RTA 460ESDFM-NNA4 Technisches Datenblatt
Real Time Automation, Inc.
1
1-800-249-1612
Firmware Version 5.2.14
460ESDFM-NNA4
Protocol Gateway
Product User Guide
Real Time Automation, Inc.
2
1-800-249-1612
Trademarks
CompactLogix, ControlLogix, & PLC-5 are registered trademarks of Rockwell Automation, Inc. EtherNet/IP is a trademark of the ODVA.
MicroLogix, RSLogix 500, and SLC are trademarks of Rockwell Automation, Inc. Microsoft, Windows, and Internet Explorer are registered
trademarks of Microsoft Corporation. BACnet®is a registered trademark of American Society of Heating, Refrigerating and Air-Conditioning
Engineers (ASHRAE). All other trademarks and registered trademarks are the property of their holders.
Limited Warranty
Real Time Automation, Inc. warrants that this product is free from defects and functions properly.
EXCEPT AS SPECIFICALLY SET FORTH ABOVE, REAL TIME AUTOMATION, INC. DISCLAIMS ALL OTHER WARRANTIES, BOTH
EXPRESSED AND IMPLIED, INCLUDING BUT NOT LIMITED TO IMPLIED WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A
PARTICULAR APPLICATION. THIS LIMITED WARRANTY GIVES YOU SPECIFIC LEGAL RIGHTS. YOU MAY ALSO HAVE OTHER
RIGHTS, WHICH VARY FROM STATE TO STATE.
The examples and diagrams in this manual are included solely for illustrative purposes. Because of the many variables and requirements
associated with any particular application, Real Time Automation, Inc. cannot assume responsibility or liability for actual use based on the
examples and diagrams. Except as specifically set forth above, Real Time Automation and its distributors and dealers will in no event be liable
for any damages whatsoever, either direct or indirect, including but not limited to loss of business profits, income, or use of data. Some states
do not allow exclusion or limitation of incidental or consequential damages; therefore, the limitations set forth in this agreement may not apply
to you.
No patent liability is assumed by Real Time Automation with respect to use of information, circuits, equipment, or software described in this
manual.
Government End-Users
If this software is acquired by or on behalf of a unit or agency of the United States Government, this provision applies: The software (a) was
developed at private expense, is existing computer software, and was not developed with government funds; (b) is a trade secret of Real Time
Automation, Inc. for all purposes of the Freedom of Information Act; (c) is “restricted computer software” submitted with restricted rights in
accordance with subparagraphs (a) through (d) of the Commercial “Computer Software-Restricted Rights” clause at 52.227-19 and its
successors; (d) in all respects is proprietary data belonging solely to Real Time Automation, Inc.; (e) is unpublished and all rights are reserved
under copyright laws of the United States. For units of the Department of Defense (DoD), this software is licensed only with “Restricted Rights”:
as that term is defined in the DoD Supplement of the Federal Acquisition Regulation 52.227-7013 (c) (1) (ii), rights in Technical Data and
Computer Software and its successors, and: Use, duplication, or disclosures is subject to restrictions as set forth in subdivision (c) (1) (ii) of the
Rights in Technical Data and Computer Software clause at 52.227-7013. If this software was acquired under GSA schedule, the U.S.
Government has agreed to refrain from changing or removing any insignia or lettering from the Software or documentation that is provided or
from producing copies of the manual or media. Real Time Automation, Inc.
© 2017 Real Time Automation, Inc. All rights reserved.
Real Time Automation, Inc.
3
1-800-249-1612
Revision History ............................................................................................................................................ 5
Overview ....................................................................................................................................................... 6
Hardware Platforms...................................................................................................................................... 7
Hardware –NNA4 ......................................................................................................................................... 8
Powering the Gateway.............................................................................................................................. 8
Port Configuration ........................................................................................................................................ 9
Mounting with a DIN Rail............................................................................................................................ 10
Installing.................................................................................................................................................. 10
Removing ................................................................................................................................................10
Accessing the Main Page............................................................................................................................. 11
Error: Main Page Does Not Launch......................................................................................................... 12
Committing Changes to the Settings ..........................................................................................................13
Main Page ................................................................................................................................................... 14
Device Configuration...................................................................................................................................15
EtherNet/IP Adapter Configuration ............................................................................................................ 16
EtherNet/IP Adapter Data Group Configuration.........................................................................................17
EtherNet/IP Adapter Data Group Configuration: Auto-Configure..........................................................18
Auto-Configure Group by Device vs. Auto-Configure Group by Data Type............................................ 19
Group by Device (Default Method)..................................................................................................... 19
Group by Data Type ............................................................................................................................ 19
EtherNet/IP Adapter Data Group Configuration: Manual Mode............................................................20
EtherNet/IP Adapter Data Group Configuration: Using Strings.............................................................. 21
EtherNet/IP Adapter Data Group Configuration-Connection Parameters .............................................22
Setting up the PLC- Example Using RSLogix5000........................................................................................ 23
DF1 Master Configuration...........................................................................................................................24
DF1 Master Device Configuration............................................................................................................... 25
Configuring Read Scan Lines ................................................................................................................... 26
Configuring Write Scan Lines ..................................................................................................................26
Configuring Read and Write Scan Lines (cont.)....................................................................................... 27
Mapping - Transferring Data Between Devices .......................................................................................... 28
Display Mapping and Values....................................................................................................................... 29
Display Data ............................................................................................................................................ 29
Display String...........................................................................................................................................31
Data and String Mapping –Auto-Configure................................................................................................ 32
Real Time Automation, Inc.
4
1-800-249-1612
Data Mapping –Explanation.......................................................................................................................33
Data Mapping –Adding Diagnostic Information ........................................................................................34
String Mapping –Explanation..................................................................................................................... 37
Mapping –Auto-Configure Mode to Manual Configure Mode .................................................................. 38
Mapping –Manual Configure Mode to Auto-Configure Mode .................................................................. 39
View as Text ................................................................................................................................................ 40
Data Mapping.......................................................................................................................................... 40
String Mapping........................................................................................................................................40
Security Configuration ................................................................................................................................ 41
Security Configuration-Security Levels ................................................................................................... 42
Security - Log In.......................................................................................................................................43
Security - Log Out.................................................................................................................................... 43
Email Configuration .................................................................................................................................... 44
Alarm Configuration.................................................................................................................................... 45
Diagnostics –Alarm Status...................................................................................................................... 47
Alarms –Active .......................................................................................................................................47
Alarms –Clear ......................................................................................................................................... 48
Change of State (COS) Configuration..........................................................................................................49
Diagnostics Info........................................................................................................................................... 50
Diagnostics –Data and String Mapping .................................................................................................. 50
Diagnostics –EtherNet/IP Adapter ............................................................................................................. 51
Diagnostics –DF1 Master ........................................................................................................................... 53
LED Configuration .......................................................................................................................................56
Configuration Files ...................................................................................................................................... 57
Export Configuration............................................................................................................................... 57
Import Configuration .............................................................................................................................. 57
Save and Replace Configuration Using SD Card.......................................................................................... 58
Saving Configuration Using SD Card........................................................................................................ 58
Replacing Configuration Using SD Card .................................................................................................. 58
Intelligent Reset Button .............................................................................................................................. 59
Utilities........................................................................................................................................................ 60
Real Time Automation, Inc.
5
1-800-249-1612
Revision History
Version
Date
Notes
5.1.1
6/7/16
Features Added
1. Reworked AutoMap functions to automap per device and made default for most
productssuppo[email protected]
2. Implemented Automatic reboot and redirect upon startup
3. Modified Template usage so it can be applied easily on a protocol or product level
4. All imported configurations will force Manual mode for Mapping and AutoServer
functionalities
5. Allow saving/replacing of configuration via SD Card
6. Added DHCP for Network Settings (default)
5.2.1
10/12/16
Features Added
1. Replaced Build Date with Revision Number
2. DF1 Master (DFM) Released
3. NNA4 Dual RS485 Hardware
Bug Fixes
1. BACnet/IP Server (BS) Relinquish Default
2. BACnet MS/TP (BMS) Reninquish Default
3. BACnet MS/TP Slave (BMS) CSV Object Parameter
4. Modbus TCP/IP Client (MC) XML Import Bug when Write Only
5. Modbus TCP/IP Client (MC) Write Directional changed Web Parameters
5.2.2
1/12/17
Features Added
1. Added ability to add in prefixes to the filename (for BETA and DEMO)
2. Updated Copyright Year to 2017
5.2.3
1/19/17
Bug Fixes
1. BACnet/IP Server (BS) COV (Change of Value) Notifications with Binary Objects (both Input
and Output)
5.2.4
1/25/17
Bug Fixes
1. BACnet/IP Server (BS) COV (Change of Value) Notifications with Binary Output Objects
5.2.5
2/16/17
Bug Fixes
1. BACnet/IP Server (BS) increased the number of COV's supported from 100 to 2800 across
all objects
2. BACnet MS/TP Slave (BMS) increased the number of COV's supported from 100 to 2800
across all objects
5.2.6
2/21/17
Bug Fixes
1. BACnet/IP Server (BS) fixed the auto-server for Binary Objects for non-1 Bit Pack Option
2. BACnet MS/TP Slave (BMS) fixed the auto-server for Binary Objects for non-1 Bit Pack
Option
3. BACnet MS/TP Slave (BMS) fixed the load template for Binary Output Objects for 1 Bit Pack
Option
5.2.9
3/15/17
Bug Fixes
1. Update for Translator Web Display for Mapping Configuration (buffer too small)
2. Update for String Translator Web Display for Mapping Configuration (buffer too small)
5.2.14
5/4/17
Bug Fixes
1. Completely removed unit id from MS protocol. MS will respond to all Unit IDs
2. Removed "Unit ID" description from MS help page
Real Time Automation, Inc.
6
1-800-249-1612
Overview
The 460ESDFM-NNA4 gateway connects an EtherNet/IP Scanner with as many as 32 DF1 Slaves. By
following this guide, you will be able to configure the 460ESDFM-NNA4 gateway.
For further customization and advanced use, please reference the appendices located on the CD or
online at: http://www.rtaautomation.com/product/460-gateway-support/.
If at any time you need further assistance do not hesitate to call Real Time Automation support.
Support Hours are Monday-Friday 8am-5pm CST
Toll free: 1-800-249-1612
Email: support@rtaautomation.com
Real Time Automation, Inc.
7
1-800-249-1612
Hardware Platforms
The 460 Product Line supports a number of different hardware platforms. There are differences in how
they are powered, what serial settings are supported, and some diagnostic features supported (such as
LEDs). For these sections, be sure to identify the hardware platform you are using.
To find which hardware platform you are using:
1) Look on the front or back label of the unit for the part number.
2) On the webpage inside the gateway, navigate to the dropdown menu under Other and select
Utilities. Click the Listing of Revisions button. The full part number is displayed here.
Once you have the full part number, the platform will be the number following the “-N”:
Real Time Automation, Inc.
8
1-800-249-1612
Hardware –NNA4
Powering the Gateway
An 8-24 VDC power source to the gateway, Red Wire = (+) Black Wire = (-).
a. The unit draws 175mA @ 12V.
Real Time Automation, Inc.
9
1-800-249-1612
Port Configuration
The Port Configuration page is where you set port specific parameters. These settings must match the
settings of the device(s) that you are connecting to.
When you have completed your port configuration, click the Save Parameters button.
Real Time Automation, Inc.
10
1-800-249-1612
Mounting with a DIN Rail
Installing
Follow these steps to install your interface converter.
1) Mount your DIN Rail.
2) Hook the top mounting flange over the DIN Rail.
3) While pressing the 515RTAAIC against the rail, press down to engage the spring loaded upper
clip and rotate the unit parallel to the DIN Rail.
4) Release downward pressure.
Removing
Follow these steps to remove your interface converter.
1) Press down on unit to engage the spring loaded upper clip.
2) Swing bottom of unit away from DIN Rail.
DIN Rail
Spring Loaded Upper Clip
Inhaltsverzeichnis
Andere RTA Tor Handbücher
RTA
RTA 460BS-NNA1 Technisches Datenblatt
RTA
RTA 460ESUS-N2E Technisches Datenblatt
RTA
RTA 460BSA-NNA4 Technisches Datenblatt
RTA
RTA 460MMBS-NNA4 Technisches Datenblatt
RTA
RTA 460ECES-NNA1 Technisches Datenblatt
RTA
RTA 460PSUSB-NNCU Technisches Datenblatt
RTA
RTA 460DFMSC-N2E Technisches Datenblatt
RTA
RTA 460BMUS-NNA4 Technisches Datenblatt
RTA
RTA 460MRSA-NNA4 Technisches Datenblatt
RTA
RTA 460ESSC-NNA4 Technisches Datenblatt
RTA
RTA 460ESUSB-NNCU Technisches Datenblatt
RTA
RTA 460DFMSC-NNA1 Technisches Datenblatt
RTA
RTA 460ETCMS-NNA4 Technisches Datenblatt
RTA
RTA 460ECPS-N700 Technisches Datenblatt
RTA
RTA 460BM-N2EW Technisches Datenblatt
RTA
RTA 460ETCMC-NNA1 Technisches Datenblatt
RTA
RTA 460ETC-N2E Technisches Datenblatt
RTA
RTA 460ESMRS-NNA4 Technisches Datenblatt
RTA
RTA 460PSBC-NNA4 Technisches Datenblatt
RTA
RTA 460ESMC-NNA1 Technisches Datenblatt
Beliebte Tor Handbücher anderer Marken
LST
LST M500RFE-AS Bedienungsanleitung
Kinnex
Kinnex Media Gateway Bedienungsanleitung
2N Telekomunikace
2N Telekomunikace 2N StarGate Bedienungsanleitung
Mitsubishi Heavy Industries
Mitsubishi Heavy Industries Superlink SC-WBGW256 Bedienungsanleitung
ZyXEL Communications
ZyXEL Communications ZYWALL2 ET 2WE Bedienungsanleitung
Telsey
Telsey CPVA 500 - SIP Bedienungsanleitung
HMS
HMS Netbiter EasyConnect EC150 Bedienungsanleitung
Huawei
Huawei EchoLife HG620 Bedienungsanleitung
AT&T
AT&T U-verse 3801 Gebrauchs- und Pflegehandbuch
Logic IO
Logic IO RTCU MX2 turbo Bedienungsanleitung
Suttle
Suttle MediaMAX MXM-521 Bedienungsanleitung
Rosonix Technology
Rosonix Technology RSG-3000 Bedienungsanleitung