19. Do not store cans of fuel or refill the fuel tank in any place where there is a
boiler, stove, wood fire, electrical sparks, welding sparks, or other sources of
heat or fire which might ignite the fuel.
20. If any fuel spillage occurs during refuelling, use a dry rag to wipe up spills and
allow remaining fuel to evaporate before turning the engine on again.
21. If you have spilt fuel on yourself or on your clothes, change your clothes and
wash any part of your body that has come in contact with fuel before turning
the engine on again.
22. If fuel is ignited, put out the fire with a dry powder fire extinguisher.
23. If the fuel tank is drained, this should be done outdoors.
4. Getting started
LONGER TIME UNUSED MACHINE RESTARTING
Unused machine be in storage for longer than 90days, the ignition coil be not damaged,
it’s only carburetor issue. Please follow these Instructions to restart the machine.
1. Check either the fuel pipe aging or cracking, if any, easy to buy new one for
replacement at local store.
2. Check either the fuel pipe joint of carburetor loosening or aging, if any, cut
the pipe joint a little bit to rejoin as well.
3. Please pull the starting rope 5-8 times before fuel refilling to the carburetor
is in an operating state.
4. Refilling the fuel and then restart the machine according to the cold start mode
5. Do not operate the product indoors, it produces poisonous exhaust fumes whilst
the engine is running and may be colorless and odourless.
6. Do not wrap the recoil starter rope around your hand whilst starting the product.
This may result in injuries to your hand or fingers.
7. Do keep handles dry, clean, and free from oil and grease. Greasy, oily handles
are slippery causing loss of control.
8. Do not operate the product with a slack chain. A slack chain may jump off the
guide bar and cause serious or even fatal injury.
9. Do not operate the product with one hand! Serious injury to the operator or
bystanders may result from one handed operation.
10. Keep all parts of the body away from the saw chain when the chain saw is
operating. Before you start the chain saw, make sure the saw chain is not
contacting anything and free from obstructions. A moment of inattention while
operating chain saws may cause entanglement of your clothing or body with
the saw chain.
11. Do shut off the engine before setting the product down.
12 . Before using the product and after any impact or dropping, check for signs of
wear or damage and repair as necessary.
5. Operation
1. When sawing, ensure the product does not touch any foreign materials such
as rocks, fences, nails etc. Such objects may be flung out and could result in
damage to the product or serious personal injury or even death.
2. Never operate the product on a ladder or other insecure support.
6
For Customer Service:
