SERGE-MODULAR.COM
SERGE MODULAR
5
Preamp
The purpose of this preamplier is to bring external signals (dynamic mic, Guitar or other instruments) to the Serge
Audio level of 5Vpp. The LED lights up when the signal reaches (or exceeds) 5Vpp.
The Preamp offers two parallel inputs, one line level input (mono minijack) with a xed amplication of approx.
x8 and one TRS balanced input (6,35mm TRS) with up to +60dB.
Compressor
The compressor reduces the dynamic range of the incoming audio signal. Its knob continuously adjusts gain,
threshold and compression ratio. It works best with 5Vpp signals.
The internal RMS detector derives an envelope control voltage from the input signal, which is available at the
ENV OUT. Note: When SIDE CHAIN is activated the enevlope is derived from the side chain signal!
VCA
This high quality audio VCA is controlled by the GATED OUT CV (see below), but offers an additional CV input for
external control.
Analyzer / Envelope Detector / Gates
ENV OUT (grey line) provides a control voltage reecting the envelope of a signal running through the compressor
(using an RMS envelope detector).
GATED OUT (blue line) controls the VCA. It is based on this envelope signal (CV), but two additional gates
are applied that can be used hard limit the CV signal. The UPPER THRESHOLD knob works as limiter (or
volume control) and prevents the CV signal from exceeding the threshold. The LOW THRESHOLD knob kills the
envelope (i.e. sets it to 0V) as long as it is below the theshold. This can be used like a noise gate in combination
with the VCA.
