RTA 515ENI-N34 Technisches Datenblatt

515RTAENI-N34

Protocol Gateway

Product User Guide

Firmware Version 4.02

All manuals and user guides at all-guides.com

all-guides.com

Real Time Automation, Inc.

1-800-249-1612

Trademarks

CompactLogix, ControlLogix, & PLC-5 are registered trademarks of Rockwell Automation, Inc. EtherNet/IP is a trademark of the

ODVA. MicroLogix, RSLogix 500, SLC, and PanelView are trademarks of Rockwell Automation, Inc. Microsoft, Windows, and

Internet Explorer are registered trademarks of Microsoft Corporation. Kepware is a registered trademark of Kepware

Technologies, a software development business of PTC Inc. All other trademarks and registered trademarks are the property of

their holders.

Limited Warranty

Real Time Automation, Inc. warrants that this product is free from defects and functions properly.

EXCEPT AS SPECIFICALLY SET FORTH ABOVE, REAL TIME AUTOMATION, INC. DISCLAIMS ALL OTHER WARRANTIES, BOTH

EXPRESSED AND IMPLIED, INCLUDING BUT NOT LIMITED TO IMPLIED WARRANTIES OF MERCHANTABILITY OR FITNESS FOR AN

APPLICATION. THIS LIMITED WARRANTY GIVES YOU SPECIFIC LEGAL RIGHTS. YOU MAY ALSO HAVE OTHER RIGHTS, WHICH VARY

FROM STATE TO STATE.

The examples and diagrams in this manual are included solely for illustrative purposes. Because of the many variables and

requirements associated with any application, Real Time Automation, Inc. cannot assume responsibility or liability for actual use

based on the examples and diagrams. Except as specifically set forth above, Real Time Automation and its distributors and

dealers will in no event be liable for any damages whatsoever, either direct or indirect, including but not limited to loss of

business profits, income, or use of data. Some states do not allow exclusion or limitation of incidental or consequential

damages; therefore, the limitations set forth in this agreement may not apply to you.

No patent liability is assumed by Real Time Automation with respect to use of information, circuits, equipment, or software

described in this manual.

Government End-Users

If this software is acquired by or on behalf of a unit or agency of the United States Government, this provision applies: The

software (a) was developed at private expense, is existing computer software, and was not developed with government funds;

(b) is a trade secret of Real Time Automation, Inc. for all purposes of the Freedom of Information Act; (c) is “restricted

computer software” submitted with restricted rights in accordance with subparagraphs (a) through (d) of the Commercial

“Computer Software-Restricted Rights” clause at 52.227-19 and its successors; (d) in all respects is proprietary data belonging

solely to Real Time Automation, Inc.; (e) is unpublished and all rights are reserved under copyright laws of the United States.

For units of the Department of Defense (DoD), this software is licensed only with “Restricted Rights”: as that term is defined in

the DoD Supplement of the Federal Acquisition Regulation 52.227-7013 (c) (1) (ii), rights in Technical Data and Computer

Software and its successors, and: Use, duplication, or disclosures is subject to restrictions as set forth in subdivision (c) (1) (ii) of

the Rights in Technical Data and Computer Software clause at 52.227-7013. If this software was acquired under GSA schedule,

the U.S. Government has agreed to refrain from changing or removing any insignia or lettering from the Software or

documentation that is provided or from producing copies of the manual or media. Real Time Automation, Inc.

All manuals and user guides at all-guides.com

Real Time Automation, Inc.

1-800-249-1612

Contents

Revision History ............................................................................................................................................5

Overview .......................................................................................................................................................7

Hardware –N34............................................................................................................................................8

Mounting.......................................................................................................................................................9

Installing................................................................................................................................................9

Removing ..............................................................................................................................................9

Powering the Gateway................................................................................................................................10

Pinouts & Wiring.........................................................................................................................................11

Pinouts ................................................................................................................................................11

Wiring 11

Accessing the Main Page.............................................................................................................................12

Error: Main Page Does Not Launch 13

Web Configuration Tabs .............................................................................................................................14

Committing Changes to the Gateway.........................................................................................................15

Network Tab................................................................................................................................................16

Ethernet Settings 16

Changing from DHCP to Static IP 17

Additional Fields under Ethernet Settings ..........................................................................................17

Serial Settings 18

Email Settings 19

Email Alarms and Messages 20

Email Message Example......................................................................................................................21

Data View Tab.............................................................................................................................................22

Mapping Tab ...............................................................................................................................................23

Utility Tab....................................................................................................................................................25

Export/Import Configuration 25

Import Configuration ..........................................................................................................................25

Export Configuration...........................................................................................................................25

Restart Gateway 26

Upgrade Firmware 26

EtherNet/IP EDS File 26

All manuals and user guides at all-guides.com

Real Time Automation, Inc.

1-800-249-1612

Other References 26

Reference Links...................................................................................................................................26

NET ENI Event Log Values ...................................................................................................................27

Security Configuration 28

Home Tab (Diagnostics) ..............................................................................................................................30

Msg Log Tab ........................................................................................................................................30

DF1 Status 31

DF1 Counters.......................................................................................................................................31

Serial Diagnostic Tab...........................................................................................................................32

Ethernet Status 33

Ethernet Status: Counters...................................................................................................................33

Ethernet Diagnostics Tab .................................................................................................................... 34

LED Behavior 35

DF1 Node Descriptions Reference Table 36

Easily replace an existing NETENI device 39

Using RSLinx and RSLogix 40

EtherNet/IP Driver ..............................................................................................................................40

Ethernet Driver ...................................................................................................................................43

Troubleshooting RSLinx and RSLogix Comms .............................................................................................44

Application Specific Tips .............................................................................................................................45

PanelView Plus Comms 45

Kepware Communications 48

All manuals and user guides at all-guides.com

Real Time Automation, Inc.

1-800-249-1612

Revision History

Version

Date

Notes

3.29

01/01/2017

Product Launch

3.30

3/14/2017

Bug Fixes

1. Fixes for setting Network Config using RSLinx

2. Fixes for setting Serial and Ethernet config using old AB

1761-NET-ENI/W Serial PC Config Utility

3. EIP Stack upgrades required by new EIP conformance test

(as of 1/2/17)

3.31

3/14/2017

Bug Fixes

1. Communication fix to work with InduSoft applications

2. PanelView Duplicate Packet Detect communications fix

3. BootP fixes

4. Data View webpage floating point writes fixed

5. Minor webpage layout fixes

6. Change to force at least 1 admin to "Full Access" when

security enabled

3.32

3/14/2017

Bug Fixes

1. Disabled force of at least 1 Admin when security is enabled

(see change 6 in version 3.31).

4.02

7/26/2017

Bug Fixes

1. Updated web UI diagnostics and counters.

2. Added support for RSLinx straight Ethernet driver.

3. Optimized message queue servicing.

4. Added ability to download EDS file from webpage.

5. Removed BOOTP support.

6. Improved IP configuration implementation.

All manuals and user guides at all-guides.com

Real Time Automation, Inc.

1-800-249-1612

7. Enabled force of at least 1 Admin when security is enabled.

8. Minor webpage layout fixes.

All manuals and user guides at all-guides.com

all-guides.com

Real Time Automation, Inc.

1-800-249-1612

Overview

The 515RTAENI is a replacement for the Allen-Bradley 1761-NET-ENI and 1761-NET-ENIW modules. The

515RTAENI gateway:

•Provides the same Ethernet connectivity for all DF1 serial controllers, PanelView Standard

Terminals, and other DF1 full-duplex devices

•Communicates between Allen-Bradley Logix and legacy controllers

•Generates email messages via Simple Mail Transport Protocol (SMTP)

•Allows ability to easily upload and download programs using standard Rockwell Automation

tools

•Writes to Ethernet controllers like ControlLogix

However, the interface is improved by providing web browser configuration, allowing up to 12 Ethernet

connections, adding support for string data types, and improving diagnostic functionality.

If at any time you need further assistance do not hesitate to call Real Time Automation support.

Support Hours are Monday-Friday 8am-5pm CST

Toll free: 1-800-249-1612

Email: support@rtaautomation.com

All manuals and user guides at all-guides.com

Real Time Automation, Inc.

1-800-249-1612

Hardware –N34

Physical Specifications

POWER

8 V @ 230 mA to 28 V @ 80 mA

Power can be received over serial cable

TEMPERATURE

Industrial Temperature Range -40C to +85C

CERTIFICATIONS

UL, C/UL, CE, FCC, CLASS 1 DIV 2

MOUNTING

Din Rail, Panel

SIZE

4.2” x 3.25” x 1#

WEIGHT

5 oz.

COMMUNICATION PORTS

SERIAL

1 RS232

ETHERNET

1 10/100 Mbps BaseT Ethernet Port

All manuals and user guides at all-guides.com

Real Time Automation, Inc.

1-800-249-1612

Mounting

Installing

Follow these steps to install your interface converter.

1. Mount your DIN Rail.

2. Hook the top mounting flange over the DIN Rail.

3. While pressing the 515RTAENI against the rail, press down to engage the spring loaded

upper clip and rotate the unit parallel to the DIN Rail.

4. Release downward pressure.

Removing

Follow these steps to remove your interface converter.

1. Press down on unit to engage the spring loaded upper clip.

2. Swing bottom of unit away from DIN Rail.

DIN Rail

Spring Loaded Upper Clip

All manuals and user guides at all-guides.com

Real Time Automation, Inc.

1-800-249-1612

Powering the Gateway

The following steps will allow you to properly and safely power the gateway.

1) Connect a 24VDC power source to the gateway.

a. The unit draws 125 mA at 24VDC

b. The gateway has a voltage operating range from 8-28VDC; 24VDC is recommended.

Hazardous Environment Power & Installation Instructions

This equipment is suitable for use in Class I, Division 2, Groups A, B, C and D, or non-

hazardous locations only.

WARNING –EXPLOSION HAZARD - Do not disconnect equipment unless power has been removed or

the area is known to be non-hazardous.

WARNING –EXPLOSION HAZARD - Substitution of components may impair suitability for Class I,

Division 2.

THIS EQUIPMENT IS AN OPEN-TYPE DEVICE AND IS MEANT TO BE INSTALLED IN AN ENCLOSURE

SUITABLE FOR THE ENVIRONMENT SUCH THAT THE EQUIPMENT IS ONLY ACCESSIBLE WITH THE

USE OF A TOOL.

WARNING –POWER JACK (Barrel Connector, J1) IS FOR MAINTENANCE USE ONLY AND MAY ONLY BE

USED WHILE THE AREA IS KNOWN TO BE FREE OF IGNITIBLE CONCENTRATIONS OF FLAMMABLE GASES

OR VAPORS. IT IS NOT TO BE CONNECTED UNDER NORMAL OPERATION.

In a Hazardous Environment, the unit must be powered with between 12-24 VDC; 860 mA (6 W) max.

Supervised. The unit is certified to be operated at -40C to 50°C.

Warning improper wiring will cause unit failure

Use the Barrel Connector OR the Screw

Terminals power connection, NOT both

All manuals and user guides at all-guides.com

Inhaltsverzeichnis

Andere RTA Tor Handbücher

RTA

RTA 460MRSBS-NNA4 Technisches Datenblatt

RTA

RTA 460ETCQT-NNA1 Technisches Datenblatt

RTA

RTA 460QT-NNA1 Technisches Datenblatt

RTA

RTA 460MCBC-N700 Technisches Datenblatt

RTA

RTA 460MMBMS-N700 Technisches Datenblatt

RTA

RTA 460BCSC-N700 Technisches Datenblatt

RTA

RTA 460ETCPS-NNA4 Technisches Datenblatt

RTA

RTA 460BCSC-NNA4 Technisches Datenblatt

RTA

RTA 460PSBS-N2EW Technisches Datenblatt

RTA

RTA 460MSA-N2EW Technisches Datenblatt

RTA

RTA 460MCBMS-NNA4 Technisches Datenblatt

RTA

RTA 460ECDFM-N34 Technisches Datenblatt

RTA

RTA 460PBSTCP-N70PB Technisches Datenblatt

RTA

RTA 460PSDFM-N34 Technisches Datenblatt

RTA

RTA 460ETCMRS-NNA4 Technisches Datenblatt

RTA

RTA 460MCWI-N2EW Technisches Datenblatt

RTA

RTA 460ETCBM-NNA4 Technisches Datenblatt

RTA

RTA 460MRSQT-NNA4 Technisches Datenblatt

RTA

RTA 460BSDFM-N700 Technisches Datenblatt

RTA

RTA 460ECETC-NNA1 Technisches Datenblatt

RTA

RTA 460MSBC-NNA1 Technisches Datenblatt

RTA

RTA 460ESBM-N34 Technisches Datenblatt

RTA

RTA 460MSMM-N2EW Technisches Datenblatt

RTA

RTA 460MCBM-N700 Technisches Datenblatt

Beliebte Tor Handbücher anderer Marken

LST

LST M500RFE-AS Bedienungsanleitung

Kinnex

Kinnex Media Gateway Bedienungsanleitung

2N Telekomunikace

2N Telekomunikace 2N StarGate Bedienungsanleitung

Mitsubishi Heavy Industries

Mitsubishi Heavy Industries Superlink SC-WBGW256 Bedienungsanleitung

ZyXEL Communications

ZyXEL Communications ZYWALL2 ET 2WE Bedienungsanleitung

Telsey

Telsey CPVA 500 - SIP Bedienungsanleitung

Shaw

Shaw Gateway HDPVR Bedienungsanleitung

ABB

ABB VSN900 Kurzanleitung

Commander

Commander Pulse Bedienungsanleitung

2N Telekomunikace

2N Telekomunikace ATEUS EasyGate 501309E Bedienungsanleitung

NETGEAR

NETGEAR C6300BD Bedienungsanleitung

Amit

Amit CDW531AM Bedienungsanleitung

HMS

HMS Netbiter EasyConnect EC150 Bedienungsanleitung

Huawei

Huawei EchoLife HG620 Bedienungsanleitung

AT&T

AT&T U-verse 3801 Gebrauchs- und Pflegehandbuch

Logic IO

Logic IO RTCU MX2 turbo Bedienungsanleitung

Suttle

Suttle MediaMAX MXM-521 Bedienungsanleitung

Rosonix Technology

Rosonix Technology RSG-3000 Bedienungsanleitung