Russell Hobbs 14174 Bedienungsanleitung

instructions

Read the instructions and keep them safe. If you pass the kettle on, pass on the

instructions too. Remove all packaging, but keep it till you know the kettle works.

important safeguards

Follow basic safety precautions, including:

1 This kettle must only be used by or under the supervision of a responsible adult.

2 Don’t put the kettle, stand, cable, or plug in any liquid; don’t use the kettle

in a bathroom, near water, or outdoors.

3 Don’t touch hot surfaces. Use the handle, lid release button, and plastic

ﬁngerplate.

4 Don’t open the lid while the water is heating.

5 Take care when pouring – pour slowly, and don’t over-tilt the kettle.

6 The scald hazard lasts long after boiling. Keep the kettle, stand, and cable away from

the edges of worktops and out of reach of children.

7 Route the cable so it doesn’t overhang, and can’t be tripped over or caught.

8 Wind excess cable beneath the stand.

9 Store the kettle out of reach of children.

10 Unplug the stand when not in use, before moving and before cleaning. Let the

kettle cool down before cleaning and storing away.

11 Check the lid is fully closed before switching the kettle on, otherwise it may not

switch oﬀ.

12 Check the kettle is properly located on the stand before switching on.

13 Don’t switch on unless the kettle contains at least 2 cups of water.

14 Don’t ﬁll past the max mark, or it may spit boiling water.

15 Remove the kettle from its stand before ﬁlling or pouring.

16 Keep the kettle, stand, cable, and plug away from sources of heat.

17 Don’t use the kettle for any purpose other than heating water.

18 Use the kettle only with the stand supplied (and vice versa).

19 This appliance must not be operated by an external timer or remote control system.

20 Don’t operate the kettle if it’s damaged or malfunctions.

21 If the cable is damaged, the kettle must be returned, in order to avoid hazard.

household use only

before using for the ﬁrst time

1 Fill to max, boil, discard the water, then rinse. Do this three times, to remove

manufacturing dust, etc.

positioning

2 Put the stand on a stable, level surface. Route the cable so it doesn’t overhang, and

can’t be caught or tripped over.

3 Wind excess cable beneath the stand.

ﬁlling

caution keep clear, steam may escape from the lid.

4 Remove the kettle from the stand.

5 Press the lid release button to open the lid.

6 Fill with at least 2 cups of water, but not above max.

7 If you overﬁll, the kettle may spit boiling water.

8 Press the lid down, touching only the plastic ﬁngerplate, to close it.

9 Check the lid is closed, or the kettle won’t switch oﬀ when it boils.

switching on

10 Plug the stand into the wall socket.

11 Put the kettle on the stand – take care not to spill.

12 Move the switch to 1.

13 The switch will light up, and the kettle will heat up.

switching oﬀ

14 When the water boils the kettle will switch oﬀ and the light will go out.

15 To switch oﬀ manually, move the switch to 0.

16 Lifting the kettle oﬀ the stand will also switch the kettle oﬀ.

general

17 Remove the kettle from the stand before pouring.

18 To avoid the risk of splashing, pour slowly and don’t over-tilt the kettle.

19 Don’t tilt the kettle backwards, water might get on to the control area. If this

happens, let the kettle dry before use – sit it somewhere warm for 12 hours.

20 When you lift the kettle, you may see moisture on the stand. Don’t worry – it’s the

steam used to switch oﬀ automatically, which then condenses and escapes via vents

under the kettle.

21 You may see some discolouration on the ﬂoor of the kettle. Again, don’t worry – it’s

due to the bonding of the element to the kettle ﬂoor.

using with insuﬃcient water

22 This will shorten the life of the element. A boil-dry cut-out will switch the kettle oﬀ.

23 To prevent the kettle cycling on and oﬀ, remove the kettle from the stand and let it

cool before replacing it on the stand.

24 Sit the kettle on the work surface till it’s cold.

25 Don’t ﬁll the kettle till it’s cold, or it may spit.

care and maintenance

1 Check that the kettle is switched oﬀ – move the switch to 0.

2 Unplug the stand, and let the kettle cool down fully.

3 Wipe the kettle, inside and out, with a damp cloth. You may use a little household

detergent, but if you do, rinse well to avoid tainting the water.

4 Keep all connectors and sockets dry.

5 Don’t put the kettle or stand in any liquid.

6 Don’t use harsh or abrasive cleaning agents or solvents.

descale regularly – even in soft water areas

7 Limescale may be white, coloured, even rusty-looking, but it’s normally visible.

8 Phosphate scale isn’t generally visible, but it’s there, even in soft water areas.

9 All scale causes overheating, reduces the kettle’s life, and may trigger the boil-dry

cut-out.

10 So, even with soft water, descale regularly, to help keep your kettle in working order.

11 Use a descaler suitable for plastic products (all kettles have plastic parts).

12 Follow the instructions on the descaler, rinse several times, then ﬁll, boil and discard

the water, to ensure no residues are left.

, Products returned under guarantee with faults due to scale will be subject to a

repair charge.

water ﬁlter

13 Scale particles suspended in the water may give it a cloudy or greasy appearance.

The ﬁlter will prevent these particles going into your drink. If you see deposits on

the ﬁlter, clean it, otherwise the performance of your kettle will drop, your drinks

may contain scale, and the water inside the kettle may look cloudy.

cleaning the ﬁlter

14 Check your hands are free from soap, or anything which might leave a taint.

15 Switch the kettle oﬀ, and let it cool.

16 Open the lid.

release the ﬁlter

17 Grip the top of the ﬁlter, and pull it up, and out of the kettle..

18 Rinse the ﬁlter under a running tap while brushing with a soft brush.

19 Rinse the kettle, in case scale particles have fallen inside.

replace the ﬁlter

20 Slide it down, into the guides.

21 Close the lid.

connection

The product must be earthed. It has a 13A BS1362 fuse in a 13A BS1363

plug. To replace the plug, ﬁt the green/yellow wire to E or E, the blue

wire to N, and the brown wire to L. Fit the cord grip.

If in doubt, call an electrician.

Don’t use a non-rewireable/moulded plug unless the fuse cover is in

place. If you remove the plug, dispose of it.

service

The product isn’t user-serviceable. If it’s not working, read the instructions, check the

plug fuse and main fuse/circuit breaker. If it’s still not working, consult your retailer. If

that doesn’t solve the problem:

Pack carefully, with a note of your name, address, day phone number, and what’s

wrong. If under guarantee, say where and when purchased, and include proof of

purchase (till receipt). Send it to Customer Returns (address below right).

Customer Service Customer Returns

(correspondence only) Salton Europe Ltd

Salton Europe Ltd Heath Mill Road

Failsworth Wombourne

Manchester Wolverhampton

M35 0HS WV5 8AQ

Customer Service (service@saltoneurope.com)

telephone 0845 658 9700 (local rate number)

guarantee

Defects aﬀecting product functionality appearing within one year of purchase

will be corrected by replacement or repair provided the product is used and

maintained in accordance with the instructions. Your statutory rights are not aﬀected.

Documentation, packaging, and product speciﬁcations may change without notice.

online

Hit www.russellhobbs.co.uk for more products.

439-672

Inhaltsverzeichnis

Andere Russell Hobbs Wasserkocher Handbücher

Russell Hobbs

Russell Hobbs Cambridge Bedienungsanleitung

Russell Hobbs

Russell Hobbs 11240 Installationsanleitung

Russell Hobbs

Russell Hobbs 14743-56 Bedienungsanleitung

Russell Hobbs

Russell Hobbs 21671-70 Bedienungsanleitung

Russell Hobbs

Russell Hobbs MONTANA 10585 Installationsanleitung

Russell Hobbs

Russell Hobbs BRIGHTON 20432AU Installationsanleitung

Russell Hobbs

Russell Hobbs 18554-70 Bedienungsanleitung

Russell Hobbs

Russell Hobbs 26300-70 Bedienungsanleitung

Russell Hobbs

Russell Hobbs 18830 Bedienungsanleitung

Russell Hobbs

Russell Hobbs 23912-70 Bedienungsanleitung

Russell Hobbs

Russell Hobbs 21150-70 Bedienungsanleitung

Russell Hobbs

Russell Hobbs 21040-56 Bedienungsanleitung

Russell Hobbs

Russell Hobbs MIDNIGHT RHK82BKF Installationsanleitung

Russell Hobbs

Russell Hobbs Quick 2 Boil Bedienungsanleitung

Russell Hobbs

Russell Hobbs LEGACY RHK122 Series Bedienungsanleitung

Russell Hobbs

Russell Hobbs 20441 Bedienungsanleitung

Russell Hobbs

Russell Hobbs Structure RHK332 Series Installationsanleitung

Russell Hobbs

Russell Hobbs 14387 Bedienungsanleitung

Russell Hobbs

Russell Hobbs 14962-56 Bedienungsanleitung

Russell Hobbs

Russell Hobbs 22851 Bedienungsanleitung

Russell Hobbs

Russell Hobbs LUNAR RHK62 Series Installationsanleitung

Russell Hobbs

Russell Hobbs 23211-70 Bedienungsanleitung

Russell Hobbs

Russell Hobbs 21150-70 Bedienungsanleitung

Russell Hobbs

Russell Hobbs 14617 Bedienungsanleitung

Beliebte Wasserkocher Handbücher anderer Marken

IKEA

IKEA UPPHETTA Bedienungsanleitung

Krups

Krups BW500B55 Bedienungsanleitung

Clas Ohlson

Clas Ohlson KE7086-BH Bedienungsanleitung

Brock

Brock WK 0902 GR Bedienungsanleitung

inventum

inventum CBW010 Bedienungsanleitung

Westfalia

Westfalia Retro 81 48 86 Bedienungsanleitung

Ovente

Ovente KS88 Series Abmessungen

HUSLOG

HUSLOG AK-0832 Bedienungsanleitung

Saturn

Saturn ST-EK840 Bedienungsanleitung

Wilfa

Wilfa TK-1200B Bedienungsanleitung

HOME ELEMENT

HOME ELEMENT HE-KT150 Bedienungsanleitung

Breville

Breville Crystal Clear BKE290 Bedienungsanleitung

ECG

ECG RK 1745 Bedienungsanleitung

cecotec

cecotec THERMOSENSE 600 TOUCH BLACK Bedienungsanleitung

Kalorik

Kalorik JK 39825 Bedienungsanleitung

tomado

tomado TM-1971 Bedienungsanleitung

Cosori

Cosori CS108-NK Bedienungsanleitung

Electrolux

Electrolux E7K1-6BP Bedienungsanleitung