Raymarine ST40 Depth Instrument Benutzerhandbuch
ST40 Depth
Instrument
Owner’s
Handbook
Document number: 81158-3
Date: March 2006
81158_3.book Page 1 Tuesday, March 28, 2006 10:33 AM
Raymarine, ST40 and SeaTalk are trademarks of Raymarine UK Ltd
© Handbook contents copyright Raymarine UK Ltd.
81158_3.book Page 2 Tuesday, March 28, 2006 10:33 AM
Preface i
Important information
Safety notices
WARNING: Product installation & operation
This equipment must be installed and operated in accordance
with the Raymarine instructions provided. Failure to do so could
result in personal injury, damage to your boat and/or poor product
performance.
WARNING: Electrical safety
Make sure you have switched off the power supply before you
start installing this product.
WARNING: Navigation aid
Although we have designed this product to be accurate and
reliable, many factors can affect its performance. Therefore, it
should serve only as an aid to navigation and should never replace
commonsense and navigational judgement. Always maintain a
permanent watch so you can respond to situations as they
develop.
EMC conformance
All Raymarine equipment and accessories are designed to the best industry
standards for use in the recreational marine environment.
The design and manufacture of Raymarine equipment and accessories conform to
the appropriate Electromagnetic Compatibility (EMC) standards, but correct
installation is required to ensure that performance is not compromised.
Waste from Electrical and Electronic Equipment
(WEEE) Directive
The Waste from Electrical and Electronic Equipment (WEEE) Directive requires the
recycling of waste electrical and electronic equipment. Whilst the WEEE Directive
does not apply to some of Raymarine’s products, we support its policy and ask you
to be aware of how to dispose of this product.
The crossed out wheelie bin symbol, illustrated above, and found on our products
signifies that this product should not be disposed of in general waste or landfill.
Please contact your local dealer, national distributor or Raymarine Technical
Services for information on product disposal.
81158_3.book Page i Tuesday, March 28, 2006 10:33 AM
ii ST40 Depth Instrument Owner’s Handbook
Handbook information
To the best of our knowledge, the information in this handbook was correct when
it went to press. However, Raymarine cannot accept liability for any inaccuracies
or omissions it may contain.
In addition, our policy of continuous product improvement may change
specifications without notice. Therefore, Raymarine cannot accept liability for any
differences between the product and the handbook.
81158_3.book Page ii Tuesday, March 28, 2006 10:33 AM
Preface iii
Contents
Important information .......................................................... i
WARNING ......................................................................... i
EMC conformance ............................................................. i
Handbook information ....................................................... i
Preface..................................................................................... v
Parts supplied ................................................................... vi
Chapter 1: Operation ............................................................. 1
1.1 Operating procedures .................................................. 1
Silencing alarms .......................................................... 1
Adjusting display backlighting and contrast ............... 4
1.2 Alarms ......................................................................... 5
Alarm indications ........................................................ 5
Shallow alarm ........................................................ 5
Deep alarm ............................................................. 5
Anchor alarms ........................................................ 5
Enabling/disabling alarms ........................................... 6
Chapter 2: Maintenance and Fault Finding ........................ 7
2.1 Maintenance ................................................................ 7
Servicing and safety .................................................... 7
Instrument .................................................................... 8
Transducer ................................................................... 8
Cabling ........................................................................ 8
2.2 Fault finding ................................................................ 8
Preliminary procedures ............................................... 8
Fixing faults ................................................................. 8
Assistance .................................................................. 10
158_2pre.p65 01/05/01, 13:553
iv ST40 Depth Instrument Owner’s Handbook
Chapter 3: Installation......................................................... 11
3.1 Planning your installation ......................................... 11
EMC installation guidelines ...................................... 11
Suppression Ferrites ........................................... 12
Connections to Other Equipment ......................... 12
Tools required ........................................................... 12
Site requirements ....................................................... 13
Transducer ........................................................... 13
Instrument ............................................................ 15
3.2 Procedures................................................................. 16
Fitting transducer ....................................................... 16
Running transducer cable .................................... 16
Connections to the instrument ................................... 17
SeaTalk connections ............................................ 18
Fitting the instrument................................................. 19
Desktop Mounting Bracket .................................. 21
3.3 Calibration requirement ............................................ 22
Chapter 4: Calibration ......................................................... 23
4.1 Introduction ............................................................... 23
EMC conformance .................................................... 23
4.2 User calibration ......................................................... 23
Depth offsets ............................................................. 24
4.3 Intermediate calibration ............................................ 26
4.4 Dealer calibration ...................................................... 26
Instrument Specification .................................................... 29
Glossary ................................................................................. 31
Index ...................................................................................... 33
158_2pre.p65 01/05/01, 13:554
Preface v
Preface
Thank you for purchasing a Raymarine product. We are sure your
ST40 instrument will give you many years of trouble-free operation.
This instrument is designed to provide reliable performance, even
under the most demanding conditions.
D4637-2
158_2pre.p65 01/05/01, 13:555
vi ST40 Depth Instrument Owner’s Handbook
Parts supplied
D4665-2
ST40
Depth
Instrument
Owner's
Handbook
Worldwide
Distributors
ST40 Depth instrument
Fixing
stud
Thumb
nut
Gasket
Depth transducer
Supplied with bung
(not illustrated)
1 m (3 ft) power cable
Instrument Cover
Owner’s Handbook.
Warranty document and fitting
templates included in Handbook
Worldwide Service Centre
Handbook.
Quick Reference Guide
Clamping bracket
DEPTH
ST40
Note:
The items shown here are supplied for an ST40 Depth system. If an instrument is purchased separately, a transducer
is not included. If any item is not present, contact your Raymarine Dealer.
With Set alarm level screen displayed,
to save the alarm level and return to
normal operation.
and keys simultaneously
press the
Adjusting display backlighting/contrast
Normal operation
ST40 Depth Instrument - quick reference guide
SWITCH ON
Depth
Minimum
depth
Shallow
alarm
Deep
alarm
Deep
anchor
alarm
Offset
Shallow
anchor
alarm
Notes:
*denotes temporary screens which will
time-out to the previous permanent
screen after 5 seconds.
On repeater instruments, only the
Depth and Minimum depth
screens are available.
3 seconds
Alarm on/off
3 seconds
Alarm on/off
Set
alarm
level
3 seconds
Alarm on/off
3 seconds
Alarm on/off
+
orTo exit adjust mode press or wait for 5 second timeout
LEVEL 1 LEVEL 1
OFF LEVEL 2LEVEL 3LEVEL 2
To enter adjust mode,press for 1 second to adjust BACKLIGHTING and a further 1 second to adjust CONTRAST
-
158_2pre.p65 01/05/01, 13:566
Chapter 1: Operation 1
Chapter 1: Operation
Your ST40 Depth instrument:
• Provides depth information, in either feet (FT), metres (M) or
fathoms (FA), as set during User calibration (see Chapter 4,
Calibration).
• Records the minimum depth encountered during the period it is
switched on. You can reset this at any time.
• Enables you to define alarm thresholds for shallow water, deep
water, shallow anchor and deep anchor.
• Enables you to see what offset is applied to the depth reading.
CAUTION
Your instrument is calibrated to factory (default) settings when
first supplied and must therefore be calibrated before use, to
ensure optimum performance on your vessel. Do NOT use the
instrument until the calibration procedures have been
satisfactorily completed, using the procedures in Chapter 4,
Calibration.
Coloured bezel and Desktop Mounting Bracket options are available
for your ST40 instrument. Contact your Raymarine dealer for further
information.
1.1 Operating procedures
Operating information is presented in flow chart form. The flow charts
show the various operating screens and key presses necessary to carry
out the various instrument functions. Key presses are momentary unless
otherwise stated.
Note that:
• Up/down depth-trend arrows are displayed, if the seabed is rising or
falling at a significant rate.
• The minimum depth reading is reset to zero at power up.
Silencing alarms
To silence an alarm (see the Alarms section, later in this chapter),
momentarily press any one of the instrument keys.
158_2c01.p65 01/05/01, 13:561
2 ST40 Depth Instrument Owner’s Handbook
NORMAL OPERATION (sheet 1)
Depth
Minimum
depth
Shallow
alarm
D4658-2
Notes:
Screens other than the Depth screen, are
temporary and will time-out to the Depth
screen after 5 seconds.
Switch on
3 seconds
To reset
3 seconds
Alarm
on/off
To/from Shallow anchor alarm screen
(sheet 2)
Deep
alarm
Set Shallow alarm
threshold
Set Deep alarm
threshold
3 seconds
Alarm
on/off
Increase
Decrease
Increase
Decrease
To/from the Offset
screen (sheet 2)
This diagram shows the operating sequence for
an ST40 Depth master instrument. On a repeater
instrument, only the Depth and Minimum
depth screens are available.
If the Shallow alarm has been locked during User calibration,
you cannot switch it on or off or change the threshold value.
+
+
With any set alarm screen displayed, press the
to save the alarm level and return to
normal operation.
and keys simultaneously
Momentary
Momentary
158_2c01.p65 01/05/01, 13:562
Inhaltsverzeichnis
Andere Raymarine Monitor Handbücher
Raymarine
Raymarine St290 Bedienungsanleitung
Raymarine
Raymarine e7 Bedienungsanleitung
Raymarine
Raymarine ST60 Tridata Bedienungsanleitung
Raymarine
Raymarine ST70 Instrument Montageanleitung
Raymarine
Raymarine C-Series Bedienungsanleitung
Raymarine
Raymarine e7 Service-Handbuch
Raymarine
Raymarine C140w Bedienungsanleitung
Raymarine
Raymarine E70141 Service-Handbuch
Raymarine
Raymarine ST40 Benutzerhandbuch
Raymarine
Raymarine St290 Bedienungsanleitung
Raymarine
Raymarine G170 Bedienungsanleitung
Raymarine
Raymarine T210 Bedienungsanleitung
Raymarine
Raymarine AXIOM XL 16 Bedienungsanleitung
Raymarine
Raymarine ST60+ SPEED INSTRUMENT Bedienungsanleitung
Raymarine
Raymarine eS Series Bedienungsanleitung
Raymarine
Raymarine i70 Bedienungsanleitung
Raymarine
Raymarine AXIOM+ Series Bedienungsanleitung
Raymarine
Raymarine AXIOM Series Bedienungsanleitung
Raymarine
Raymarine Raytheon R21 Series Bedienungsanleitung
Raymarine
Raymarine ALPHA Bedienungsanleitung
