RUSTA 90651097 Bedienungsanleitung

Manual/Bruksanvisning/Gebrauchsanweisung

SE

ENG NO DE

Item. No. 90651097

Electric ﬁreplace

Dekorationsbrasa / Dekorasjonsovn / Dekorationskamin

2

ENG

Electric ﬁreplace

IMPORTANT SAFETY INFORMATION: Always read this manual ﬁrst before attempting to

install or use this ﬁreplace. For your safety, always comply with all warnings and safety

instructions contained in this manual to prevent personal injury or property damage.

Keep the user manual for future reference.

SAFETY INSTRUCTIONS

When using electrical appliances, basic precautions should always be

followed to reduce the risk of ﬁre, electric shock, and injury to persons,

including the following:

• Read all instructions before using the electric ﬁreplace.

• This ﬁreplace is hot when in use. To avoid burns, do not let bare skin

touch hot surfaces. The trim around the heater outlet becomes hot

during heater operation.

• Extreme caution is necessary when any heater is used near children

and whenever the unit is left operating and unattended.

• Always unplug the ﬁreplace when not in use.

• Young children should be supervised to ensure that they do not play

with the appliance

• The appliance is not intended for use by young children or inﬁrmed

persons without supervision.

• If the supply cord is damaged, it must be replaced by a qualiﬁed person

in order to avoid a hazard.

• Do not operate any unit with a damaged cord or plug, or if the heater

has malfunctioned, or if the electric ﬁreplace has been dropped or

damaged in any manner, please ask for help from a qualiﬁed technician.

• Do not use outdoors.

• This ﬁreplace is not intended for use in bathrooms, laundry areas and

similar indoor locations. never locate heater where it may fall into a

bathtub or other water container.

Thank you for choosing to

purchase a product from Rusta!

Read through the entire manual

before installation and use!

3

• High temperature! Keep electrical cords, drapery, and other furnish-

ings at least 3 feet (0.9m) from the front of the heater and away from

the side and rear.

• Do not run the cord under carpeting. Do not cover cord with throw

rugs, runners, or the like. Arrange cord away from trac area and

where it will not be tripped over.

• The heater must not be located immediately below a socket outlet.

• To disconnect the ﬁreplace, turn the controls o, then remove the plug

from the outlet.

• Do not insert or allow foreign objects to enter any ventilation or ex-

haust opening as this may cause an electric shock or ﬁre, or damage

to the heater.

• Do not block air intake or exhaust in any manner. Do not use on soft

surfaces, like a bed, where openings may become blocked.

• All electrical heaters have hot and arcing or sparking parts inside.

Do not use in areas where gasoline, paint, or ﬂammable liquids are

used or stored or where the unit will be exposed to ﬂammable vapors.

• Do not modify the electric ﬁreplace. use it only as described in this

manual. Any other use not recommended by the manufacturer may

cause ﬁre, electric shock or injury to persons.

• Avoid the use of an extension cord. Extension cords may overheat and

cause a risk of ﬁre. This heater is not intended for use with an exten-

sion cord. Plug the cord directly into an appropriate wall receptacle.

• Do not burn wood or other materials in the electric ﬁreplace.

• Do not strike the ﬁreplace glass.

• Always use a certiﬁed electrician if new circuits or outlets should be

required.

• Always use properly grounded, fused and polarized outlets.

• Disconnect all power supply before performing any cleaning, main-

tenance or relocation of the unit.

WARNING!

If these instructions are not followed, an accident may

lead to serious personal injury or property damage.

4

ENG

• When transporting or storing the unit and cord, keep in a dry place,

free from excessive vibration and store so as to avoid damage.

• If the supply cord is damaged, it must be replaced by the manufacturer,

its service agent or similarly qualiﬁed persons in order to avoid a hazard.

• Do not use this heater in the immediate surroundings of a bath, a shower

or a swimming pool.

CAUTION! Risk of electric shock. Do not open. No user-servicable

parts inside.

QUICK REFERENCE GUIDE

1. The heater may emit a slight, harmless odor when ﬁrst used. This odor is a normal

condition caused by the initial heating of internal heater parts.

2. For dimensions and speciﬁcation of your ﬁreplace, please refer to below:

5

FIREPLACE INSTALLATION

WARNING! The heater in the electric ﬁreplace is not equipped with a device to control

the room temperature.

SITE SELECTION

NOTE! A 230 Voltage circuit is required. A dedicated circuit is preferred but not necessary

in all cases. A dedicated circuit will be required if, after installation, the circuit breaker

trips or the fuse blows on a regular basis when the heater in the electric ﬁreplace ope-

rating. Additional appliances on the same circuit may exceed the current rating of the

circuit breaker.

WARNING! Ensure the power cord is not installed so that it is pinched or against a

sharp edge and ensure that the power cord is stored or secured to avoid tripping or

snagging to reduce the risk of ﬁre, electric shock or injury to persons.

Construction and electrical outlet wiring must comply with local building codes and other

applicable regulations to reduce the risk of ﬁre, electric shock and injury to persons.

Do not attempt to wire your own new outlets or circuits. To reduce the risk of ﬁre, electric

shock or injury to persons, always use a licensed electrician.

WARNING! In order to avoid overheating, do not cover the heater.

NOTE! For safety reason, please ensure the vent on heater is not less than 150cm away

from other objects.

Model Number 9065-1097

Description Electric ﬁreplace

Voltage 230V~50HZ

Watts 900/1800W

TECHNICAL DATA

6

ENG

Wall anchor

Screw

Wall bracket

WALL MOUNTING INSTRUCTIONS

WARNING! Failure to install ﬁreplace as instructed below may result in damage to

the equipment and or may expose the user to the risk of ﬁre, serious injury, illness

or death.

CAUTION! Select an appropriate location to mount the unit on a wall, near an electrical

outlet. Access to the electrical outlet must be maintained. Ensure the installation meets

the national and state/provincial electrical codes.

1. Have two people hold the appliance against the wall to determine the ﬁnal location

to maintain an optimized viewing angle of the ﬂame. To ensure a suitable location for

mounting bracket, then make the holes.

2. First install the wall anchors into the holes, then tighten the mounting bracket by

screws supplied. (See the assembly description down below).

3. With the screws installed have two people lift the appliance up and insert the screws

into the keyholes on the back of the appliance.

4. Make sure the electric ﬁreplace is ﬁrmly ﬁxed.

5. Install anchors into the ﬁxed block holes, secure using the screw provided.

6. Check the appliance for stability ensuring that the appliance will not pull free from the wall.

Shoulder

screw

GLASS FRONT INSTALLATION

It is recommended that two people install this glass front onto the

appliance, wear safety glassesand gloves when handling glass.

1. Line up the brackets on the back of the glass with the

screws on the side of the appliance body.

2. Hang the glass front.

NOTE! For safety reason, please ensure the vent on heater is

not less than 150 cm away.

7

OPERATION

CAUTION! Once the appliance has been plugged in to a grounded electrical outlet, it is

ready to ope-rate. Ensure the house circuit breakers for the power supply are turned on.

In the event of a power failure, both the ﬂame and heating function will remain turned o

when the power is restored.

The switch is located on the top right hand side of the appliance.

1. Main Switch

The main switch supplies power to all ﬁreplace functions. Press the button to “I” side

to turn on the appliance, press “O” to turn o the appliance. When the main switch at “I”

side, press once to open the ﬂame and heating function is ready to start.

2. Heating Function

It has two heat settings, ﬁrst ensure the ﬂame

is on by pressing , then press the power is

900W. Press this button again, heating function

is turned o. Press the power is 1800W. Press

this button again, heating function is turned o.

NOTE! The ﬁreplace can be turned o at any

point by pressing the button .

REMOTE CONTROL

NOTE! Make certain the batteries are installed correctly and are new.

1. Make certain the appliance’s main power switch “O/I” is at the “I” side. The remote

control will NOT work if the Main Power Switch is at the “O” position.

2. When operating the remote control, it must be directed towards the front center of the

appliance.

3. Press to open the ﬂame and heating function is ready to start.

4. Press button on remote to make the ﬂame function work. Press

this button once, the brightnessof ﬂame is decreased or increased

gradually, and form a cycle. Press this button again, brightnessof

ﬂame is ﬁxed.

5. Press button, the heating function works and this is low heat

900W. Press , the power reach high heat 1800W.

6. Press the button again, all functions will be shut o.

NOTE! This remote control must remain within 8–10 meters of the

appliance to be eective.

8

MAINTENANCE

WARNING! Always disconnect power before attempting any maintenance or cleaning

to reduce the risk of ﬁre, electric shock or damage to persons.

GLASS CLEANING

Glass is cleaned in the factory during the assembly operation. During shipment, installa-

tion, handling, etc., the glass may collect dust particles; these can be removed by dusting

lightly with a clean dry cloth. To remove ﬁngerprints or other marks, can be cleaned with

a damp cloth. The glass should be completely dried with a lint free cloth to prevent water

spots. To prevent scratching, do not use abrasive cleaners.

ENG

RIGHT OF COMPLAINT

By law the product must be returned to the place of purchase along with the original

receipt in the event of a complaint. The user is liable for any damage to the product that

is caused by not using the product for its intended purpose or by not following this user

manual correctly. The right of complaint will not apply in these instances.

INFORMATION ABOUT HAZARDOUS WASTE

Used products should be handled separately from

household waste. They should be taken for recycling in

accordance with local rules for waste management.

........................................................................................................................................................................................................

NOTES

10

SE

Dekorationsbrasa

VIKTIG SÄKERHETSINFORMATION: Läs den här bruksanvisningen innan du monterar eller

använder dekorationsbrasan. Följ alltid, för din egensäkerhet, alla varningar och säker-

hetsanvisningar i den här bruksan-visningen, så förebygger du sak- eller personskador.

Spara bruksanvisningen för senare bruk.

SÄKERHETSFÖRESKRIFTER

Vid användning av elektriska apparater, bör grundläggande försik-

tighetsåtgärder som minskar risken för brand, elektriska stötar och

personskada alltid följas, inklusive följande:

• Läs alla anvisningar innan du börjar använda dekorationsbrasan.

• Eldstaden är varm när den används. Undvik brännskador; låt inte de

varma ytorna komma i kontakt med huden. Listen kring värmeutsläp-

pet blir varm när elementet används.

• Mycket stor försiktighet ska iakttas när apparaten används i närheten

av barn och när apparaten lämnas på utan övervakning.

• Dra alltid ur kontakten till dekorationsbrasan när den inte används.

• Små barn ska hållas under uppsikt så att de inte leker med apparaten.

• Apparaten är inte avsedd att användas av barn.

• Om sladden är skadad måste den bytas ut av en kvaliﬁcerad person

för att undvika fara.

• Använd inte apparaten om sladden eller kontakten är skadad, om deko-

rationsbrasan inte fungerar som den ska eller om den har tappats i gol-

vet eller på annat sätt skadats. Kontakta en kvaliﬁcerad tekniker för råd.

• Använd inte utomhus.

• Den här dekorationsbrasan är inte avsedd att användas i badrum, tvätt-

stuga eller liknande utrymmen. Placera aldrig ett värmeelement så att

det riskerar att falla ned i ett badkar eller annan vattenfylld behållare.

• Hög temperatur! Håll elsladdar, gardiner och andra möbleringsdetal-

jer på minst 0,9 meters avstånd från elementet, och på avstånd från

dess sidor och baksida.

Tack för att du valt att

köpa en produkt från Rusta!

Läs igenom hela bruksanvisningen

innan montering och användning!

RUSTA 90651097 Bedienungsanleitung

Beliebte Kamin im Innenbereich Handbücher anderer Marken