Roland Fantom-Xa Betriebsanleitung
1
Sequencing with Rhythms
®ÂØÒňΙ
Workshop
© 2005 Roland Corporation U.S.
All rights reserved. No part of this publication may be reproduced in
any form without the written permission of Roland Corporation U.S.
2
About the Fantom-Xa Workshop Series
Roland’s Fantom-Xa workstation keyboard provides lots of
creative power at an affordable price. It shares many of the
features of its more expensive siblings—the Fantom X6, X7,
and X8—including killer sounds, 128-note polyphony, a full-
featured 16-track sequencer, sampling capabilities, and so
much more.
The Fantom-Xa Workshop Series booklets discuss some of
the things you can do with your Fantom-Xa. Each booklet
focuses on one topic, and is intended as a companion to your
Fantom-Xa Owner’s Manual.
About This Booklet
The Fantom-Xa’s full-featured drum machine contains rhythms
that are designed for songwriting—it’s only natural that you’ll
want to use them in your Fantom-Xa sequences.
This booklet discusses playing rhythms and explains how to
lock your rhythms to the Fantom-Xa sequencer’s beat.
Understanding the Symbols in This Booklet
Throughout this booklet, you’ll come across information that
deserves special attention—that’s the reason it’s labeled with
one of the following symbols.
A note is something that adds information about the topic at hand.
A tip offers suggestions for using the feature being discussed.
Warnings contain important information that can help you avoid possible
damage to your equipment, your data, or yourself.
Rhythm Patterns
The Fantom-Xa’s built-in drum beats are called “rhythm
patterns,” or “rhythms” for short. The Fantom-Xa has 256 preset
rhythms covering a large variety of musical styles, and 256
user locations for storing your own rhythms.
To learn how to create your own rhythm patterns, see the Fantom-Xa
Owner’s Manual.
The TRIGGER/CATEGORY Pads
Each TRIGGER/CATEGORY pad acts as a
button that starts and stops the playback of
a rhythm.
The behavior of the pads depends on the
state of the TRIGGER button, and of the
RHYTHM button, over in ARP/RHY section of
the Fantom-Xa’s front panel.
When RHYTHM and TRIGGER are
lit, the pads are unlit and they play
rhythms.
When RHYTHM’s not lit, but
TRIGGER is, the pads light and they
play percussion notes.
You can also use the pads for the selection of patches, but we’re not
concerned about that in this booklet.
3
Playing a Rhythm
1. Press RHYTHM so it lights if it isn’t already lit.
2. Press TRIGGER so it lights if it isn’t already
lit.
3. Strike the desired pad—its rhythm begins
playing and its pad flashes.
The rhythm plays at the Fantom-Xa’s current Tempo setting. To learn about
changing the rhythm/song tempo, see the Fantom-Xa Owner’s Manual.
4. To stop a rhythm, strike its pad again. The rhythm stops
and its light goes out.
Mix ‘n Match Rhythms
You don’t have to wait until the end of one rhythm to start
playing of another one. This lets you throw together—and
record—bits and pieces of different rhythm patterns to
create your own rhythm arrangement on the fly.
When a rhythm is playing and you strike a new rhythm’s pad,
the Fantom-Xa immediately switches to the new rhythm
without missing a beat. You can do this as often as you like.
When you want the beat to stop, strike the last rhythm’s pad.
Telling the Pads What Rhythms to Play
A set of nine rhythm patterns is called a “rhythm group.” You
can set the pads to play the desired rhythms by selecting the
rhythm group to which they belong.
There are 32 preset rhythm groups and 32 user locations for
storing your own rhythm groups.
To learn how to create your own rhythm groups, see the Fantom-Xa Owner’s
Manual.
Each rhythm group is programmed to use a particular rhythm set, so when
you select a different rhythm group, you may also be selecting a new
rhythm set. You can edit a rhythm group to use the kit you want to use, as
described in the Fantom-Xa Owner’s Manual.
You can select a different rhythm group even when a rhythm is currently
playing.
Selecting a Rhythm Group
1. Hold down SHIFT and press RHYTHM to display the
RHYTHM GROUP screen.
2. Turn the VALUE dial to select the desired rhythm group.
3. Press the EXIT button.
In Patch mode, the Fantom-Xa remembers your most recent rhythm
group selection until you power off. In Performance mode, you can press
the WRITE button to store your rhythm group selection in the current
performance.
Sync or Swim
When you use a rhythm in a sequence, you’ll want to make sure
that the rhythm’s beat and the sequencer’s beat are absolutely
in sync with each other and that the rhythm’s measures line up
with the sequencer’s measures. This way, when you:
• start playback of the sequence—the rhythm starts, too.
• edit the sequence—the sequencer’s beats and measures
also apply to the rhythm as you edit.
Use the following procedure to perfectly line everything up.
4
Recording a Rhythm Into a Sequence
PlayStop RecordReset
If your Fantom-Xa is set to load the demo song at startup, you’ll have to
clear the song before recording one of your own—to do this, press SONG
EDIT↔LIST once or twice until “UTILITY” appears onscreen above F3. Then
press F3 (UTILITY), F2 (SONG CLEAR), and finally, F6 (EXEC).
You can record a rhythm—or mix ‘n match series of rhythms—
into a sequence as the sequence’s first track, or after you’ve
already recorded other tracks. The procedure is precisely the
same in either case.
We’ll record onto the sequence’s first track for our tutorial.
1. Press RHYTHM so it lights, and locate the rhythm you wish
to record by striking its pad to listen to the rhythm.
2. Press the rhythm’s pad again to turn off the rhythm.
3. Press the Reset button to move to the start of the song.
4. Press the SEQUENCER Record button to display the
Realtime Rec Standby screen.
If you’d like to record on a track other than Track 1, set the Rec Track
parameter to the desired track.
5. The key is the Count In parameter—set it to WAIT NOTE.
With this setting, the sequencer won’t begin recording
until the rhythm starts, and will place the rhythm’s first
note exactly on Beat 1.
Be careful not to play the keyboard before starting your first rhythm, since
any note the sequencer receives will cause it to start recording.
6. Play the pad that triggers the first rhythm you want to
use—recording starts.
7. If you’d like to record a series of rhythms, strike their pads
as desired.
8. When you’re done, press RHYTHM to turn off the drum
machine, and then press the SEQUENCER Stop button.
9. Press Reset and then Play to listen to your recording.
Do-Over
If you’re not satisfied with your recording, you can re-record it
in either of two ways. You can:
• press ERASE/UNDO—and when the Fantom-Xa asks if
you’re sure you want to undo your recording, press F6
(EXEC). You can then repeat the recording procedure.
• record it again—simply by using the same procedure with
one minor change: set the Realtime Rec Standby screen’s
Rec Mode parameter to REPLACE so each new attempt
replaces the previous one.
The End
We hope you’ve enjoyed this explanation of how to record
rhythms in the Fantom-Xa’s sequencer. The Fantom-Xa’s
rhythms can provide the perfect groove for most any type of
song, and, as you can see, they’re simple to record. Keep an eye
out for other Fantom-Xa Workshop booklets, all available for
downloading at www.RolandUS.com.
For the latest Fantom-Xa updates and support tools, visit the Roland U.S.
Web site at www.RolandUS.com. If you need personal assistance, call our
amazing Product Support team at 323-890-3745.
Andere Handbücher für Fantom-Xa
7
Andere Roland Elektronische Tastatur Handbücher
Roland
Roland Prelude Bedienungsanleitung
Roland
Roland X-6 Handbuch
Roland
Roland FP-4 Bedienungsanleitung
Roland
Roland S-10 Bedienungs- und Wartungshandbuch
Roland
Roland E-300 Bedienungsanleitung
Roland
Roland Workstation GW-8 Bedienungsanleitung
Roland
Roland Fantom-Xa Installationsanleitung
Roland
Roland VR-700 Bedienungsanleitung
Roland
Roland V-Combo VR-09 Bedienungsanleitung
Roland
Roland JUPITER-X Bedienungsanleitung
Roland
Roland Cube-60 Bass Bedienungsanleitung
Roland
Roland JX-3P Bedienungs- und Wartungshandbuch
Roland
Roland X-6 Bedienungsanleitung
Roland
Roland BK-5 Bedienungs- und Wartungshandbuch
Roland
Roland Fantom G6 Technisches Datenblatt
Roland
Roland V-Synth GT Montageanleitung
Roland
Roland EXR-5 Bedienungsanleitung
Roland
Roland Fantom G6 Technisches Datenblatt
Roland
Roland Fantom G8 Bedienungsanleitung
Roland
Roland V-Combo VR-760 Bedienungsanleitung
Beliebte Elektronische Tastatur Handbücher anderer Marken
Yamaha
Yamaha Portatone PSR-100 Bedienungsanleitung
Casio
Casio WK-1600 Bedienungsanleitung
Keith McMillen Instruments
Keith McMillen Instruments K-Board Pro 4 Technisches Datenblatt
Yamaha
Yamaha PortaSound PCS-30 Bedienungsanleitung
McGrey
McGrey 6170 Bedienungsanleitung
Yamaha
Yamaha PortaTone PSR-41 Bedienungsanleitung
