RED ATOM RED-EXT-4K-HDBASET Bedienungsanleitung

RED-EXT-4K-HDBASET

HDMI 2.0 Extender

Product Manual

www.redatomproducts.com

40M 4K30 4:4:4/4K60 4:2:0 HDBaseT

Introduction

The RED-EXT-4K-HDBASET is an HDMI extender featuring HDBaseT technology, allowing for

the extension of 4K HDR HDMI signals up to 40 Meters. Equipped with Bi-directional POC and IR

extension the RED-EXT-4K-HDBASET makes extension easy by transmitting video, control, and

power over a single piece of Category cable.

Features:

• HDMI 2.0b

• Max Resolution 4K30 4:4:4/4K60 4:2:0

• Up to 40M (Cat6a) at 4K

• Up to 70M (Cat6a) at 1080p

• Single Bi-Directional Power Supply / POC

• IR Emitter and Receiver included

• HDR Capability

• HDCP 1.X/2.2 Support

• CEC Pass-Through

• 12V IR Support

Specications

Video:

• Video Resolutions: Up to 4K30 4:4:4

• VESA Resolutions: Up to 4096x2160 (DCI 4K)

• Chroma Supported: 4:4:4, 4:2:2, 4:2:0, RGB (Limited and Full)

• Deep Color: Up to 16 Bit (1080p), Up to 12 Bit (4K)

Audio:

• LPCM (Up to 192KHz 24 bit): 2.0, 5.1, 7.1

• Dolby: Dolby Digital, Dolby Digital Plus, Dolby TrueHD, Dolby Atmos

• DTS: DTS 6.1 ES, DTS HRA, DTS Master Audio, DTS:X

Dimensions:

• Block Size: 4” x 2.75” x .75” (WxLxH) each

Included in the Box:

• Transmitter

• Receiver

• IR Receiver

• IR Emitter

HDBaseT Distance (CAT 6A):

• 4K Resolutions: 40 meters (131 feet)

• 1080p Resolutions: 70 meters (230 feet)

• Power cord

• Mounting brackets

Panel Descriptions

Transmitter Front Panel:

• SERVICE USB input — For service & ﬁrmware updates only; Do not use.

• IR Transmitter input

• IR Receiver input

• HDMI IN input

• SYNC LED

Light On — HDMI Source is Active on the HDMI input

Light Oﬀ — HDMI Source is not Active, or HDMI input does not sense

active HDMI Source

Transmitter Back Panel:

• HDBT OUT category cable input

• ACTIVITY LED

Light On — Transmitter is sending the signal to the Receiver

Light Oﬀ — Transmitter is not sending a signal

• DC/12V — power supply input

• Power LED

Light On — Power Supply/POC Connected and Unit is operating

Light Oﬀ — Power Supply is not connected, or no power is present

Panel Descriptions

Receiver Front Panel:

• SERVICE USB input — For service & ﬁrmware updates only; Do not use.

• IR Transmitter input

• IR Receiver input

• HDMI OUT input

• SYNC LED

Light On — HDMI Source is Active on the HDMI input

Light Oﬀ — HDMI Source is not Active, or HDMI input does not sense

active HDMI Source

Receiver Back Panel:

• HDBT IN category cable input

• ACTIVITY LED

Light On — Receiver has an active signal from the Transmitter

Light Oﬀ — Receiver does not have an active signal from the Transmitter

• DC/12V — power supply input

• Power LED

Light On — Power Supply/POC Connected and Unit is operating

Light Oﬀ — Power Supply is not connected, or no power is present

Connections and Operations

1. Connect an HDMI input source into the RED-EXT-4K-HDBASET Transmitter HDMI IN input

2. Connect an HDMI from a display into the RED-EXT-4K-HDBASET Receiver HDMI OUT input

3. Connect a single Category 5e/6/7 cable to the Transmitter HDBT OUT input, then connect

the other end of the category cable to the Receiver HDBT IN input

4. Insert the DC end of the power supply into either the Transmitter or the Receiver of the

RED-EXT-4K-HDBASET — the opposite unit does not need to be plugged in as it features

Power over Cable (PoC)

5. The units automatically power up when plugged in

Connection Diagram:

IR Conguration

IR communication can be sent two ways:

1. Downstream (from Transmitter)

a. Plug an IR Receiving Eye directly into the IR RX port of the Transmitter to

pass infrared signals to the IR TX port on the Receiver

b. Connect an IR Emitter or Direct IR Input to the IR TX port of the Receiver

2. Upstream (from Receiver)

a. Plug an IR Receiving Eye into the IR RX port of the Receiver to pass infrared

signals to the IR TX port on the Transmitter

b. Connect an IR Emitter or Direct IR Input to the IR TX Port of the Transmitter

Troubleshooting

TRANSMITTER

No power LED

• Ensure power supply unit is sending proper voltage

• If using POC, ensure that the unit sending POC is connected to power

• If using POC, try powering the unit directly to ensure unit operates stand alone

No HDMI LED

• Plug Source directly into Display to ensure operability

• Change the resolution of the source device to 1080p or 4K30 (No HDR)

• Set a canned EDID; Source may require power cycle

• Swap HDMI cable between Transmitter and Source

— HDMI Handshakes with cables under 2 meters may not sync properly

No HDBaseT Extension

• Check the connecting cable length as the Max Distances are 40M at 4K or 70M at 1080p;

HDBaseT recommends Cat 6A; Cat 6 and Cat 5e may experience a 5-20% loss of distance

• Remove excess service loops and bundles of cable. HDBaseT recommends up to 6 runs of

Cat cabling in a single bundle

• Bypass all patch-panels and punch down blocks

• Re-terminate connectors; IP continuity testers may indicate correct pinouts, however,

HDBaseT signals are transmitted diﬀerently than ethernet signals

RECEIVER

No power LED

• Ensure power supply unit is sending proper voltage

• If using POC, ensure that the unit sending POC is connected to power

• If using POC, try powering the unit directly to ensure unit operates stand alone

No HDMI LED

• Plug Source directly into Display to ensure operability

• Change the resolution of the source device to 1080p or 4K30 (No HDR)

• Set a canned EDID; Source may require power cycle

• Swap HDMI cable between Receiver and Source

— HDMI Handshakes with cables under 2 meters may not sync properly

No HDBaseT Extension

• Check the connecting cable length as the Max Distances are 40M at 4K or 70M at 1080p;

HDBaseT recommends Cat 6A; Cat 6 and Cat 5e may experience a 5-20% loss of distance

• Remove excess service loops and bundles of cable. HDBaseT recommends up to 6 runs of

Cat cabling in a single bundle

• Bypass all patch-panels and punch down blocks

• Re-terminate connectors; IP continuity testers may indicate correct pinouts, however,

HDBaseT signals are transmitted diﬀerently than ethernet signals

Warranty Information

• This warranty applies to US Residents who purchase from an authorized RED ATOM Dealer.

RED ATOM media distribution products are covered against defects in materials and

workmanship for 1 year from date of purchase.

• Within the warranty period, RED ATOM will repair or replace the defective component or product,

at its sole discretion.

• For warranty service:

— For RED ATOM media distribution products that were professionally installed, contact your

installer directly.

— For all other service requests, contact RED ATOM at info@redatomproducts.com.

• For all warranty service requests, you must supply a copy of your original receipt and installation

service order if applicable. If your product must be shipped to RED ATOM for inspection, you will

be responsible for the shipping charges. For warranty replacements, RED ATOM will ship product

back to you for free.

• RED ATOM disclaims any liability for modiﬁcations, improper installations, accidental damage,

or failure to follow care instructions provided by RED ATOM. To the maximum extent permitted

by law, RED ATOM disclaims any other warranties, expressed or implied, including warranties of

ﬁtness for a particular purpose and warranties of merchantability. RED ATOM will not be liable

for any damages arising out of the use of, or inability to use, RED ATOM. This warranty gives

you speciﬁc legal rights, and you may also have other rights which vary from state to state.

Speciﬁcations are subject to change without prior notice.

Troubleshooting (continued)

IR TRANSMISSION

• The Visible IR Emitters can be used to ensure signal is being sent from one point to the other

www.redatomproducts.com

Questions? Contact us at info@redatomproducts.com

Inhaltsverzeichnis

Andere RED ATOM Extender Handbücher

RED ATOM

RED ATOM RED-EXT-4K-HDMI Bedienungsanleitung

Beliebte Extender Handbücher anderer Marken

SY HDBT-60T Bedienungsanleitung

Appsys ProAudio

Appsys ProAudio ADX-16 Bedienungsanleitung

Atlona

Atlona RS232 Bedienungsanleitung

IDK

IDK OPF-TH1000-A Bedienungsanleitung

Enable-IT

Enable-IT 824WP Bedienungsanleitung

Worx

Worx Landroid RadioLink WA0864 Technisches Datenblatt

TP-Link

TP-Link TL-WA730RE Bedienungsanleitung

Camplex

Camplex CMX-HDMI-SFPL Bedienungsanleitung

SC&T

SC&T HE03-4K Bedienungsanleitung

Marmitek

Marmitek MegaView70 Bedienungsanleitung

Samsung

Samsung SCS-26UC4 Bedienungsanleitung

Foxun

Foxun SX-GES24 Bedienungsanleitung

MuxLab

MuxLab 500771 Bedienungsanleitung

foxunhd

foxunhd SX-AEX01 Bedienungsanleitung

TERK Technologies

TERK Technologies LFIRX2 Bedienungsanleitung

Devolo

Devolo Audio Extender Handbuch

Edimax

Edimax EW-7438RPn V2 Bedienungsanleitung

Shinybow USA

Shinybow USA SB-6335T5 Bedienungsanleitung