RCA RD3500 Bedienungsanleitung
Copyright © 2014 Discount Two-Way Radio Corporation - North American Distributor
1
RD3500TM Professional Two-Way Radio Instruction Manual
Congratulations on selecting the RD3500TM from
RCA Communications Systems - The most trusted name in radio.
Our new series of professional communications products establishes a new benchmark in premium
radio products made to perform awlessly under the most demanding commercial conditions.
Cutting edge design, professional grade materials and components, simple operation and superior
assembly quality: RCA Communications Systems has it all, including our exclusive no-nonsense,
two-year “Warranty Protection Program,” one of the most comprehensive warranties in the
communications industry.
To ensure you achieve maximum performance from your RD3500TM radio, please be sure to carefully
read this manual.
MODELS COVERED IN THIS MANUAL:
RD3500TM Two-Way Radio
sound
Enhanced Audio Clarity
TM
Copyright © 2014 Discount Two-Way Radio Corporation - North American Distributor
RD3500TM Professional Two-Way Radio Instruction Manual
2
• Refer service to qualied technicians only.
• Do not operate the transceiver nor charge
a battery pack in an explosive atmosphere
(gases, dust, fumes, etc.).
• Turn OFF the transceiver while taking on fuel
or while parked in a gasoline service station.
• Do not modify nor attempt to adjust this
transceiver for any reason.
• Do not expose the transceiver to long periods
of direct sunlight, nor place it close to heating
appliances.
• Do not place the transceiver in excessively
dusty, humid, and/or wet areas, nor on
unstable surfaces.
SAFETY: It is important that the operator be
aware of and understand hazards common to
the operation of any transceiver.
PRECAUTIONS
Copyright © 2014 Discount Two-Way Radio Corporation - North American Distributor
3
RD3500TM Professional Two-Way Radio Instruction Manual
UNPACKING AND CHECKING EQUIPMENT
Supplied Accessories.....................................1
PREPARATION
Charging the Battery Pack.........................2-3
Installing/Removing the Battery Pack..............4
Installing the Antenna................................... 5
Installing the Belt Clip....................................5
Installing the Cover over the Speaker/
Microphone Jacks..........................................6
Installing the Speaker/Microphone.................6
GETTING ACQUAINTED.................................7
OPERATION...............................................8
AUXILIARY FUNCTIONS
Time-Out Timer.............................................9
Battery Saver.................................................9
Low Battery Warning..................................... 9
Monitor...................................................... 10
CTCSS/DCS CODES
50 CTCSS frequency codes (Hz).................11
104+1 DCS code.........................................11
TROUBLESHOOTING GUIDE.........................12
FREQUENCY CHART....................................13
ADVANCED OPERATIONS
Safety Training Information..........................14
Electromagnetic interference/Compatibility..15
CONTENTS
Copyright © 2014 Discount Two-Way Radio Corporation - North American Distributor
RD3500TM Professional Two-Way Radio Instruction Manual
4
UNPACKING AND CHECKING
EQUIPMENT
Carefully unpack the transceiver. We
recommend that you identify the items listed
in the following table before discarding the
packing material. If any items are missing or
have been damaged during shipment, le a
claim with the carrier immediately.
Supplied Accessories
ITEM QUANTITY
Antenna 1
Battery charger 1
AC adaptor 1
Battery pack 1
Belt clip 1
lnstruction manual 1
Copyright © 2014 Discount Two-Way Radio Corporation - North American Distributor
5
RD3500TM Professional Two-Way Radio Instruction Manual
Notices
Emergency Key/Side button 1/Side button 2
and side button 3 can be programmable for
short press and long press by PC software to
these functions:
1. Unassigned. 2. All alert tones on/off, 3.
Emergency on, 4. Emergency off, 5. High/
low power, 6. Monitor, 7. Nuisance channels
delete, 8. One touch Access1, 9. One touch
Access2, 10. One touch Access3, 11. One
touch Access4, 12. One touch Access5, 13.
One touch Access6, 14. scan on/off, 15. Tight/
normal squelch, 16. Scrambler on/off, 17. Vox
on/off, 18. Tone select, 19. Battery indicator,
20. Lone work on/off, 21. Repeater/talk
around, 22. Man down on/off
GETTING UNDERSTANDING
Copyright © 2014 Discount Two-Way Radio Corporation - North American Distributor
RD3500TM Professional Two-Way Radio Instruction Manual
6
CHARGING THE BATTERY PACK FOR MORE
THAN 5 DAYS MAY REDUCE THE BATTERY
PACK LIFE.
Note: The ambient temperature should be
between 41 and 104°F (5 and 40°) while
charging is in progress. Charging outside this
range may not fully charge the battery. Always
switch OFF the transceiver equipped with a
battery pack before charging. Using the trans-
ceiver while charging its battery pack will in-
terfere with correct charging. The battery pack
life is over when its operating time decreases
even though it is fully and correctly charged.
Replace the battery pack.
PREPARATION
Charging the Battery Pack
The battery pack is not charged at the factory;
charge it before use. Initially charging the
battery pack after purchase or extended
storage (greater than 2 months) will not
bring the battery pack to its normaloperating
capacity. After repeating the charge/discharge
cycle two or three times, the operating capacity
will increase to normal.
CAUTION: DO NOT RECHARGE THE BATTERY
PACK IF IT IS ALREADY FULLY CHARGED.
DOING SO MAY CAUSE THE LIFE OF THE
BATTERY PACK TO SHORTEN OR THE BATTERY
PACK MAY BE DAMAGED.
AFTER RECHARGING THE BATTERY PACK,
DISCONNECT IT FROM THE CHARGER.
Copyright © 2014 Discount Two-Way Radio Corporation - North American Distributor
7
RD3500TM Professional Two-Way Radio Instruction Manual
Plug the AC adaptor cable into the adaptor
jack located on the rear of the charger.
Plug the AC adaptor into an AC outlet.
Slide the battery pack or transceiver with a
battery pack into the charger.
Make sure the battery pack contacts are in
contact with the charging terminals. The
charger LED lights and charging begins.
After charging the supplied battery pack for 4
hours, remove it or the transceiver equipped
with it from the charger.
The charger turns to green automatically after
charging is completed.
Unplug the AC adaptor from the AC outlet.
Copyright © 2014 Discount Two-Way Radio Corporation - North American Distributor
RD3500TM Professional Two-Way Radio Instruction Manual
8
Installing / Removing the Battery Pack
The average life of the supplied battery pack
is 10 hours.
Average times are calculated using 5% transmit
time, 5% receive time, and 90% standby time.
CAUTION: DO NOT TAMPER WITH THE
BATTERY TERMINALS NOR DISPOSE OF
THE BATTERY BY FIRE. NEVER ATTEMPT TO
REMOVE THE CASING FROM THE BATTERY
PACK.
Match the top of battery with the frame of
chassis.
Match the top of battery with the frame of
chassis.
Push the battery pack to the connection of
chassis and push down the battery locker.
To remove the battery pack, pull up the battery
locker and slide the pack away from the
transceiver.
Copyright © 2014 Discount Two-Way Radio Corporation - North American Distributor
9
RD3500TM Professional Two-Way Radio Instruction Manual
Installing the Antenna
Screw the antenna into the connector on the
top of the transceiver by holding the antenna
at its base and turning it clock-wise until
secure.
Note: The antenna is neither a handle, a
key ring retainer, nor a speaker/microphone
attachment point. Using the antenna in these
ways may damage the antenna and degrade
your transceiver’s performance.
Installing the Belt Clip
If necessary, buckle the belt clip to the back of
the battery pack.
Note: if not install the belt clip, the installation
position may become hot during High
Temperature.
CAUTION: DO NOT USE GLUE WHICH IS
DESIGNED TO PREVENT SCREW LOOSENING
WHEN INSTALLING THE BELT CLIP,AS IT MAY
CAUSE DAMAGE TO THE TRANSCEIVER.
ACRYLIC ESTER, WHICH IS CONTAINED
IN THESE GLUES, MAY CRACK THE
TRANSCEIVER’S BACK PANEL.
Copyright © 2014 Discount Two-Way Radio Corporation - North American Distributor
RD3500TM Professional Two-Way Radio Instruction Manual
10
Installing the Earphone/
Speaker Microphone
Plug the Earphone/Speaker Microphone into
the jack.
Note: When you use the Earphone/Speaker
Microphone, the radio may not be waterproof.
Installing the Jack Cover
If you are not using the jack, cover the jack with
the jack cover that is supplied with a screw.
Note: To keep the transceiver water resistant,
you must cover the jacks with the supplied
cover and twisting in the screw.
Inhaltsverzeichnis
Andere RCA Zwei-Wege-Funkgerät Handbücher
RCA
RCA RDR2600U Bedienungsanleitung
RCA
RCA RDR2600V Bedienungsanleitung
RCA
RCA RDR3600V Bedienungsanleitung
RCA
RCA RDR2000 Series Bedienungsanleitung
RCA
RCA digital Xsound BR250 VHF Bedienungsanleitung
RCA
RCA Prodigi RDR1520 Series Bedienungsanleitung
RCA
RCA RDR2000 Series Bedienungsanleitung
RCA
RCA RDR2300V Bedienungsanleitung
RCA
RCA Alpha One APR100 Series Bedienungsanleitung
RCA
RCA RDR3600U Bedienungsanleitung
RCA
RCA RDR5200 Bedienungsanleitung
RCA
RCA BR200V Bedienungsanleitung
RCA
RCA MR240 Bedienungsanleitung
RCA
RCA BRM300DV Bedienungsanleitung
RCA
RCA RDR43 0-IS Series Bedienungsanleitung
RCA
RCA RDR2 0 Series Bedienungsanleitung
RCA
RCA Prodigi RDR1520 Series Bedienungsanleitung
RCA
RCA RDR23 0 Series Bedienungsanleitung
RCA
RCA BR850U Bedienungsanleitung
RCA
RCA BRM350D Series Bedienungsanleitung
