-2035 Bedienungsanleitung

Radio Shack

Radio Shack 12-889 Bedienungsanleitung

Radio Shack

Radio Shack 21-1863 Bedienungsanleitung

Radio Shack

Radio Shack 12-225 Bedienungsanleitung

Radio Shack

Radio Shack 1201480 Bedienungsanleitung

Radio Shack

Radio Shack 200 Ch VHF/Air/UHF Home Scanner Bedienungsanleitung

Radio Shack

Radio Shack 1201476 Bedienungsanleitung

Radio Shack

Radio Shack 12-803 Bedienungsanleitung

Radio Shack

Radio Shack TRC521 CB Bedienungsanleitung

Radio Shack

Radio Shack Realistic TRC-473 Bedienungsanleitung

Radio Shack

Radio Shack 1201519 Bedienungsanleitung

Radio Shack

Radio Shack 21-1840 Bedienungsanleitung

Beliebte Radio Handbücher anderer Marken

EisSound

EisSound KBSound iSelect Bedienungsanleitung

Midland

Midland 1001LWX Bedienungsanleitung

Konig

Konig HAV-SR41 Bedienungsanleitung

Roberts

Roberts exprssion Bedienungsanleitung

VDigi

VDigi DD3.0 Bedienungsanleitung

Roberts

Roberts Stream 207 Bedienungsanleitung

Sony

Sony Walkman SRF-M97 Bedienungsanleitung

Stanley

Stanley FatMax FMC770 Bedienungsanleitung

auna

auna DAB-Radio 10026947 Bedienungsanleitung

SOUNDMASTER

SOUNDMASTER UR190 Bedienungsanleitung

HYT

HYT TC-320 Bedienungsanleitung

B-Tech

B-Tech GMRS-V2 Bedienungsanleitung

Weierwei

Weierwei VEV-V8 Bedienungsanleitung

SOUNDMASTER

SOUNDMASTER DAB750 Bedienungsanleitung

Telefunken

Telefunken TF-1505 Bedienungsanleitung

Makita

Makita LXRM03 Bedienungsanleitung

PRESIDENT

PRESIDENT TEDDY R. Bedienungsanleitung

FRIENDCOM

FRIENDCOM FC-302V Bedienungsanleitung