WARRANTY
This product has a lifetime warranty to the original purchaser that ap-
plies to defects in materials and workmanship only. We will
repair or replace the product or part(s) at our discretion. This warranty
does not apply to product failure or defects due to direct or indirect mis-
use, abuse, negligence, accidents, alterations, repairs or lack of main-
tenance. The item must be shipped prepaid to our Clarkston, WA loca-
tion. If items must be returned for warranty service, call to receive a
Return Goods Authorization (RGA) number and further instruction.
SAFETY GUIDELINES
Always follow the safety recommendations and guidelines provided by
the manufacturer of your tools. When in doubt refer to your owner’s
manual.
MOUNTING AND ASSEMBLY
IF YOU DO NOT HAVE OUR BASE PLATE MOUNTING SYSTEM
FOLLOW THE INSTRUCTIONS BELOW.
1. Peel protective paper backing off acrylic base.
2. Before removing your router’s stock plate, center router on offset
base plate with handles parallel to length of plate.
3. Your stock plate will be used as the drilling jig. To keep everything
aligned, place a piece of masking tape on each plate in the corre-
sponding location.
4. Remove stock plate from router.
5. Placestockplate(face-up)onoffsetbaseplate(face-up),alignpieces
of tape and center plates by measuring.
6. Clamp plates together, making sure they remain centered.
7. Drill and countersink mounting holes using drill press if possible.
NOTE: For best results drill holes at high speed and countersink
holes at a slow speed.
8. Mount plate to router. NOTE: If your router’s screws are not long
enough, you can find longer screws at hardware stores, bolt supply
companies, auto part stores or through your Rousseau Co.
Distributor.
USE
FOR EDGE DETAIL USING A BEARING CUTTER
1. Gripouterrouterhandleand base platehandlefirmlywithlongend of
plate over surface of material.
2. Turn router on and begin cutting.
FOR EDGE DETAIL USING A CUTTER WITHOUT A BEARING
1. Create a fence block approx. the height of your bit, cutting out
opening around bit.
2. Predrill fence block and attach it to aluminum edge guide.
3. Adjust fence for depth of cut and tighten in place. By cutting (with a
table saw or jointer) the leading edge of the fence a bit nar-
rower than the take up side, you can make jointer cuts. Either
straight or profile. Door edge details like this work great joint-
ing off the saw marks from end grain etc..
4. Grip both router handles (not plate handle) turn on router and
start cut.
FOR DADOES, RABBETS AND INLAY CUTS
1. Create a fence block, predrill holes and attach to aluminum edge
guide. NOTE: When making fence block consider that the smallest
distance from aluminum edge guide to bit center is approx. 2-7/8”.
2. Adjust edge guide to achieve correct inset of cut by measuring from
block to cutter edge.
3. Tighten in place, grip both router handles (not plate handle), turn on
router and begin cutting.
