Rosewill RFS-105 Bedienungsanleitung

The RFS-105 / RFS-108 is a high-performance Fast Ethernet

switch, with all ports capable of 10 or 100Mbps

auto-negotiation operation.

Store-and-forward switching mode promises the low latency

plus eliminates all the network errors, including runt and CRC

error packets. To work under full-duplex mode, transmission

and reception of the frames can occur simultaneously without

causing collisions as well as double the network bandwidth.

The switch is plug-n-play with no required software to

configure and fully compliant with all kinds of network

protocols. Moreover, the rich diagnostic LEDs on the

front-panel can provide the operating status of individual port

and whole system.

RFS-105 Features:

5x 10/100Mbps RJ-45 Nway ports

Supports 802.3az Green Ethernet: Detecting port

usage power saving and cable length power saving

Supports NWay protocol for speed (10/100Mbps)

and duplex mode (Half/Full) auto-detection

Supports MDI/MDI-X auto crossover

Supports full and half duplex operation on all ports

Supports back-pressure (half duplex) and flow

control (IEEE 802.3x)

Wire-speed packet filtering and forwarding rate

Store-and-forward architecture filters fragment &

CRC error packets

Supports 1K MAC address entries in whole system

384K bits (48KB) buffer memory

FCC Class B, CE

RFS-108 Features:

8 x 10/100Mbps RJ-45 Nway ports

Supports 802.3az Green Ethernet: Detecting port

usage power saving and cable length power saving

Supports NWay protocol for speed (10/100Mbps)

and duplex mode (Half/Full) auto-detection

Supports MDI/MDI-X auto crossover

Supports full and half duplex operation on all ports

Supports back-pressure (half duplex) and flow

control (IEEE 802.3x)

Supports 802.11p QoS data management

Wire-speed packet filtering and forwarding rate

Store-and-forward architecture filters fragment &

CRC error packets

Supports 1K MAC address entries in whole system

768K bits (96KB) buffer memory

FCC Class B, CE

Before you start to install the switch, check the following

contents in this package：

A 5 port RFS-105 switch or a 8 port RFS-108 switch

One external power adapter

User’s manual

Please refer to the following table for LED definition

5port

8port

LED

Status

Operation

Power

Steady Green

Power is on

Off

Power is off

Link/Act

Steady Green

The port is connected

Blinking Green

The port is transmitting/receiving

data.

Off

No connection

Connect each station to the switch by twisted-pair cable.

Plug one RJ-45 connector into a RJ-45 port of the switch,

and plug the other RJ-45 connector into the station’s network

adapter. Power on the switch and then system is ready.

For cable selection, refer to the following table.

In making a switch interconnection, you could use any port to

connect another switch with straight or crossover cable. As

all the ports support auto MDI / MDI-X function, using a

straight cable to make a switch-to-switch connection is

allowed.

For cable selection, refer to the following table：

Network Speed

Cable Type

Max. Length

10Mbps

Cat. 3, 4, 5 UTP/STP

100 meters

100Mbps

Cat. 5 UTP/STP

100 meters

RFS-105 Spec

Switch Type

Desktop

Standards

802.3 Ethernet, 802.3u Fast

Ethernet, 802.3x Full-Duplex

Flow Control, 802.3az Energy

Efficient Ethernet

Network Management

Type

Unmanaged

Ports

5 x RJ45

Speed

10/100Mbps

MAC Address Table

Buffer Memory

384K bits (48KB)

Switching Method

Store and Forward

LEDs

System: Power

Port: Link/Act

Power

External Power 5V0.6A

Dimensions

4.76" x 2.95" x 1.02" (121 x

75 x 26 mm)

Weight

0.57 lbs. (258.55g)

Temperature

0ºC to 40ºC (32ºF to 104ºF)

Humidity

10% - 90%, Non-condensing

RFS-108 Spec

Switch Type

Desktop

Standards

802.3 Ethernet, 802.3u Fast

Ethernet, 802.3x Full-Duplex

Flow Control, 802.3az Energy

Efficient Ethernet, 802.1p

QoS data management

Network Management

Type

Unmanaged

Ports

8 x RJ45

Speed

10/100Mbps

MAC Address Table

Buffer Memory

768K bits (96KB)

Switching Method

Store and Forward

LEDs

System: Power

Port: Link/Act

Power

External Power 5V0.6A

Dimensions

6.08" x 2.95" x 1.02" (155 x

75 x 26 mm)

Weight

0.76 lbs. (345g)

Temperature

0ºC to 40ºC (32ºF to 104ºF)

Humidity

10% - 90%, Non-condensing

FCC Certifications

This Equipment has been tested and found to comply with the limits for

a Class B digital device, pursuant to part 15 of the FCC Rules. These

limits are designed to provide reasonable protection against harmful

interference when the equipment is operated in a commercial

environment. This equipment generates, uses, and can radiate radio

frequency energy and, if not installed and used in accordance with the

instruction manual, may cause harmful interference to radio

communications.

Operation of this equipment in a residential area is likely to cause

harmful interference in which case the user will be required to correct

the interference at his own expense.

This device complies with Part 15 of the FCC Rules. Operation is

subject to the following two conditions: (1) this device may not cause

harmful interference, and (2) this device must accept any interference

received; including interference that may cause undesired operation.

CE Mark Warning

This equipment complies with the requirements relating to

electromagnetic compatibility, EN 55022 class B for ITE, the essential

protection requirement of Council Directive 2004/108/EC on the

approximation of the laws of the Member States relating to

electromagnetic compatibility.

Company has an on-going policy of upgrading its products and it may

be possible that information in this document is not up-to-date. Please

check with your local distributors for the latest information. No part of

this document can be copied or reproduced in any form without written

consent from the company.

Trademarks:

All trade names and trademarks are the properties of their respective

companies.

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere Rosewill Schalten Handbücher

Rosewill

Rosewill RC-409X Bedienungsanleitung

Rosewill

Rosewill RHUB110 Bedienungsanleitung

Rosewill

Rosewill KVMRKV-4UC Bedienungsanleitung

Rosewill

Rosewill RHUB-200 Bedienungsanleitung

Rosewill

Rosewill RVHS3-11001 Bedienungsanleitung

Rosewill

Rosewill RHUB100 Bedienungsanleitung

Rosewill

Rosewill RC-410X Bedienungsanleitung

Rosewill

Rosewill RC-409LX Bedienungsanleitung

Rosewill

Rosewill RHB320 Bedienungsanleitung

Rosewill

Rosewill RKV-2DVI Bedienungsanleitung

Rosewill

Rosewill RC-GS1024 Bedienungsanleitung

Rosewill

Rosewill RHUB-310B Bedienungsanleitung

Rosewill

Rosewill RHB-620 Bedienungsanleitung

Rosewill

Rosewill RC-407 Bedienungsanleitung

Rosewill

Rosewill RHUB120 Bedienungsanleitung

Rosewill

Rosewill RHUB-210 Bedienungsanleitung

Rosewill

Rosewill RGS-108P Bedienungsanleitung

Rosewill

Rosewill RC-415 Bedienungsanleitung

Rosewill

Rosewill RNWA-PoE-4065 Bedienungsanleitung

Rosewill

Rosewill RKV-2P Bedienungsanleitung

Rosewill

Rosewill RC-410LX Bedienungsanleitung

Rosewill

Rosewill RC405 Bedienungsanleitung

Rosewill

Rosewill RC412 Bedienungsanleitung

Rosewill

Rosewill RC409 Bedienungsanleitung

Beliebte Schalten Handbücher anderer Marken

URC

URC Total Control MFS-8 Bedienungsanleitung

Azbil

Azbil HPQ-D11 Bedienungsanleitung

Sony

Sony DFS-900M Bedienungsanleitung

SICK

SICK i17S Bedienungsanleitung

F&F

F&F SZR-277 Bedienungsanleitung

Shure

Shure UAMS/BK Bedienungsanleitung

Dräger

Dräger X-zone Switch Off Bedienungsanleitung

Asco

Asco Joucomatic 349 Series Bedienungsanleitung

BT Mini Hub Bedienungsanleitung

D-Link

D-Link DES-1226G Bedienungsanleitung

Johnson Controls

Johnson Controls FS80-C Bedienungsanleitung

MicroNet

MicroNet SP1200A Bedienungsanleitung

Ruijie

Ruijie RG-PF2920 Series Installations- und Betriebsanleitung

Altinex

Altinex DA1914SX Bedienungsanleitung

RJM

RJM MASTERMIND PBC/6X Bedienungsanleitung

Atlas

Atlas MMK-KVM8 Bedienungsanleitung

Cabletron Systems

Cabletron Systems GIGAswitch GSR-16 Bedienungsanleitung

Cisco

Cisco Catalyst X4448 Handbuch