RMG ACT Bedienungsanleitung
ACT –Operation & Installation Manual
1
Version 1.0 –04/19
Analog Cyclic Timer
Analogue Cyclic timer is used to switch ON & OFF the electrical devices at particular
equal or unequal time duration. There are two Rotary switches is provided to set ON & OFF
time and it is adjustable from approximately 1 minutes to 5 hours. Widely used for Hydroponic
Systems, Fogger Systems, Irrigation, Lawn sprinkler, drip house, Motor Pumps, intelligent
control of lighting equipment, fish aquarium, street lamps, garden lights decorative lighting,
hoarding lighting, glow sign board and outdoor lighting, neon signs, household electrical
appliances etc
Product Description:
Power ON/OFF switch: This switch is provided at the right lower corner to switch ON or
switch OFF the Timer unit.
Power ON LED: It indicates the power supply to the unit.
ON TIME LED: It indicates the electrical device which is connected to timer relay is in
ON.
OFF TIME LED: It indicates the electrical device which is connected to timer relay is in
OFF.
ON/OFF TIME Rotary Switch: Provided to select an ON and OFF time.
Time ranges: From 1 minutes to 5 hours.
Installation steps
Power Connection for Switch/MCB model:
Caution: Switch off the main power while doing the Power Connection steps.
Step 1: Connect Phase and neutral (AC 230V) to red and black (paired) wire of the controller
respectively as shown in the Picture1.
Step 2: Connect Blue pair cable to the switch or MCB in parallel as shown in the Picture1.
Power Connection for Starter model:
Step 1: Connect Phase and neutral (230V) to red and black (paired) wire of the controller
respectively as shown in the Picture2.
Step 2: Remove the wire which connects the start and stop button terminals. Connect one wire
of blue pair and one wire of black pair to the start button where the wire was removed as shown in the
Picture 4.
Step 3: Connect the other wire of blue pair in parallel to the same side of the start button.
Step 4: Connect the other wire of the black pair to the stop button where the wire was removed
as shown in the Picture 2.
ACT –Operation & Installation Manual
2
Version 1.0 –04/19
Connection Diagram:
Methods of programming the device:
Step 1: Use the rotary switch and set the desired ON time and OFF time.
Step 2: Power ON the device and you can see the ON operation starts first and the OFF operation next.
Note: There is no inbuilt memory to resume the operation at the time of power failure. The
product starts the ON operation from the first in such case.
In case of doubts please call 044 - 43180017 and for What’s App 9940594413 from
Monday to Saturday 10 am to 6 pm.
YOUTUBE LINK:
https://www.youtube.com/watch?v=KFGb4_D-yLg
https://www.youtube.com/watch?v=o6RMYYPcJFU
Inhaltsverzeichnis
Andere RMG Timer Handbücher
