Rona 38115106 Bedienungsanleitung

Model / Modèle : 38115106

10’ x 14’ gazebo

Operators’ Manual p. 2

Abri-soleil 10 x 14 pi

Guide de l'utilisateur p. 11

IMPORTANT:

1. Keep all children and pets away from assembly area. Children and pets should be

supervised while gazebo is being assembled.

2. The assembled gazebo should be located at least 6 feet (2 m) from any obstruction

such as a fence, garage, house, overhanging branches, laundry lines or electrical wires.

3. This unit is heavy. Do not assemble this item alone. Six people are recommended for

safe assembly.

4. Some parts may contain sharp edges. Wear protective gloves if necessary during

assembly.

5. When assembling and using this product, basic safety precautions should always be

followed to reduce the risk of personal injury and damage to equipment. Please read all

instructions before assembly and use.

6. For outdoor use only. Install on level ground. 16 stakes are provided to secure the

gazebo in the ground. If you wish to secure the gazebo to a wood deck or concrete

surface, use 16 anchors suited for these surfaces (anchors not included).

7. Check all bolts for tightness before and during usage.

8. Please check your state and local regulations prior to purchasing. Some jurisdictions

may require permits for installation and use. Some special procedures may be valid in

your area.

9. While this gazebo is manufactured to withstand strong force winds through only the

supplied ground stakes, securing the gazebo to a deck, concrete patio or a stronger base,

in areas subject to frequent severe weather should be considered.

NOTE: The gazebo’s roof and structure are not guaranteed against extreme weather

conditions (storms, high winds, etc.). If the gazebo is not dismantled for the winter, snow

must be cleaned off regularly. Any damage caused by snow accumulation is not covered

by the warranty.

GAZEBO ASSEMBLY INSTRUCTIONS

Our clear, easy-to-follow, step-by-step instructions will guide you through the

project from start to finish.

All that is required is a screwdriver, a hammer and two ladders of at least 8 feet

(2.5 m) high (not included).

For you safety, DO NOT assemble this item alone. Two people or more are

required for a smooth and safe installation.

Item identification: For ease of identification, all parts are labeled to correspond to

the Step number in which the part is used.

Description Part Quantity Image

Big panel 1$ 

Big panel 2$ 

Small panel 1% 

Small panel 2% 

Long beam 1& 

Long beam 2& 

Short beam' 

Lower connector 1( 

Lower connector 2) 

Top frame 1* 

Top frame 2* 

Top frame 3* 

Slanted beam+ 

Middle beam, 

Long roof piece 1- 

Long roof piece 2- 

Short roof piece 1- 

Parts List

Description Part Quantity Image

Short roof piece 2- 

Middle roof piece- 

Small roof piece 1. 

Small roof piece 2. 

Left brace/ 

Right brace/ 

Middle brace/ 

Long brace0  

Short brace0  

Left rail1  

Right rail1  

Middle rail1  

Center plate2  

Corner plate2 



Hook3  

Small top connector4  

Cover5  

Small slanted beam 6  

Small slanted beam 6 



Long netting tube7  

Short netting tube8  

Mosquito netting9  

Parts List

Part Description Quantity Image

AA M6X35 Bolt 4 PCS

BB M6 Flat washer 82 PCS

CC M6X15 Bolt 74 PCS

DD M6X20 Bolt 2 PCS

FF M6 Nut 2 PCS

Z M6 Wrench 2 PCS

Hardware Pack 1

Fig.1: Secure the small panels (B1 and B2) to the large panels (A1 and A2) with bolts (AA) and flat washers (BB).

Fig.2: Secure the lower connector 1 (E) to the corner of the panels with bolts (CC) and flat washers (BB).

Fig.3: Insert the long beam 1 into the long beam 2 (C2), then secure the lower connector 2 (F) to long beam 1 (C1) and long

beam 2 (C2) with bolts (CC), bolts (DD) and flat washers (BB), nuts (FF). Reserve one hole on the long beam (C2) to install

the netting tube.

Part Description Quantity Image

BB M6 Flat washer 56PCS

CC M6X15 Bolt 32PCS

DD M6X20 Bolt 24PCS

Hardware Pack 2

Fig.4: Secure the assembled long beam 1 to the large panels (A1 and A2) with bolts (CC) and flat washers (BB).

Repeat this step to secure the short beam (D) to small panels (B1 and B2).

Fig.5: Secure the lower connector 2 (F) and short netting tube (U) to the short beam (D) with bolts (CC) and flat

washers (BB).

Fig.6: Secure the long netting tubes (T) to the long beams (C1 and C2) with bolts (CC) and flat washers (BB). Repeat

this step to secure the short netting tubes.

Fig.7: Insert the top beam 1 (G1) into the top beam 2 (G2) and use bolts (CC) and flat washers (BB) to secure the

top beam 2 (G2) to top beam 1 (G1).

Fig.7-1: Secure the slanted beam (H) to the top beams 1 (G1) with bolts (DD) and flat washers (BB).

Fig.8: Secure the slanted beam (H) to the lower connector 1 (E) with bolts (CC) and flat washers (BB).

Fig.9: Secure the middle beam (I) to the top beams 2 (G2) with bolts (DD) and flat washers (BB).

Fig.10: Secure the lower end of the middle beam (I) the lower connector 2 (F) with bolts (CC) and flat washers (BB).

Fig.11: Secure the small slanted beam 1 and 2 (S1 and S2) to the top beam 1 (G1) with bolts (CC) and flat washers (BB).

Fig.12: Secure the small slanted beam 1 and 2 (S1 and S2) to the small top connector (Q) with bolts (CC) and flat washers

(BB).

Fig.12-1: Secure the support beam (G3) to the top beams with bolts (CC) and flat washers (BB).

Fig.13: Attach the hook (P) to the small top connector (Q).

Fig.14: Insert the small roof pieces (K1 and K2) into the rail of the small slanted beam1 / 2 (S1 / S2).

Fig.15: Insert the braces (M1 and M2) into the lower small roof pieces (K1 and K2), then secure the corner

plate (O2) to the small slanted beam 1 / 2 (S1 / S2) through three holes with screws (EE) and flat washers (BB).

Fig.16: Secure the cover (R) to the small top connector (Q) with bolts (AA) and flat washers (BB).

Part Description Quantity Image

AA M6X35 Bolt 2 PCS

BB M6 Flat washer 18 PCS

EE M6X20 Screw 16 PCS

Hardware Pack 3

Fig.19: Insert the braces (L1, L2 and L3) into the lower of the roof pieces; then secure the center plate (O1) to the

middle beam (I) through three holes with screws (EE) and flat washers (BB).

Fig.20: Secure the corner plate (O2) to the slanted beam (H) by using screws (EE) and flat washers (BB) through

three holes.

Fig.17: Insert the short roof piece 1 and 2 (J3 and J4) into the middle beam (I) and slanted beam (H), then insert the

rails (N1 and N2) into it. Insert the long roof piece (J1) into the middle beam (I) and slanted beam (H). Repeat this step

to install the right roof pieces.

Fig.18: Insert the middle roof piece (J5) into the middle beam (I); then insert the middle rail (N3) into it. Insert the

middle PC (J5) into middle beam (I).

Part Description Quantity Image

HH 8X180 mm Stake 16 PCS

Hardware Pack 4

Fig.21: Attach the mosquito netting (V) to the long netting tubes (T) and short tubes (U) with rings (GG).

Fig.22: Secure the whole gazebo to the ground with stakes (HH).

Your

azebo is now full

assembled.



Part Description Quantity Image

GG Ring 56 PCS

Hardware Pack 5

Inhaltsverzeichnis

Sprachen:

Andere Rona Gartenmöbel Handbücher

Rona

Rona 38115112 Bedienungsanleitung

Rona

Rona 38115090 Bedienungsanleitung

Rona

Rona Alton L-GZ324PST-1A Bedienungsanleitung

Rona

Rona 38115087 Bedienungsanleitung

Rona

Rona KINGSBURY 71495121 Bedienungsanleitung

Rona

Rona 38115088 Bedienungsanleitung

Rona

Rona 38115089 Bedienungsanleitung

Rona

Rona 20095101 Bedienungsanleitung

Beliebte Gartenmöbel Handbücher anderer Marken

Belleze

Belleze 014-HG-20074 Bedienungsanleitung

Hatteras Hammocks

Hatteras Hammocks DCA1-K-HH Bedienungsanleitung

Kozyard

Kozyard Morgan Aluminum Pergola Bedienungsanleitung

Lemeks

Lemeks Palmako PA120-5959 Installationshandbuch

OLT

OLT 24 Bedienungsanleitung

forest-style

forest-style HACIENDA 2354 Bedienungsanleitung

Courtyard Creations

Courtyard Creations RUS0188-WM Bedienungsanleitung

RPR

RPR OLLIE CHAIR Bedienungsanleitung

kingsley-bate

kingsley-bate MC-55 Bedienungsanleitung

Weltevree

Weltevree Carrier Bedienungsanleitung

Grange Fencing

Grange Fencing Elite Arch Bedienungsanleitung

Grosfillex

Grosfillex AUVENT YR14 Bedienungsanleitung

X-METAL

X-METAL EAGLE 33511 Bedienungsanleitung

Anova

Anova FBW6R Bedienungsanleitung

Outsunny

Outsunny 84A-090 Bedienungsanleitung

Ivy Terrace

Ivy Terrace IVTD212 Bedienungsanleitung

Breezesta

Breezesta FANBACK ADIRONDACK AD-0101 Bedienungsanleitung

hanit

hanit SUTTON 1 Bedienungsanleitung