Initial checks
●When power is initially connected to the module, the load should power up to full
brightness.
●The clear button can be used as a manual on/off switch to test the circuit.
●The internal LED behind the clear button will flicker when the module receives any
Rako wireless message and is a useful diagnostic indicator. The LED feedback
becomes inactive after 20 minutes to avoid a nuisance light spill but can be
re-activated by pressing the clear button.
Programming the RMT-500
Once the RMT-500 has powered up and has been tested working with the setup button, the
device is ready to be programmed. For instructions on how to program the RMT-500, see the
Wireless Module Setup Guide.
Appendix 1: LED Diagnostics
When the unit is receiving
successfully, there will be
four rapid pulses on the LED
when any wireless message
is sent.
When the unit is out of
range, there will be
intermittent pulses on the
LED when any wireless
message is sent.
NB
It is recommended to install
a wireless repeater
(WRB-100) if you are
experiencing intermittent
wireless range.
Should the module not respond to any of the above, check the supply voltage.
RMT-500 Manual Version 2.0.0
