RE310P+_New_DSC-Compat_PIR_InstructionsPage 1 of 3 30-Oct-14
24-Hour Tech Support Line: (715)808-0164
www.ResolutionProducts.com
RE310P+ DSC-Compatible PIR Motion,
TWO 60-Pound-Do -Immune
Features
• PYROFLEX™ IR sensor and HighBar™ signal processing or superior per ormance
• Unparalleled Pet Immunity and Catch per ormance
• 44 oot range and 90 degree ield o view (45 degrees to each side)
• Mountable on Flat-wall, 45 degree corner, or swivel/gimbal (sold separately).
• Unique external contact on separate, but related, wireless ESN
• Cover tamper.
• Strong, reliable RF signal.
• 6-8 year battery li e on CR123A battery.
• Low Battery indication.
Key Instructions
• Mount at 7.5 oot height or optimum per ormance between: Catch
per ormance, Pet Immunity and False Alarm prevention.
• Motion Sensitivity:
Jumper on BOTH PINS or Normal sensitivity
Jumper on ONLY 1 PIN or High sensitivity.
• External contact activation (enabling):
Insert battery while holding Tamper switch.
Seal wire routing hole.
• Make sure bug / insulation foam is installed
• Enrolling:
Enter Wireless Enrollment Mode in DSC Panel.
PIR: Open tamper switch. ESN = 3xx xx0
External Contact: Trip contact ESN = 2xx xx1 (x’s same as PIR’s)
Con irm ESN, Enter Zone # and Zone Type on DSC panel.
• LED Walk Test: Press Tamper or 3 minute test:
LED lights when motion sensed
Sensor re-calibrates or 10 to 30 seconds a ter each LED blink.
It will not transmit during re-calibration.
So wait about 30 seconds be ore irst test, and 30 seconds between
tests.
Wireless transmissions sent or each detection, so walk test can be used
or panel operation test as well
RE310P+_New_DSC-Compat_PIR_InstructionsPage 2 of 3 30-Oct-14
24-Hour Tech Support Line: (715)808-0164
www.ResolutionProducts.com
Operation
• Motion sends wireless transmission a ter 2 or 3 (select via jumper) pulses.
• Motion stops (locks out) transmitting wireless sensor alarms for 3 minutes
after sending an alarm transmission. This is to conserve battery li e.
• Tamper, when cover is opened (only Motion reports tamper, not Ext Contact).
• Supervisories, every hour (including Ext Contact, i activated).
pecifications
Pet Immunity: Two 60 pound dogs
Mounting hardware: #4 or #6 screws
Mounting height: 7.5 t
Replacement Battery: CR123A 1550mAH
Temperature Range: 0F to 120F
Housing dimensions: 3.5x2.4x1.7 inches
Speci ications subject to change without notice.
Use this model or ALL pet situations.
RE020 Horizontal Beam Lens also available or unique situations.
Internal Picture
LED
Jumper
10 ft
20 ft
30 ft
40 ft
+
Walk Test
witch
56 ft
56 ft
56 ft
40 ft
Foam
Contacts
