Roberts R737 Bedienungsanleitung

ROBERTS

Sound for Generations

R737R737

R737

3 Band Digital Preset Portable Radio3 Band Digital Preset Portable Radio

3 Band Digital Preset Portable Radio

Please read this manual before use

All manuals and user guides at all-guides.com

all-guides.com

Controls (top panel)

STANDBY

MHz

2143 5 6 7 8 9 10 11 12 13

1415161718192021

16. FM button

17. MW button

18. LW button

19. Preset buttons

20. + 5 button

21. tandby switch

11. Liquid crystal display

12. Tuning up button

13. Telescopic aerial

14. Power button

15. Tuning down button

6. Mono button

7. leep button

8. Memory button

9. Light button

10. Tuning indicator

1. Headphone socket

2. Volume control

3. Tone control

4. tandby button

5. Mode button

All manuals and user guides at all-guides.com

Controls (LH end)

PU9-B

INPUT 240V 50Hz

OUTPUT 9V 300mA

DC 9V

PIN -ve

Liquid crystal display

22.DC ocket

STANDBY

MHz

kHz

FM MW LW

a. Waveband indicator

b. tereo indicator

c. Memory indicator

d. Low battery indicator

e. leep time indicator

f. tandby indicator

All manuals and user guides at all-guides.com

General

Do not allow this unit to be exposed to water, steam or sand. Do not leave

the unit where excessive heat could cause damage such as in a parked car

where the heat from the sun can build up even though the outside

temperature may not seem too high. It is recommended that the F band

be used were ever possible as better results in terms of quality and freedom

from interference will usually be obtained than on the W or LW bands.

Mains adaptor

Plug the adaptor into a 13A mains outlet. Plug the lead from the adaptor into

the DC socket (22). The battery will be automatically disconnected.

The mains adaptor should be disconnected from the mains supply when not

in use.

Batteries

Remove the battery cover on the base by releasing the catches and lifting

the cover up and out. Insert six IEC R14 (C size) cells into the compartment.

Replace the battery cover.

The radio switching off and the low battery indicator (d) showing in the

display are all signs that the batteries need replacing. Battery replacement

should be carried out within 2 minutes otherwise clock/memory settings will

be lost.

In order to maintain the clock and memory functions it is important that

batteries are fitted at all times.

We would recommend for economy, that the R737 is used via the

Mains adaptor whenever possible with battery operation for occa-

sional or stand-by use only.

Aerials

On F fully extend the telescopic aerial (13), angle and rotate for best

reception.

On W and LW stations are received on the built in ferrite rod aerial, rotate

the entire radio to the position giving best reception.

The telescopic aerial is inoperative on W and LW.

Headphones

A 3.5mm socket (1) is provided for use with either stereo headphones or an

earpiece. Inserting a plug into this socket automatically mutes the internal

loudspeaker.

All manuals and user guides at all-guides.com

Setting the clock

Ensure the batteries are fitted and the power switch (14) is off.

Press and hold the mode button (5) until the display starts to flash. Release

the mode button. You now have 5 seconds to start the next procedure

otherwise the display will stop flashing and return to showing normal time.

Whilst the display is flashing use the tuning up button (12) to adjust the

minutes and the tuning down button (15) to adjust the hours. After approx.

5 seconds the display will stop flashing and return to a normal time display.

The time is displayed in 24 hour format.

Search tuning

Press the power button (14) to turn on the receiver.

Select a waveband. Turn the volume control (2) until sound is audible.

Press and hold either the tuning up (12) or tuning down button (15) for more

than 1 second to start the search tuning facility. The receiver will continue

searching until a station of reasonable strength is found. To search for

additional stations it is only necessary to repeat the above operation.

Search tuning may be stopped by a single press of either the tuning up or

tuning down buttons.

Adjust the volume (2) and tone controls (3) to the desired level and tone of

sound.

Manual tuning

Press the power button (14) to turn on the receiver.

Select a waveband. Turn the volume control (2) until sound is audible.

Pressing the tuning up (12) or tuning down (15) buttons intermittently will

change the frequency up or down in steps. Each step is equal to 50kHz on

the F band 9kHz on the medium waveband and 1kHz on the long

waveband.

Adjust the volume (2) and tone controls (3) to the desired level and tone of

sound.

Tuning indicator

The tuning indicator (10) will light up when stations are correctly tuned.

MHz

All manuals and user guides at all-guides.com

Memory tuning

You may store up to 25 stations in memory. 10 on F , 10 on medium wave

and 5 on long wave.

Tune in the desired station as previously described.

Press the memory button (8) to open the memory a flashing ' ' will appear

in the display. While the ' ' is flashing press one of the preset buttons on

which you want to store the station. Press the memory button (8) to store

the station and close the memory. Repeat this procedure for the other 4

presets.

Note memory tuning can only be carried out while the 'M' in the display is

flashing.

On F and W a further 5 stations can be preset.

To set preset memory 6.

Press the memory button (8) to open the memory a flashing ' ' will appear

in the display. While the ' ' is flashing press the +5 button (20) and then

press preset button 1. Press the memory button (8) to store the station and

close the memory. The display will show 6 in the top right hand corner.

To set preset memory 7.

Press the memory button (8) to open the memory a flashing ' ' will appear

in the display. While the ' ' is flashing press the +5 button (20) and then

press preset button 2. Press the memory button (8) to store the station and

close the memory. The display will show 7 in the top right hand corner.

Repeat this procedure for presets 8-10.

To recall a station rom preset memory

First select the waveband then press the required preset button. Presets 6-

10 are accessed by pressing the +5 button followed by the required preset

button. e.g. to recall preset memory 8 press the +5 button followed by preset

button 3. Preset memories 6-10 are only available on F and W.

MHz

All manuals and user guides at all-guides.com

all-guides.com

Setting the standby time

Ensure that the receiver is switched off. Press the mode button (5) once,

the

STANDBY

symbol in the display will start to flash.

Press and hold down the mode button (5) until the

STANDBY

symbol and the

time shown in the display begin to flash. Release the mode button. You now

have 5 seconds to start the next procedure otherwise the display will stop

flashing and return to showing normal time.

While the display is flashing use the tuning up button (12) to adjust the

minutes and the tuning down button (15) to adjust the hours. After approx.

5 seconds the display will stop flashing and return to a normal time display.

The time is displayed in 24 hour format.

Waking up to the bleeper

Set the standby time as previously described. Set the standby switch (21)

to the 'bleep' position. Press the standby button (4) until the

STANDBY

symbol is shown in the display.

When the standby time is reached the bleeper will sound. The bleeper will

continue to sound for approx. 59 minutes or until the power button (14) is

pressed. The standby time (alarm) can be permanently switched on or off

by pressing the standby button (4). When the

STANDBY

symbol is

visible in the display, the standby time (alarm) is active.

Waking up to the radio

Set the standby time as previously described. Tune the radio to the required

station and set the volume level. Set the standby switch (21) to the 'radio'

position. Press the standby button (4) until the

STANDBY

symbol is

shown in the display.

When the standby time is reached the radio will turn on and will continue to

operate for approx. 59 minutes or until the power button (14) is pressed.

The standby time (alarm) can be permanently switched on or off by pressing

the standby button (4). When the

STANDBY

symbol is visible in the

display, the standby time (alarm) is active.

STANDBY

All manuals and user guides at all-guides.com

Sleep timer

The R737 has a built in sleep timer which will automatically switch off the

receiver after the preset time has elapsed.

Switch on the receiver and select the required station. Press and hold

down the sleep button (7) the timer will count down from 90 minutes in 10

minute steps. Release the sleep button when the desired sleep time is

reached. Sleep timer operation is shown by the symbol in the display.

A further press of the sleep button will cancel the sleep timer.

Low battery indicator

The low battery indicator (d) on the display will flash and the radio will switch

off when the batteries are in need of replacement.

Stereo FM operation

Switch on the receiver and tune in the required station. Plug the earphones

supplied into the headphone socket (1). Press the mono button (6) until

the stereo indicator (b) in the display lights up. If the station being received

is weak some hiss may be audible, to reduce the hiss press the mono

button (6) to return to mono operation.

Note: FM stereo is only available via the headphone socket.

MHz

Light

Pressing the light button (9) will turn on the light and illuminate the display

for approximately 10 seconds.

All manuals and user guides at all-guides.com

Speci ications

Power Requirements 9.0V

Batteries 6 x IEC R14 (C size)

attery Life

Approx. 60 hrs. of listening for 4 hours a day at

normal volume using alkaline cells.

Frequency Coverage

F 87.5 -108 Hz

W 522 - 1620kHz

LW 144 - 281kHz

Circuit Features

Loudspeaker 100mm 8 ohms

Output Power 1 watt into 8 ohms

Headphone socket 3.5mm dia

Aerial System F Telescopic aerial

W Built-in Ferrite aerial

LW Built-in Ferrite aerial

Displaying the time

While the radio is playing the time may be displayed by pressing the mode

button (5) once. After approximately 5 seconds the display will revert to

showing frequency.

Displaying the standby time

While the radio is playing the standby time may be displayed by pressing

the mode button (5) twice. The

STANDBY

symbol will flash in the display.

After approximately 5 seconds the display will revert to showing frequency.

With the radio switched off pressing the mode button (5) will display the

standby time. The

STANDBY

symbol will flash in the display. After approxi-

mately 5 seconds the display will revert to showing time.

The ompany reserves the right to amend the specification without notice.

All manuals and user guides at all-guides.com

Notes:

All manuals and user guides at all-guides.com

Andere Handbücher für R737

Inhaltsverzeichnis

Andere Roberts Tragbares Radio Handbücher

Roberts

Roberts R9993 Bedienungsanleitung

Roberts

Roberts FM RDS/DAB Digital Radio RD-50CFM Bedienungsanleitung

Roberts

Roberts R9954 Bedienungsanleitung

Roberts

Roberts MP-30FM RDS/MP3/WMA/DAB Digital Radio MP-30 Bedienungsanleitung

Roberts

Roberts R9947 Bedienungsanleitung

Roberts

Roberts RP28 Bedienungsanleitung

Roberts

Roberts RP3 Bedienungsanleitung

Roberts

Roberts Play 20 Bedienungsanleitung

Roberts

Roberts RD70 Bedienungsanleitung

Roberts

Roberts WM-202 Bedienungsanleitung

Roberts

Roberts ecologic 2 Bedienungsanleitung

Roberts

Roberts R876 Bedienungsanleitung

Roberts

Roberts R9966 Bedienungsanleitung

Roberts

Roberts Classic DAB 2 Bedienungsanleitung

Roberts

Roberts R9927 Bedienungsanleitung

Roberts

Roberts R309 Bedienungsanleitung

Roberts

Roberts Analogue World Radio R9968 Bedienungsanleitung

Roberts

Roberts R9993 Bedienungsanleitung

Roberts

Roberts R757 Bedienungsanleitung

Roberts

Roberts Revival R250 Bedienungsanleitung

Roberts

Roberts rp28 Bedienungsanleitung

Roberts

Roberts 3-band Battery Portable Radio R9924 Bedienungsanleitung

Roberts

Roberts R737 Bedienungsanleitung

Roberts

Roberts WM-202 Technisches Handbuch

Beliebte Tragbares Radio Handbücher anderer Marken

Telefunken

Telefunken P5 Bedienungsanleitung

Tait

Tait TP9300 Bedienungsanleitung

Lafayette

Lafayette Guardian 5500 Bedienungsanleitung

Sailor

Sailor SP3300 Bedienungsanleitung

Matra Nortel

Matra Nortel MC 6500 Bedienungsanleitung

Hytera

Hytera PD362i Bedienungsanleitung

Vertex Standard

Vertex Standard VX-P920 Series Bedienungsanleitung

LENCO

LENCO IPD-5100 Bedienungsanleitung

Baofeng

Baofeng BF-82 Bedienungsanleitung

Trevi

Trevi RA 764 Bedienungsanleitung

M/A-Com

M/A-Com P5100 Series Bedienungsanleitung

Elta

Elta 6699 Bedienungsanleitung

PURE

PURE ONE classic Series II Bedienungsanleitung

Teac

Teac PR130 Bedienungsanleitung

Philips

Philips AE6370 Bedienungsanleitung

Simoco

Simoco SRP9170 Bedienungsanleitung

Audiovox

Audiovox FR14 Bedienungsanleitung

Radio Shack

Radio Shack Genex MK 2000 Bedienungsanleitung