The logger does not transfer data:
• Check that there is data on the logger, 11’ LED should be in light
green.
• Check the mobile device hotspot. Try to nd it with another
device. The hotspot goes off in a while, if there is no data
transfer.
• Check that the hotspot is set to use 2.4GHz band. It is valid for
Android and Apple devices.
• Check the hotspot password. It must be reses638.
• Shutdown the logger and start again. Repeat this a couple of
times.
• Try to keep logger and mobile device close to each other.
• Try to connect the logger to another mobile device with ReSES
Communicator.
• If you use local WiFi for data transfer check the rewall settings.
If none of the actions above help, please contact technical support
for assistance (support@relianeering.com).
SES Logger LEDs status
LEDs Colour Description
All White
ashing
slowly
The logger is in idle mode.
12’
Green CM Point UID (RFID) has been scanned successfully. The user has
а few seconds to press the button and await measurement.
1’
Green
Long measurement mode. If 12', and 1' are green, the CM Point
UID has been scanned two consecutive times. The user has a few
seconds to press the button and awaits 30 seconds measurement.
Wait for a while to exit from the long measurement mode.
2’
Green
Long measurement mode. If 12', 1', and 2' are green, the CM Point
UID has been scanned three consecutive times. The user has a few
seconds to press the button and await 60 seconds measurement.
Wait for a while to exit from the long measurement mode.
3’
Green
Long measurement mode. If 12', 1', 2', and 3' are green, the CM
Point UID has been scanned four consecutive times. The user has
a few seconds to press the button and await 180 seconds measure-
ment. Wait for a while to exit from the long measurement mode.
4’
Green
Long measurement mode. If 12', 1', 2', 3', and 4' are green, the CM
Point UID has been scanned ve consecutive times. The user has
a few seconds to press the button and await 300 seconds measure-
ment. Wait for a while to exit from the long measurement mode.
1’
Blue The measurement is initiated and logger is settling mode for 5
seconds.
2’ до
12’ Blue
Show the progress of measurement. First starts
2’ and in 3 seconds all LEDs become blue. NOTE: For the Long
measurement mode, it will take more time for all LEDs to become
blue. After completing the measurement, all LEDs are blue and start
fading until the signal is processed and stored in the logger memory.
All Flashing
shortly
in green
Data collection from the CM Point has been completed. The logger
goes to idle mode.
2’
Red System Error. Sensor is not connected. Cable or sensor are
damaged.
2’
Blue FW is updating. After completing the logger shut downs.
10’
Yellow The battery level is below 20%.
10’
Red Critical battery level. Recommend to charge immediately.
Relianeering AB 12 Simple – Easy – Smart Relianeering AB 13 Simple – Easy – Smart
