RELM RPV516 Bedienungsanleitung
ÞßÔ²ú
TWO-WAY RADIO
TM
RPV516/RPU416
Owner's Manual
RPV516/RPU416
Owner's Manual
TM
1
OWNER’S MANUAL
RELM Wireless Corporation
Thankyou!
We are grateful that you choose RELM for your
land mobile applications . We believe this easy-
to-use transceiver will provide dependable
communications to keep personnel operating at
peak efficiency . Please read and understand this
manual carefully for efficient operation.
Applied model:
RPV516: VHF FM Transceiver
RPU416: UHF FM Transceiver
268ACManual.pm6 01-11-21, 11:061
RELM Wireless Corporation
OWNER’S MANUAL
Contents
User Safety, Training, and General Information ......................1
Compliance with RF Energy Exposure Standards...................1
FCC Compliance .....................................................................3
Precautions ............................................................................4
Preparations...........................................................................4
Supplied Accessories...............................................................5
Battery/Antenna and Other Accessories ............................5
Charging the Battery................................................................5
Installing/Removing the Battery ..............................................6
Installing the Antenna..............................................................7
Installing the Belt Clip.............................................................7
Installing the Additional Speaker/Microphone........................7
Getting Acquainted ...............................................................7
Basic Operation.....................................................................8
Auxiliary Functions ..............................................................9
Time-out Timer ....................................................................... 9
Battery Save ............................................................................9
Low Battery Warning ............................................................10
Monitor .................................................................................10
CTCSS/DCS ..........................................................................10
TwoTone Signaling................................................................10
Channel Scan ..........................................................................12
Busy Channel Lockout ..........................................................12
Optional Accessories ..........................................................13
Troubleshooting ..................................................................13
Frequency Chart ................................................................14
268ACManual.pm6 01-11-21, 11:062
OWNER’S MANUAL
RELM Wireless Corporation
User Safety, Training, and General Information
READ THIS IMPORTANT INFORMATION ON SAFE AND
EFFICIENT OPERATION BEFORE USING YOUR RELM
HANDHELD PORTABLE TWO-WAY RADIO.
Compliance with RF Energy Exposure Standards
Your RELM two-way radio is designed and tested to comply with a
number of national and international standards and guidelines (listed
below) regarding human exposure to radio frequency electromag-
netic energy. This radio complies with the IEEE (FCC) and ICNIRP
exposure limits for occupational/controlled RF exposure environ-
ment at duty cycles of up to 50% talk-50% listen and should be used
for occupational use only. In terms of measuring RF energy for
compliance with the FCC exposure guidelines, your radio radiates
measurable RF energy only while it is transmitting (during talking),
not when it is receiving (listening) or in standby mode.
Note: The approved batteries supplied with this radio are rated
for a 5-5-90 duty cycle (5% talk-5% listen-90% standby),
even though this radio complies with the FCC occupational
RF exposure limits at duty cycles of up to 50% talk.
Your RELM two-way radio complies with the following of RF
energy exposure standards and guidelines:
•United States Federal Communications Commission, Code of
Federal Regulations; 47CFR part 2 sub-part J
•American National Standards Institute (ANS)/Institute of
Electrical and Electronic Engineers (IEEE) C95. 1-1992
•Institute of Electrical and Electronic Engineers (IEEE) C95. 1-
1999 Edition
•International Commission on Non-Ionizing Radiation Protection
(ICNIRP) 1998
268ACManual.pm6 01-11-21, 11:063
RELM Wireless Corporation
OWNER’S MANUAL
•Ministry of Health (Canada) Safety Code 6. Limits of Human
Exposure to Radiofrequency Electromagnetic Fields in the
Frequency Range from 3kHz to 300GHz, 1999
•Australian Communications Authority Radiocommunications
(Electromagnetic Radiation-Human Exposure) Standard 1999
(applicable to wireless phones only)
Operational Instructions and Training Guidelines
To ensure optimal performance and compliance with the occupa-
tional/controlled environment RF energy exposure limits in the
above standards and guidelines, users should transmit no more than
50% of the time and always adhere to the following procedures:
Transmit and Receive
To transmit (talk), push the Push-To-Talk (PTT) button; to re-
ceive, release the PTT button.
Hand-held radio operation
Hold the radio in a vertical position with the microphone one to
two inches (2.5 to 5 cm) away from the lips.
Body-worn operation
•Always place the radio in a RELM approved clip, holder, hol-
ster, case, or body harness for this product. Use of non-RELM-
approved accessories may exceed FCC RF exposure guidelines.
•If you do not use a RELM approved body-worn accessory and are
not using the radio in the intended use position in front of the
face, then ensure the antenna and the radio are kept 2.5 cm (one
inch) from the body when transmitting.
Antennas & Batteries
•Use only RELM approved, supplied antenna or RELM approved
replacement antenna. Unauthorized antennas; modifications,
or attachments could damage the radio and may violate FCC
regulations.
268ACManual.pm6 01-11-21, 11:064
OWNER’S MANUAL
RELM Wireless Corporation
•Use only RELM approved, supplied batteries or RELM approved
replacement batteries. Use of non-RELM-approved batteries
may exceed FCC RF exposure guidelines.
Approved Accessories
For a list of RELM approved accessories see the accessories page of
this user manual or visit the following website which lists approved
accessories: http://www.RELM.com
FCC Compliance
This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular instal-
lation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equip-
ment off and on, the user is encouraged to try to correct the inter-
ference by one or more of the following measures:
•Reorient or relocate the receiving antenna.
•Increase the separation between the equipment and receiver.
•Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
•Consult the dealer or an experienced radio/TV technician for
help.
Industry Canada Compliance
This Class B digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe B est conforme à la norme
NMB-003 Canada.
268ACManual.pm6 01-11-21, 11:065
RELM Wireless Corporation
OWNER’S MANUAL
Only qualified technicians are allowed to maintain this product.
Do not use the transceiver or charge a battery in explosive areas
such as coal gas, dust, steam, etc.
Switch OFF the transceiver while refueling or parking at gas station.
Do not modify or adjust this transceiver without permission.
Do not expose the transceiver to direct sunlight over a long time,
nor place it close to heating source.
Do not place the transceiver in excessively dusty, humid areas, nor
on unstable surfaces.
Safety: It is important that the operator is aware of and
understands hazards common to the operation of any
transceiver.
Please carefully take the transceiver out of the box. We recom-
mend that you confirm the items listed in the following table before
discarding the box. If any items are missing or have been damaged
during shipment, file a claim with the carrier immediately.
Preparations
Precautions
FCC Requirements
Your radio must be properly licensed by the Federal Communications
Commission prior to use. Your RELM Wireless dealer can assist
you in meeting
these requirements. Your dealer will program each radio with your
authorized frequencies, signaling codes, etc., and will be there to
meet your communications needs as your system expands.
268ACManual.pm6 01-11-21, 11:066
OWNER’S MANUAL
RELM Wireless Corporation
Supplied Accessories
Item Quantity
Antenna (*) 1
BCRP-Battery Charger 1
AC Adapter 1
BPRP1100-Battery Pack (7.2V 1100mAH) 1
Belt Clip 1
Owner’s Manual 1
Strap 1
*Note: The RPV516B Antenna mark is shamrock.
The RPV516A Antenna mark is grass green.
The RPU416A Antenna mark is milk white.
Charging the Battery
The battery is not charged in factory, charge it before use. When
first charging the battery after purchase or extended storage (more
than 2 months), battery capacity is lower than its normal operating
capacity. Repeating the charge/discharge cycle two or three times,
its capacity will increase to normal.
Caution:
Do not recharge the battery if it is already fully charged. Doing so
may shorten the life of the battery or cause damage to it.
After recharging the battery pack, disconnect it from the charger,
otherwise, battery life will be shortened as a result of overcharge.
Please turn OFF the power of the transceiver with a battery before
charging. Using the transceiver while charging its battery will
interfere with proper charging.
Battery/Antenna and Other Accessories
268ACManual.pm6 01-11-21, 11:067
RELM Wireless Corporation
OWNER’S MANUAL
When the operating time of the radio continually decreases even
though the battery has been fully and properly charged, replace the
battery with a new battery.
Do not short the battery terminals or dispose of the battery by fire.
Never remove the case from the battery pack.
Slide the battery pack or the
transceiver with a battery pack into
the charger.
•Make sure the battery pack
contacts are in contact with the
charging terminals .
•Rapid charging starts when the
idicator light is red and it
finishes when the light is green.
Installing/Removing the Battery
Match the four grooves of the battery pack
with the corresponding guides on the back
of the transceiver .
Slide the battery pack along the back of
the transceiver until the release latch on
the base of the transceiver locks .
To remove the battery pack , pull back on
the release latch and slide the pack away
from the transceiver .
268ACManual.pm6 01-11-21, 11:068
OWNER’S MANUAL
RELM Wireless Corporation
Installing the Antenna
Hold the antenna at its base, screw the antenna into the connector
on the top panel of the transceiver.
Installing the Belt Clip
Position the edge of belt clip on the corresponding grooves on the
top of the battery pack. Push the belt clip along the back of the
battery pack until the release latch locks.
To remove the belt clip, pull back on the release latch located
between the battery pack and the belt clip, and slide the belt clip
away from the battery pack.
Installing Additional Speaker/Microphone
Remove the cover of the speaker/microphone jacks,then insert the
speaker/ microphone plugs into the speaker/microphone jacks.
Note: The transceiver is not fully water resistant while using speaker/
microphone.
GettingAcquainted
268ACManual.pm6 01-11-21, 11:069
Andere Handbücher für RPV516
1
Dieses Handbuch passt für folgende Modelle
2
Inhaltsverzeichnis
Andere RELM Zwei-Wege-Funkgerät Handbücher
