Roberts CR9932 Bedienungsanleitung

CR9932

3 Band SingleAlarm

Night Light Clock Radio

ROBERTS

SoundforGenerations

Please read this manual before use

Controls

(Top) 3

(Left side) (Right side)

1. Dimmer switch

2. Function switch

3. Headphonesocket

4. Volume control

9. Alarm/Offbutton

10. Time button

11. Minute button

12. Hourbutton

5. Wavebandselector

6. Tuningcontrol

7. Snooze/nightlightbutton

8. Sleepbutton

12 11 10 9 8 7

If you need any further advice, please call our Technical Helpline on :-

020 8758 0338 (Mon-Fri) 2

Controls

(Front)

13. PM indicator

14. LED dial pointer

15. Battery compartment (underside)

16. Alarm indicator

16 15

Switching on and setting the time

Before using your clock radio you must first set the correct time.

1. Place the unit on a flat surface. Plug the power cord into the wall

socket and switch on.

2. The clock display will flash 12:00.

3. Press and hold down the Time Set button.

4. Whilst holding down the Time Set button press the Hour, or

Minute buttons to set the time. Release the buttons when the

correct time is reached. The clock uses a 12 hour display with a

PM indicator. Ensure that the correct 12 hour cycle is selected.

If you need any further advice, please call our Technical Helpline on :-

020 8758 0338 (Mon-Fri) 4

4. Adjust the volume by rotating the Volume control.

3.Tune in to the desired station by rotating the Tuning control.

The station frequency is indicated by the LED dial pointer.

The Wire aerial located on the rear of your clock radio is for FM

reception. The wire should be fully extended and positioned for

optimum reception.

For MW and LW reception there is a built-in ferrite aerial. Rotate

your clock radio to the position giving best reception.

2.Select the required waveband using the Waveband selector

switch.

Listening to the Radio

1. Turn on the radio by sliding the Function switch to the 'On '

position. The LED dial pointer will light up indicating that the

radio is switched on.

5. The radio can be switched off by sliding the Function switch to

the 'Off ' position.

Alarm

The alarm can be set to wake you by either the buzzer or the radio.

Setting alarm time

1. Press and hold down the Alarm/Off button.

2.Whilst holding down the Alarm/Off button press the Hour, or

Minute buttons to set the time. Release the buttons when the

correct alarm time is reached. The clock uses a 12 hour display

with a PM indicator. Ensure that the correct 12 hour cycle is

selected.

Checking the alarm time

1. To check alarm time, press and hold down the Alarm/Off button

the display will show the alarm time

If you need any further advice, please call our Technical Helpline on :-

020 8758 0338 (Mon-Fri)

Setting the alarm to wake to buzzer

1. Set the alarm time as previously described. Set the Function

switch to the 'Buzz'position. The Alarm indicator will light.

The alarm will sound every day at the preset time for 59 minutes.

To turn off the alarm until the next day press the Alarm/Off

button. To turn off the alarms permanently set the Function

selector to the 'Off'position.

Setting the alarms to wake to radio

1.Set the alarm time as previously described. Set the Function

switch to the 'Auto'position. The Alarm indicator will light.

Ensure that the volume is set to the correct level and the desired

station is tuned in.

The alarm will sound every day at the preset time for 59 minutes. To

turn off the alarm until the next day press the Alarm/Off button.To

turn off the alarms permanently set the Function selector to the

'Off'position.

Snooze control

The radio or buzzer alarm can be silenced for 7 minutes by pressing the

Snooze Light button. This sequence can be repeated whilst the alarm

is sounding.

Sleep timer

The radio can be set to turn off after a preset time has elapsed.

Press and hold down the Sleep button until the desired time is reached

(maximum 59 minutes in 1 minute steps). The radio will switch off after

the sleep time has elapsed.

To cancel the sleep function before the preset time has expired, press

the Alarm/Off button.

Dimmer Switch

TheDimmer switch located on the left side of your clock radio will allow

you to adjust the intensity of the clock display to suit room brightness.

If you need any further advice, please call our Technical Helpline on :-

020 8758 0338 (Mon-Fri)

Night light

Press the Snooze button once to turn on the night light. Press

again to turn it off. The night-light will provide a warm glow adequate

to allow movement around the room safely. It is not intended as a

reading light.

Headphones (on rear)

A Headphone Socket (3.5mm) is provided for use with either

headphones or an earpiece . Inserting a plug automatically mutes

the internal loudspeaker.

General

Donotallowthisunittobe exposed towaterorsteam. It isrecommended

that the FM band be used wherever possible as better results in terms

of quality and freedom from interference will usually be obtained than

on the MW or LW bands.

Mains supply

TheCR9932will operate from a supply ofAC230volts,50Hz only.

For your convenience this product is supplied with a plug which is

fitted with a fuse of the appropriate rating. If the plug supplied is not

suitablefor your socket outlet,it should be removedby unscrewing the

plug top, the terminal screws, and removing the cable.

Thecorrectstyleof plug to suit your household together withacorrectly

rated fuse should be fitted.

IF IN DOUBT - CONSULTA QUALIFIED ELECTRICIAN

IMPORTANT.DONOT makeanyconnection tothelargerterminalwhich

ismarkedwiththeletterEorbythesafetyearthsymbol orcoloured

GreenorGreen-and-yellow.

Thewires in themainsleadarecoloured inaccordancewiththefollowing

codes :- BLUE - NEUTRAL BROWN - LIVE

As these colours may not correspond with the coloured markings

identifyingthe terminals inyour plug, proceed as follows:-

Thewire coloured BLUE must be

connectedtotheterminalmarked

N or coloured BLACK.

The wire coloured BROWN must

be connected to the terminal

markedL or coloured RED.

Fuse

Thisapparatusmust be protected bya 3Afuse (BS1362)in a 13Aplug

(BS1363). If another type of plug is used a 5A fuse should be fitted in

theplug, adaptor or distribution board.

IF IN DOUBT - CONSULTA QUALIFIED ELECTRICIAN.

Back-up Battery (not necessary for the unit to function)

Slide the battery cover catch in the direction of the arrow. Remove the

battery cover. Fit a 9 volt IEC size 6LR61(6F22,PP3) or equivalent

battery into the compartment. Replace the battery cover.

The time and alarm settings will be retained during a temporary failure

of theAC mains supply. The LED display will not be operational. The

display will be extinguished to conserve battery life.

(Underside)

Inhaltsverzeichnis

Andere Roberts Radiowecker Handbücher

Roberts

Roberts Gemini 33 CRD-33 Bedienungsanleitung

Roberts

Roberts DreamDock 2 Bedienungsanleitung

Roberts

Roberts ORTUS 2 Bedienungsanleitung

Roberts

Roberts CR987 Bedienungsanleitung

Roberts

Roberts iDream Bedienungsanleitung

Roberts

Roberts PISA two CR9934 Bedienungsanleitung

Roberts

Roberts CR9933 Bedienungsanleitung

Roberts

Roberts CR966 Bedienungsanleitung

Roberts

Roberts CR9902 Bedienungsanleitung

Roberts

Roberts CR9980 Bedienungsanleitung

Roberts

Roberts iDream CRD-42 Bedienungsanleitung

Roberts

Roberts CR9976 Bedienungsanleitung

Roberts

Roberts DreamDock Bedienungsanleitung

Roberts

Roberts CR980 Bedienungsanleitung

Roberts

Roberts CR9916 Bedienungsanleitung

Roberts

Roberts CR9901 Bedienungsanleitung

Roberts

Roberts CR9987 Bedienungsanleitung

Roberts

Roberts GlowTime CR9952 Bedienungsanleitung

Roberts

Roberts CR9955 Bedienungsanleitung

Roberts

Roberts DAB/FM/CD Stereo Clock Radio Bedienungsanleitung

Roberts

Roberts Chronoplus 2 Bedienungsanleitung

Roberts

Roberts Pisa Three CR9935 Bedienungsanleitung

Roberts

Roberts CR9920 Bedienungsanleitung

Roberts

Roberts CRD-37 Bedienungsanleitung

Beliebte Radiowecker Handbücher anderer Marken

Denver

Denver CRQ-105 Bedienungsanleitung

Audiovox

Audiovox CE90 Bedienungsanleitung

Sony

Sony Dream Machine ICF-C763L Bedienungsanleitung

Sanyo

Sanyo DMP-P6 Bedienungsanleitung

Yamaha

Yamaha ISX-80 Bedienungsanleitung

Pyle

Pyle PLMR20W Bedienungsanleitung

Blaupunkt

Blaupunkt CR7BK Bedienungsanleitung

Philips

Philips AJ3180 Bedienungsanleitung

HoMedics

HoMedics SS-5500-2EU Bedienungsanleitung

RCA

RCA RC66i Bedienungsanleitung

Versaudio

Versaudio Vers Bedienungsanleitung

SOUNDMASTER

SOUNDMASTER UR8100 Bedienungsanleitung

Audiovox

Audiovox CE90 Bedienungsanleitung

Jensen Audio

Jensen Audio JCR-222 - AM/FM Projection Alarm Clock Radio Bedienungsanleitung

AEG

AEG MRC 4132 BT Bedienungsanleitung

Tokai

Tokai TC-155 Bedienungsanleitung

Timex

Timex T300 Bedienungsanleitung

Sony

Sony DREAM MACHINE ICF-C318 Bedienungsanleitung