Ryobi RY253SS Bedienungsanleitung
First Time Start
First Time Assembly
Remove product from carton.
Assemble per instructions
in your operator’s manual.
1
WARNING: This Quick Start Guide is not a substitute for reading the
operator’s manual. To reduce the risk of injury, user must read and understand
operator’s manual before using this product.
2
4
Align and assemble 2 booms
until fully seated.
Snap shield into place over boom and bracket.
Secure with bolt and wing nut as shown.
3
Spread handle over boom and
snap into place. Secure with
bolt and wing nut.
- OR -
Curved Shaft
Straight Shaft
Mix 2.6 oz. 2-cycle oil with
1 gallon of fresh gasoline in
separate gas container. Shake,
then pour into trimmer tank.
5
6
8
7
Place trimmer on ground
with the trim head end facing
away from you.
Set choke lever to
FULL CHOKE position.
Repeatedly press the primer
bulb 10 times.
SQUEEZE THROTTLE
TRIGGER FULLY and pull
starter grip and rope until
engine attempts to start (no
more than 4x).
NOTE: If engine does not
start, return to step 7 and
repeat.
9
SET TO HALF CHOKE position.
11
12
SQUEEZE THROTTLE
TRIGGER FULLY and pull
starter grip until engine
runs. Allow engine to run
10 seconds, set to RUN
position.
You are now ready to Trim!
If engine did not start,
REPEAT STEPS
To stop trimmer, press
the red switch located
on the top of the
trigger housing.
Go to www.ryobitools.com and register your new tool online.
For any questions about operating or maintaining your product,
call the Ryobi™Help Line!
1-800-860-4050
Your Product has been fully tested prior to shipment to
ensure your complete satisfaction. Troubleshooting tips are
also available in your operator’s manual.
For additional registration instruction, refer to operator’s manual.
10X
TRIM!
10
991000348
1-14-15 (REV:01)
7
–
11
First Time Start
First Time Assembly
Remove product from carton.
Assemble per instructions
in your operator’s manual.
1
WARNING: This Quick Start Guide is not a substitute for reading the
operator’s manual. To reduce the risk of injury, user must read and understand
operator’s manual before using this product.
2
4
Align and assemble 2 booms
until fully seated.
Snap shield into place over boom and bracket.
Secure with bolt and wing nut as shown.
3
Spread handle over boom and
snap into place. Secure with
bolt and wing nut.
- OR -
Curved Shaft
Straight Shaft
Mix 2.6 oz. 2-cycle oil with
1 gallon of fresh gasoline in
separate gas container. Shake,
then pour into trimmer tank.
5
6
8
7
Place trimmer on ground
with the trim head end facing
away from you.
Set choke lever to
FULL CHOKE position.
Repeatedly press the primer
bulb 10 times.
SQUEEZE THROTTLE
TRIGGER FULLY and pull
starter grip and rope until
engine attempts to start (no
more than 4x).
NOTE: If engine does not
start, return to step 7 and
repeat.
9
SET TO HALF CHOKE position.
11
12
SQUEEZE THROTTLE
TRIGGER FULLY and pull
starter grip until engine
runs. Allow engine to run
10 seconds, set to RUN
position.
You are now ready to Trim!
If engine did not start,
REPEAT STEPS
To stop trimmer, press
the red switch located
on the top of the
trigger housing.
Go to www.ryobitools.com and register your new tool online.
For any questions about operating or maintaining your product,
call the Ryobi™Help Line!
1-800-860-4050
Your Product has been fully tested prior to shipment to
ensure your complete satisfaction. Troubleshooting tips are
also available in your operator’s manual.
For additional registration instruction, refer to operator’s manual.
10X
TRIM!
10
991000348
1-14-15 (REV:01)
7
–
11
First Time Start
First Time Assembly
Remove product from carton.
Assemble per instructions
in your operator’s manual.
1
WARNING: This Quick Start Guide is not a substitute for reading the
operator’s manual. To reduce the risk of injury, user must read and understand
operator’s manual before using this product.
2
4
Align and assemble 2 booms
until fully seated.
Snap shield into place over boom and bracket.
Secure with bolt and wing nut as shown.
3
Spread handle over boom and
snap into place. Secure with
bolt and wing nut.
- OR -
Curved Shaft
Straight Shaft
Mix 2.6 oz. 2-cycle oil with
1 gallon of fresh gasoline in
separate gas container. Shake,
then pour into trimmer tank.
5
6
8
7
Place trimmer on ground
with the trim head end facing
away from you.
Set choke lever to
FULL CHOKE position.
Repeatedly press the primer
bulb 10 times.
SQUEEZE THROTTLE
TRIGGER FULLY and pull
starter grip and rope until
engine attempts to start (no
more than 4x).
NOTE: If engine does not
start, return to step 7 and
repeat.
9
SET TO HALF CHOKE position.
11
12
SQUEEZE THROTTLE
TRIGGER FULLY and pull
starter grip until engine
runs. Allow engine to run
10 seconds, set to RUN
position.
You are now ready to Trim!
If engine did not start,
REPEAT STEPS
To stop trimmer, press
the red switch located
on the top of the
trigger housing.
Go to www.ryobitools.com and register your new tool online.
For any questions about operating or maintaining your product,
call the Ryobi™Help Line!
1-800-860-4050
Your Product has been fully tested prior to shipment to
ensure your complete satisfaction. Troubleshooting tips are
also available in your operator’s manual.
For additional registration instruction, refer to operator’s manual.
10X
TRIM!
10
991000348
1-14-15 (REV:01)
7
–
11
Andere Handbücher für RY253SS
1
Inhaltsverzeichnis
Andere Ryobi Trimmer Handbücher
Ryobi
Ryobi 825r Bedienungsanleitung
Ryobi
Ryobi RLT3025S Bedienungsanleitung
Ryobi
Ryobi RLT30CESC Bedienungsanleitung
Ryobi
Ryobi RY40640 Bedienungsanleitung
Ryobi
Ryobi 5133003670 Bedienungsanleitung
Ryobi
Ryobi RY30570 Bedienungsanleitung
Ryobi
Ryobi RHT5655RS Bedienungsanleitung
Ryobi
Ryobi OLT1831 Bedienungsanleitung
Ryobi
Ryobi RHT185020 Bedienungsanleitung
Ryobi
Ryobi 890r Bedienungsanleitung
Ryobi
Ryobi 765r Bedienungsanleitung
Ryobi
Ryobi RLT3123 Bedienungsanleitung
Ryobi
Ryobi RHT6760RL Bedienungsanleitung
Ryobi
Ryobi PBC3046B Bedienungsanleitung
Ryobi
Ryobi RY253SS Bedienungsanleitung
Ryobi
Ryobi PBC-3046YE Bedienungsanleitung
Ryobi
Ryobi RLT30CESA Bedienungsanleitung
Ryobi
Ryobi P600 Bedienungsanleitung
Ryobi
Ryobi RLT5027 Bedienungsanleitung
Ryobi
Ryobi P20010 Bedienungsanleitung
