2. The GoPro SSID is not listed at all on the R1+.
The R1+ connects to GoPro cameras by connecting to its MAC Address. We
recently found that some Hero5 Black units use a MAC address not listed in
our R1+ source code. We have included all remaining MAC addresses in our
new 1.2.1 firmware, so you should have no issues connecting after updating
firmware.
b. While updating the R1+ firmware to version 1.1.0, It shows this
screen.
- This is caused by only adding 1 of the 2 .bin file required to perform the 1.1.0
update (BOTH r1_110.bin and r1+_110.bin MUST be placed into the R1+
folder separately)
- Also, please be advised, when updating the R1/R1+ firmware, after you copy &
paste the firmware update file to the R1/R1+ folder, you must disconnect the
R1/R1+ from your computer before rebooting it or you may run into an error.
Please keep this in mind, and advise it to your customers if the situation arises.
c. My R1+ and Hero5 are paired, but they are not connected
automatically after rebooting.
- Make sure both Wi-Fi and Bluetooth are enabled, pair with Hero5 Black using
GoPro Capture APP, and connect with your R1+ using the ID/PASSWORD
shown on your Hero5 Black.
