Riverlea Rustics NEBRASKA Bedienungsanleitung

NEBRASKA

ASSEMBLY INSTRUCTIONS

BASE SIZE: 3.600m x 2.490m

• Baery Drill

• Riveter

• Hammer

• Tape Measure

• Ladder

• Skillsaw

• Level

• Screwdriver - Flat

• 3/8 Hex Drive bit

• 8mm Hex Drive bit

• Drill Bit 3.2mm

• Socket Set

• Read all instrucons carefully.

• Idenfy all parts and check quanes against checklist.

• Do not aempt to build your shed in high winds.

• Beware of sharp edges.

• Protect your eyes and ears.

• Use electric tools with care. Use a Safety Trip Switch.

• It is easier and quicker if this shed is erected by two people.

• Your shed must be level. Achieve this by either levelling the

ground or by using blocks.

Tools Required:

Select your site:

Safety:

Before you start:

PG 1

NEBRASKA

Descripon Size Qty

PACK ONE - SHED

Standard Door 895 x 1780 1

Std Wall Panels 1200 x 1877 5

Front Wall Panel 300 x 1877 1

End Wall Panels (L/H) 1200 x 2389 2

End Wall Panels (R/H) 1200 x 2389 2

Door Lintel 110 x 900 1

Cedar Corner Clashings 85 x 17 x 1902 4

30 x 17 Std Cedarbead 30 x 17 x 1877 3

15 x 17 Std Cedarbead 15 x 17 x 1877 2

30 x 17 Gable Cedarbead 30 x 17 x 2389 2

Silicone Tube 300g 2

Roof Truss 535 x 2490 2

Barge Flashings 85 x 40 x 2960 2

Temporary Door Stop 45 x 45 x 900 1

Roof Sheets 845 x 1450 10

Ridge Flashing 175 x 2010 2

15mm Packer 15 x 45 x 1740 1

Hardware Pack

Tek Screws 14G x 75mm, CL4 50

Framing Nails 75 x 3.15mm 80

Bead Nails 50 x 2.5mm 60

Galv Clouts 30 x 2.5mm 50

Colour Rivets 3.2 x 8.2mm 50

Roong Screws and Washers 50mm 30

Padbolt and Keeper 1

Padbolt Screws 32 x 8g 6

Instrucons 1

Oponal

Building Paper (Roof + 20 clouts) 1370 x 7500 1

Clear Roof Panel (Panel replaces roof sheet) Qty

PACK TWO - STIFFENERS (& FLOOR if required)

Purlins (Top) 100 x 25 x 3740 2

Purlins (Boom) 50 x 25 x 3740 2

Spoung 3735mm 2

Seners 45 x 45 x 3600 2

Floor Joists 70 x 45 x 3590 5

Floor Boards 150 x 19 x 2480 24

Floor Nails 50 x 2.5mm 240

Packed by: Date: / /

NEBRASKA PARTS LIST

PG 2

PG 3

Step 1: Establish size of shed and excavate sucient area. Re-

member to allow for rear roof overhang up to 150mm, and

120mm on each end.

Step 2: Ensure that the base substrate is compacted rmly.

We suggest that the slab should be 80mm thick in the middle

and 100mm thick around the edges.

Step 3: Lay boxing to the required size, the raised slab

size should be 3585 x 2475mm and at least 30mm

above the ground line.

Step 4: Lay plasc sheeng if required. Plasc sheeng under slab

will prevent moisture coming through from underneath.

Step 5: Pour concrete and screed ush

Building a Raised Concrete Base

100mm

80mm

100mm

NEBRASKA CONCRETE FLOOR OPTION

PG 4

NEBRASKA FLOOR OPTION

Step 1: Lay out oor joists, spacing them evenly

as shown. Using 50mm ooring nails, nail a oor

board on each end, ensuring ends are ush with

joists. Make sure oor is level and joists are sup-

ported at 1240mm centres.

Step 2: Lay out remaining oor boards. Measure

diagonals to ensure measurements are equal (I.e.

oor is square). Rip down last oor board to suit

gap, and nail o oor with 50mm ooring nails

(10 nails per board).

Step 3: Unpack panels and idenfy wall panels

and door posions as per the wall plan located

on page 5.

Select two panels that go either side of a corner

(gable and standard panel) and stand together.

Example: R (standard) and LG (Gable)

Located on the boom plate of each wall.

PG 5

NEBRASKA WALL PLAN

NEBRASKA

WALL PLAN

1200RG

1200LG

1200 L

300

1200 R

1200RG

1200LG

1200 R

1200 C

1200 L

15 x 17mm Std Cedar bead

30 x 17mm Std Cedar bead

30 x 17mm Gable Cedar bead

Corner Clashing

45 x 20mm Packer

Tek Screws (To secure Walls to Floor)

Truss Locaon

Please note: The walls are not screwed down to the oor unl all the walls

are erected, the roof is in place and the door is about to be installed.

The Boom Plate of each wall will be labelled L, R, C, LG or RG based on

the posion it goes in the wall plan.

Step 4: Screw wall panels together using 75mm tek

screws (3 per low connecon, 4 per high connecon),

ensuring gable walls are inside the standard walls as

per the wall plan on the previous page.

Step 5: Silicone edge of weatherboards on the stand-

ing panel, and lying your next wall down silicone the

connecng edges weatherboards. Nail the bead to the

laid down panel. ( 4 bead nails per standard bead, 5

per gable bead)

Make sure bead is properly sealed to avoid leaks.

Note: On standard panels only, top of bead is bevelled

to allow for slope of roof.

Step 6: Silicone and nail remaining beads on each panel. Screw panels together us-

ing 3 tek screws per join and 4 on the longer joins on gable panels as menoned

above.

PG 6

NEBRASKA WALL INSTALLATION

PG 7

NEBRASKA DOOR LINTEL

Step 8: Using 75mm framing nails, nail both top

plate seners into standard wall panels studs, as

shown using 2 nails per each end stud, and 1 nail

for each remaining stud. Ensure ends are evenly

spaced before nailing.

Step 9: Using 30mm clouts nail top cedar boards

to seners (2-3 nails per board). Predrill holes to

stop boards from spling.

NEBRASKA STIFFENERS

Step 7: Using the 15mm Packer screw the door

lintel into place, using 2 x 75mm tek screws at

each end. Screwing though the stud into the

lintel.

Tip: Using the screw to predrill a hole before

aempng to screw into the lintel will make this

easier.

Above Lintel from the outside, below Lintel from

the inside.

PG 8

NEBRASKA CORNER CLASHINGS

NEBRASKA ROOF

Step 11: Posion roof trusses over the join of

the panels on the front and back walls, as

shown in the wall plan. Using 75mm framing

nails, nail the truss to the seners. Predrill the

truss as to avoid spling the mber.

Refer to Wall Plan on page 5 for correct truss locaon.

Step 12: Posion purlins on roof. (Top Purlins

100mm, boom purlins 50mm) Top purlins

should be together and boom purlins should

be against the Seners. Using 75mm framing

nails, predrill then nail purlins into top of gable

end panels and truss (2 nails per join).

Check that overhangs are even all around.

Condensaon can form on the under side of shed roof. If

building paper is required, t now. Nailing to the purlins with

the clouts provided.

Please note: The image above has one truss, this

model requires two.

Please note: The image above has one truss, this

model requires two trusses.

Step 10: Ensuring the clashing is ush at the top.

Silicone and nail corner clashings on all corners as

shown using 4 x bead nails per clashing.

Silicone both edges where the clashing meets the

weatherboards to ensure this doesn't leak.

PG 9

NEBRASKA ROOF

Step 13: Ensure shed is square, by measuring

diagonals at top corner of wall panels.

Step 14: Posion rst full sheet with rib ush with

end of purlins and top of sheet ush with the top

of the purlin.

Tack top of the sheet into the top purlin using a

30mm clout through the pan. Using a 35mm

Roong Screw with Washer, screw through the

rst full rib into the boom purlin to a depth of

approximately 10mm.

Tip: Predrilling with a 3mm drill bit may make this easier.

First full Rib

Pan

Step 15: Lay out remaining full roof sheets, with

sucient overlap that the last lip lines up with

the opposite ends purlins.

This may require overlapping mulple ribs.

Rivet these sheets together, 3 rivets per join, to

make 1 large roof panel as shown in photo.

Rivet top, middle and boom.

Tack remaining top corner and screw the boom

corner ensuring edge of sheet is ush with end of

purlins and height is correct.

Ensure purlins are straight, Nail through every

fourth pan using 30mm clouts into the top purlin,

using 35mm roong screws with washers screw

through every fourth rib into the boom purlin.

Tip: If you have string or a long piece of mber use it as a

guide to screw on a straight line.

Inhaltsverzeichnis

Andere Riverlea Außenlagerung Handbücher

Riverlea

Riverlea SmartStore SM2525 Bedienungsanleitung

Riverlea

Riverlea SmartStore SM2015 Bedienungsanleitung

Riverlea

Riverlea Duratuf Garrison Sheds PL63 Bedienungsanleitung

Riverlea

Riverlea SmartStore SM2007 Bedienungsanleitung

Riverlea

Riverlea SmartStore SM2515 Bedienungsanleitung

Riverlea

Riverlea Duratuf Garrison Sheds PL84 Bedienungsanleitung

Riverlea

Riverlea CEDAR SHED NOTTINGHAM Bedienungsanleitung

Riverlea

Riverlea Duratuf Guardian Sheds GL57 Bedienungsanleitung

Riverlea

Riverlea CEDAR SHED COVENTRY Bedienungsanleitung

Riverlea

Riverlea Duratuf Garrison Sheds PL46 Bedienungsanleitung

Riverlea

Riverlea Duratuf Garrison Sheds PL64 Bedienungsanleitung

Riverlea

Riverlea DURATUF Sentry SL2015 Bedienungsanleitung

Riverlea

Riverlea Smart Store SM2010 Bedienungsanleitung

Riverlea

Riverlea Duratuf KIWI MK4B Bedienungsanleitung

Riverlea

Riverlea Duratuf Gurdian Sheds GS62 Bedienungsanleitung

Riverlea

Riverlea SmartStore SM2020 Bedienungsanleitung

Riverlea

Riverlea SmartStore SM3025 Bedienungsanleitung

Riverlea

Riverlea SmartStore SM1520 Bedienungsanleitung

Riverlea

Riverlea Duratuf Garrison Sheds PL36 Bedienungsanleitung

Riverlea

Riverlea Duratuf KIWI SHEDS MK4C Bedienungsanleitung

Riverlea

Riverlea Smartstore SS2020 Bedienungsanleitung

Riverlea

Riverlea Duratuf KIWI SHEDS MK4A Bedienungsanleitung

Riverlea

Riverlea Duratuf Garrison Sheds PS62 Bedienungsanleitung

Riverlea

Riverlea SmartStore SS2520 Bedienungsanleitung

Beliebte Außenlagerung Handbücher anderer Marken

USP

USP DURAMAX 10 Ft x 8 Ft StoreMax Plus Bedienungsanleitung

TYGO

TYGO Nyland Bedienungsanleitung

Duratuf

Duratuf GL105 Bedienungsanleitung

Viking

Viking SD5300SS Technisches Handbuch

USP

USP DURAMAX Apex Pro 10.5 Ft x 8 Ft 40116 Bedienungsanleitung

ModuLaro

ModuLaro Lojo WC202200 Bedienungsanleitung

Lifetime

Lifetime 6418 Bedienungsanleitung

rollaway container

rollaway container ARPCA24 Bedienungsanleitung

Duratuf

Duratuf Havelock Bedienungsanleitung

X-METAL

X-METAL 4065 Bedienungsanleitung

Outdoor Life Products

Outdoor Life Products FP2030 F Bedienungsanleitung

Royalcraft

Royalcraft Faro 295L Storage Box Bedienungsanleitung

Rubbermaid

Rubbermaid 5L45 Bedienungsanleitung

garofalo

garofalo TUSCANY EVO Bedienungsanleitung

OLT

OLT GS84D-FJ-Plywood Bedienungsanleitung

Duratuf

Duratuf Kiwi MK1 Bedienungsanleitung

Eden

Eden CA2988 Bedienungsanleitung

Palram

Palram CANOPIA RUBICON 6x10 Administratorhandbuch